- 您現在的位置：買賣IC網 > PDF目錄373641 > Tiny12 (Atmel Corp.) 8-bit AVR Microcontroller with 1K Byte Flash PDF資料下載
參數資料
| 型號： | Tiny12 |
| 廠商： | Atmel Corp. |
| 英文描述： | 8-bit AVR Microcontroller with 1K Byte Flash |
| 中文描述： | 8位AVR微控制器，帶有1K字節閃存 |
| 文件頁數： | 32/91頁 |
| 文件大小： | 1137K |
| 代理商： | TINY12 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁當前第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁
32
ATtiny11/12
1006D–AVR–07/03
Note that if a level triggered or pin change interrupt is used for wake-up from Power-
down Mode, the changed level must be held for a time to wake up the MCU. This makes
the MCU less sensitive to noise. The wake-up period is equal to the clock-counting part
of the reset period (See Table 9). The MCU will wake up from the power-down if the
input has the required level for two watchdog oscillator cycles. If the wake-up period is
shorter than two watchdog oscillator cycles, the MCU will wake up if the input has the
required level for the duration of the wake-up period. If the wake-up condition disap-
pears before the wake-up period has expired, the MCU will wake up from power-down
without executing the corresponding interrupt. The period of the watchdog oscillator is
2.7 μs (nominal) at 3.0V and 25
°
C. The frequency of the watchdog oscillator is voltage
dependent as shown in the section “ATtiny11 Typical Characteristics” on page 60.
When waking up from Power-down Mode, there is a delay from the wake-up condition
occurs until the wake-up becomes effective. This allows the clock to restart and become
stable after having been stopped. The wake-up period is defined by the same CKSEL
fuses that define the reset time-out period.
ATtiny12 Calibrated
Internal RC Oscillator
In ATtiny12, the calibrated internal oscillator provides a fixed 1.2 MHz (nominal) clock at
5V and 25
°
C. This clock may be used as the system clock. See the section “Clock
Options” on page 5 for information on how to select this clock as the system clock. This
oscillator can be calibrated by writing the calibration byte to the OSCCAL register. When
this oscillator is used as the chip clock, the Watchdog Oscillator will still be used for the
Watchdog Timer and for the reset time-out. For details on how to use the pre-pro-
grammed calibration value, see the section “Calibration Byte in ATtiny12” on page 47. At
5V and 25
o
C, the pre-programmed calibration byte gives a frequency within ± 1% of the
nominal frequency.
Oscillator Calibration Register
– OSCCAL
Bits 7..0 - CAL7..0: Oscillator Calibration Value
Writing the calibration byte to this address will trim the internal oscillator to remove pro-
cess variations from the oscillator frequency. When OSCCAL is zero, the lowest
available frequency is chosen. Writing non-zero values to this register will increase the
frequency of the internal oscillator. Writing $FF to the register gives the highest available
frequency. The calibrated oscillator is used to time EEPROM access. If EEPROM is
written, do not calibrate to more than 10% above the nominal frequency. Otherwise, the
EEPROM write may fail. Table 14 shows the range for OSCCAL. Note that the oscillator
is intended for calibration to 1.2 MHz, thus tuning to other values is not guaranteed.
Bit
7
6
5
4
3
2
1
0
$31
CAL7
CAL6
CAL5
CAL4
CAL3
CAL2
CAL1
CAL0
OSCCAL
Read/Write
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Initial Value
0
0
0
0
0
0
0
0
Table 14.
Internal RC Oscillator Frequency Range
OSCCAL Value
Min Frequency
Max Frequency
$00
0.6 MHz
1.2 MHz
$7F
0.8 MHz
1.7 MHz
$FF
1.2 MHz
2.5 MHz
相關PDF資料 |
PDF描述 |
|---|---|
| TIP140 | Complemetary Silicon Power Darlington Transistors(互補硅功率達林頓晶體管) |
| TIP142F | TO-3P Fully Isolated Plastic Package Transistor CDIL |
| TIP145F | TO-3P Fully Isolated Plastic Package Transistor CDIL |
| TIP140F | TO-3P Fully Isolated Plastic Package Transistor CDIL |
| TIP141F | TO-3P Fully Isolated Plastic Package Transistor CDIL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TINY88-15MZ | 功能描述:8位微控制器 -MCU 8KB FLASH 12MHz AUTO RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT |
| TINY-BWA | 制造商:HCC Embedded 功能描述:TINY FILE SYSTEM FOR BYTE WRITABLE ARRAYS - Virtual or Non-Physical Inventory (Software & Literature) |
| TINY-RAM | 制造商:HCC Embedded 功能描述:TINY FILE SYSTEM FOR RAM - Virtual or Non-Physical Inventory (Software & Literature) |
| TIOL1113DMWT | 功能描述:IO LINK 制造商:texas instruments 系列:- 包裝:剪切帶（CT） 零件狀態:在售 類型:收發器 協議:I/O 鏈路 驅動器/接收器數:1/1 雙工:- 接收器滯后:750mV 數據速率:250kbps 電壓 - 電源:7 V ~ 36 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-VFDFN 裸露焊盤 供應商器件封裝:10-VSON（3x2.5） 標準包裝:1 |
| TIOL1115DMWT | 功能描述:IO-LINK DEVICE TRANSCEIVERS WITH 制造商:texas instruments 系列:- 包裝:剪切帶（CT） 零件狀態:在售 類型:收發器 協議:I/O 鏈路 驅動器/接收器數:1/1 雙工:- 接收器滯后:750mV 數據速率:250kbps 電壓 - 電源:7 V ~ 36 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-VFDFN 裸露焊盤 供應商器件封裝:10-VSON（3x2.5） 標準包裝:1 |
發布緊急采購，3分鐘左右您將得到回復。