參數資料
型號: SAK-XC2285M-56F80LAA
廠商: INFINEON TECHNOLOGIES AG
元件分類: 微控制器/微處理器
英文描述: RISC MICROCONTROLLER, PQFP144
封裝: 0.50 mm pitch, GREEN, PLASTIC, LQFP-144
文件頁數: 15/142頁
文件大?。?/td> 1112K
代理商: SAK-XC2285M-56F80LAA
XC2287M, XC2286M, XC2285M
XC2000 Family Derivatives / Base Line
Electrical Parameters
Data Sheet
111
V2.0, 2009-03
Direct Drive
When direct drive operation is selected (SYSCON0.CLKSEL = 11B), the system clock is
derived directly from the input clock signal CLKIN1:
f
SYS = fIN.
The frequency of
f
SYS is the same as the frequency of fIN. In this case the high and low
times of
f
SYS are determined by the duty cycle of the input clock fIN.
Selecting Bypass Operation from the XTAL11) input and using a divider factor of 1 results
in a similar configuration.
Prescaler Operation
When prescaler operation is selected (SYSCON0.CLKSEL = 10B, PLLCON0.VCOBY =
1B), the system clock is derived either from the crystal oscillator (input clock signal
XTAL1) or from the internal clock source through the output prescaler K1 (= K1DIV+1):
f
SYS = fOSC / K1.
If a divider factor of 1 is selected, the frequency of
f
SYS equals the frequency of fOSC. In
this case the high and low times of
f
SYS are determined by the duty cycle of the input
clock
f
OSC (external or internal).
The lowest system clock frequency results from selecting the maximum value for the
divider factor K1:
f
SYS = fOSC / 1024.
Phase Locked Loop (PLL)
When PLL operation is selected (SYSCON0.CLKSEL = 10B, PLLCON0.VCOBY = 0B),
the on-chip phase locked loop is enabled and provides the system clock. The PLL
multiplies the input frequency by the factor F (
f
SYS = fIN × F).
F is calculated from the input divider P (= PDIV+1), the multiplication factor N (=
NDIV+1), and the output divider K2 (= K2DIV+1):
(F = N / (P
× K2)).
The input clock can be derived either from an external source at XTAL1 or from the on-
chip clock source.
The PLL circuit synchronizes the system clock to the input clock. This synchronization is
performed smoothly so that the system clock frequency does not change abruptly.
Adjustment to the input clock continuously changes the frequency of
f
SYS so that it is
locked to
f
IN. The slight variation causes a jitter of fSYS which in turn affects the duration
of individual TCSs.
1) Voltages on XTAL1 must comply to the core supply voltage
VDDI1.
相關PDF資料
PDF描述
SAF-XC2287M-72F80LAA RISC MICROCONTROLLER, PQFP144
SAF-XC2285M-72F80LAA RISC MICROCONTROLLER, PQFP144
SAK-XC2723X-20F66V 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PQCC48
SAH-XC2723X-20F66V 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PQCC48
SAK-XC2765X-72F80LAA 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP100
相關代理商/技術參數
參數描述
SAK-XC2286-56F66L 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16/32-Bit Single-Chip Microcontroller with 32-Bit Performance
SAK-XC2286-72F66L 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16/32-Bit Single-Chip Microcontroller with 32-Bit Performance
SAK-XC2286-96F66L 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16/32-Bit Single-Chip Microcontroller with 32-Bit Performance
SAKXC2286M104F80LAA 制造商:Infineon Technologies AG 功能描述:
SAK-XC2287-56F66L 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16/32-Bit Single-Chip Microcontroller with 32-Bit Performance