參數資料
型號： Tiny12
廠商： Atmel Corp.
英文描述： 8-bit AVR Microcontroller with 1K Byte Flash
中文描述： 8位AVR微控制器，帶有1K字節閃存
文件頁數： 25/91頁
文件大?。?/td> 1137K
代理商： TINY12
25
ATtiny11/12
1006D–AVR–07/03
1.
2.
When BOD is enabled (by programming the BODEN fuse)
When the bandgap reference is connected to the Analog Comparator (by setting
the AINBG bit in ACSR)
Thus, when BOD is not enabled, after setting the AINBG bit, the user must always allow
the reference to start up before the output from the Analog Comparator is used. The
bandgap reference uses approximately 10 μA, and to reduce power consumption in
Power-down mode, the user can turn off the reference when entering this mode.
Interrupt Handling
The ATtiny11/12 has two 8-bit Interrupt Mask control registers; GIMSK – General Inter-
rupt Mask register and TIMSK – Timer/Counter Interrupt Mask register.
When an interrupt occurs, the Global Interrupt Enable I-bit is cleared (zero) and all inter-
rupts are disabled. The user software can set (one) the I-bit to enable nested interrupts.
The I-bit is set (one) when a Return from Interrupt instruction – RETI – is executed.
When the Program Counter is vectored to the actual interrupt vector in order to execute
the interrupt handling routine, hardware clears the corresponding flag that generated the
interrupt. Some of the interrupt flags can also be cleared by writing a logic one to the flag
bit position(s) to be cleared.
If an interrupt condition occurs when the corresponding interrupt enable bit is cleared
(zero), the interrupt flag will be set and remembered until the interrupt is enabled, or the
flag is cleared by software.
If one or more interrupt conditions occur when the global interrupt enable bit is cleared
(zero), the corresponding interrupt flag(s) will be set and remembered until the global
interrupt enable bit is set (one), and will be executed by order of priority.
Note that external level interrupt does not have a flag, and will only be remembered for
as long as the interrupt condition is active.
Note that the status register is not automatically stored when entering an interrupt rou-
tine and restored when returning from an interrupt routine. This must be handled by
software.
Interrupt Response Time
The interrupt execution response for all the enabled AVR interrupts is 4 clock cycles
minimum. After the 4 clock cycles, the program vector address for the actual interrupt
handling routine is executed. During this 4-clock-cycle period, the Program Counter (9
bits) is pushed onto the Stack. The vector is normally a relative jump to the interrupt rou-
tine, and this jump takes 2 clock cycles. If an interrupt occurs during execution of a
multi-cycle instruction, this instruction is completed before the interrupt is served. In
ATtiny12, if an interrupt occurs when the MCU is in Sleep mode, the interrupt response
time is increased by 4 clock cycles.
A return from an interrupt handling routine takes 4 clock cycles. During these 4 clock
cycles, the Program Counter (9 bits) is popped back from the Stack, and the I-flag in
SREG is set. When AVR exits from an interrupt, it will always return to the main program
and execute one more instruction before any pending interrupt is served.
General Interrupt Mask
Register – GIMSK
Bit
7
6
5
4
3
2
1
0
$3B
-
INT0
PCIE
-
-
-
-
-
GIMSK
Read/Write
R
R/W
R/W
R
R
R
R
R
Initial Value
0
0
0
0
0
0
0
0
相關PDF資料
PDF描述
TIP140 Complemetary Silicon Power Darlington Transistors(互補硅功率達林頓晶體管)
TIP142F TO-3P Fully Isolated Plastic Package Transistor CDIL
TIP145F TO-3P Fully Isolated Plastic Package Transistor CDIL
TIP140F TO-3P Fully Isolated Plastic Package Transistor CDIL
TIP141F TO-3P Fully Isolated Plastic Package Transistor CDIL
相關代理商/技術參數
參數描述
TINY88-15MZ 功能描述:8位微控制器 -MCU 8KB FLASH 12MHz AUTO RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
TINY-BWA 制造商:HCC Embedded 功能描述:TINY FILE SYSTEM FOR BYTE WRITABLE ARRAYS - Virtual or Non-Physical Inventory (Software & Literature)
TINY-RAM 制造商:HCC Embedded 功能描述:TINY FILE SYSTEM FOR RAM - Virtual or Non-Physical Inventory (Software & Literature)
TIOL1113DMWT 功能描述:IO LINK 制造商:texas instruments 系列:- 包裝:剪切帶（CT） 零件狀態:在售 類型:收發器 協議:I/O 鏈路 驅動器/接收器數:1/1 雙工:- 接收器滯后:750mV 數據速率:250kbps 電壓 - 電源:7 V ~ 36 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-VFDFN 裸露焊盤 供應商器件封裝:10-VSON（3x2.5） 標準包裝:1
TIOL1115DMWT 功能描述:IO-LINK DEVICE TRANSCEIVERS WITH 制造商:texas instruments 系列:- 包裝:剪切帶（CT） 零件狀態:在售 類型:收發器 協議:I/O 鏈路 驅動器/接收器數:1/1 雙工:- 接收器滯后:750mV 數據速率:250kbps 電壓 - 電源:7 V ~ 36 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-VFDFN 裸露焊盤 供應商器件封裝:10-VSON（3x2.5） 標準包裝:1
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*