- 您現在的位置：買賣IC網 > PDF目錄373435 > SN54ABT8374 (Texas Instruments, Inc.) Scan Test Devices With Octal D-Type Edge-Triggered Flip-Flops(掃描測試裝置(帶八D邊沿觸發器)) PDF資料下載
參數資料
| 型號： | SN54ABT8374 |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | Scan Test Devices With Octal D-Type Edge-Triggered Flip-Flops(掃描測試裝置(帶八D邊沿觸發器)) |
| 中文描述： | 掃描測試設備與八路D型邊沿觸發正反器（掃描測試裝置（帶八?邊沿觸發器）） |
| 文件頁數： | 4/19頁 |
| 文件大?。?/td> | 391K |
| 代理商： | SN54ABT8374 |
SN54ABT8374, SN74ABT8374
SCAN TEST DEVICES WITH
OCTAL D-TYPE EDGE-TRIGGERED FLIP-FLOPS
SCBS486 – JULY 1994
3–4
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
test architecture
Serial-test information is conveyed by means of a 4-wire test bus or TAP that conforms to IEEE Standard
1149.1-1990. Test instructions, test data, and test control signals all are passed along this serial-test bus. The
TAP controller monitors two signals from the test bus, namely TCK and TMS. The TAP controller extracts the
synchronization (TCK) and state control (TMS) signals from the test bus and generates the appropriate on-chip
control signals for the test structures in the device. Figure 1 shows the TAP-controller state diagram.
The TAP controller is fully synchronous to the TCK signal. Input data is captured on the rising edge of TCK and
output data changes on the falling edge of TCK. This scheme ensures data to be captured is valid for fully
one-half of the TCK cycle.
The functional block diagram illustrates the IEEE Standard 1149.1-1990 4-wire test bus and boundary-scan
architecture and the relationship among the test bus, the TAP controller, and the test registers. As illustrated,
the device contains an 8-bit instruction register and three test-data registers: an18-bit boundary-scan register,
an 11-bit boundary-control register, and a 1-bit bypass register.
Test-Logic-Reset
Run-Test/Idle
Select-DR-Scan
Capture-DR
Shift-DR
Exit1-DR
Pause-DR
Update-DR
TMS = L
TMS = L
TMS = H
TMS = L
TMS = H
TMS = H
TMS = L
TMS = H
TMS = L
TMS = L
TMS = H
TMS = L
Exit2-DR
Select-IR-Scan
Capture-IR
Shift-IR
Exit1-IR
Pause-IR
Update-IR
TMS = L
TMS = L
TMS = H
TMS = L
TMS = H
TMS = H
TMS = L
TMS = H
TMS = L
Exit2-IR
TMS = L
TMS = H
TMS = H
TMS = H
TMS = L
TMS = H
TMS = L
TMS = H
TMS = H
TMS = H
TMS = L
Figure 1. TAP-Controller State Diagram
P
相關PDF資料 |
PDF描述 |
|---|---|
| SN74ABT8374 | Scan Test Devices With Octal D-Type Edge-Triggered Flip-Flops(掃描測試裝置(帶八D邊沿觸發器)) |
| SN54ABT845 | Octal Bus Interface D-Type Latches With 3-State Outputs(八總線接口D鎖存器(三態輸出)) |
| SN74ABT845 | Octal Bus Interface D-Type Latches With 3-State Outputs(八總線接口D觸發器(三態輸出)) |
| SN54ABT8543FK | SCAN TEST DEVICES WITH OCTAL REGISTERED BUS TRANSCEIVERS |
| SN54ABT8543JT | SCAN TEST DEVICES WITH OCTAL REGISTERED BUS TRANSCEIVERS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SN54ABT841 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-BIT BUS-INTERFACE D-TYPE LATCHES WITH 3-STATE OUTPUTS |
| SN54ABT841FK | 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-BIT BUS-INTERFACE D-TYPE LATCHES WITH 3-STATE OUTPUTS |
| SN54ABT841JT | 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-BIT BUS-INTERFACE D-TYPE LATCHES WITH 3-STATE OUTPUTS |
| SN54ABT841W | 制造商:TI 制造商全稱:Texas Instruments 功能描述:10-BIT BUS-INTERFACE D-TYPE LATCHES WITH 3-STATE OUTPUTS |
| SN54ABT843 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:9-BIT BUS-INTERFACE D-TYPE LATCHES WITH 3-STATE OUTPUTS |
發布緊急采購，3分鐘左右您將得到回復。