- 您現在的位置：買賣IC網 > PDF目錄2118 > TPA6140A2YFFR (Texas Instruments)IC AMP AUDIO 25MW STER 16DSBGA PDF資料下載
參數資料
| 型號： | TPA6140A2YFFR |
| 廠商： | Texas Instruments |
| 文件頁數： | 17/30頁 |
| 文件大小： | 0K |
| 描述： | IC AMP AUDIO 25MW STER 16DSBGA |
| 視頻文件： | TPA6140A2 Demonstration |
| 標準包裝： | 1 |
| 系列： | DirectPath™ |
| 類型： | G 類 |
| 輸出類型： | 耳機，2-通道（立體聲） |
| 在某負載時最大輸出功率 x 通道數量： | 32mW x 2 @ 32 歐姆 |
| 電源電壓： | 2.5 V ~ 5.5 V |
| 特點： | 消除爆音，差分輸入，I²C，靜音，短路和熱保護，關機，音量控制 |
| 安裝類型： | 表面貼裝 |
| 供應商設備封裝： | 16-DSBGA（1.56x1.56） |
| 封裝/外殼： | 16-UFBGA，DSBGA |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 878 (CN2011-ZH PDF) |
| 配用： | 296-24299-ND - EVALUATION MODULE FOR TPA6140A2 |
| 其它名稱： | 296-24237-6 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
SLOS598A – MARCH 2009 – REVISED OCTOBER 2009................................................................................................................................................. www.ti.com
OPERATING MODES
HARDWARE SHUTDOWN
Hardware shutdown is not available in the TPA6140A2. The SWS register (Software Shutdown) must be used to
shutdown the amplifier.
SOFTWARE SHUTDOWN
Set software shutdown by writing a logic 1 in register 1, bit 0 (SWS bit). Software shutdown places the device in
the lowest power state (see the Electrical Characteristics Table for values). Engaging software shutdown turns
off the buck regulator and charge pump and disables the amplifier outputs. Write a logic 0 to the SWS bit to
reactivate the device.
Note that when the device is in SWS mode all registers will maintain their values. The HP_EN_L and HP_EN_R
bits can be reset because a full word must be used when writing just one bit to the register.
To ensure lowest current consumption and highest input to output signal attenuation, SWS must be used instead
of HP_EN_L and HP_EN_R (set HP_EN_L and HP_EN_R to logic 1) when disabling both channels of the
amplifier simultaneously. Set HP_EN_L and HP_EN_R to logic 1 before changing SWS from logic 0 to logic 1.
MUTE MODE
Set the Mute_L bit to 1 to mute the left channel output. Set the Mute_R bit to 1 to mute the right channel output.
They are respectively located at Register 2, Bits 7 and 6. Mute attenuation is -80 dB, typical. Mute attenuation
can only be guaranteed when the amplifier is operational (SWS = 0) and enabled (HP_EN_L or HP_EN_R = 1)
HI-Z MODE
HI-Z mode mutes the device and puts the amplifier outputs into a high impedance state. Use this configuration
when the outputs of the TPA6140A2 share traces with other devices whose outputs may be active. Write a logic
1 in register 3, bits 0 and 1 to enable Hi-Z mode for the left and right outputs. Place a logic 0 in register 3, bits 0
and 1 to disable the Hi-Z state. The left and right outputs can be placed into a Hi-Z state individually.
Note that to use the Hi-Z mode, the SWS bit must be equal to logic 0 (amplifier operational) and the output
headphone amplifiers must NOT be enabled (HP_EN_L and HP_EN_R = 0).
DEFAULT MODE AT START-UP
On power-up, the TPA6140A2 initializes in the following conditions:
SWS = 1 (Shutdown mode)
HP_EN_L = HP_EN_R = 0 (Outputs disabled)
Hi-Z_L = Hi-Z_R = 0 (Hi-Z off)
Mute_L = Mute_R = 1 (Amplifiers muted)
VOLUME = –59 dB
PACKAGE INFORMATION
Package Dimensions
The package dimensions for this YFF package are shown in the table below. See the package drawing at the
end of this data sheet for more details.
Table 2. YFF Package Dimensions
Packaged Devices
D
E
Min = 1530
μm
Min = 1530
μm
TPA6140A2YFF
Max = 1590
μm
Max = 1590
μm
24
Copyright 2009, Texas Instruments Incorporated
Product Folder Link(s): TPA6140A2
相關PDF資料 |
PDF描述 |
|---|---|
| TRF3750IRGPG4 | IC PLL FREQ SYNTHESIZER 20-QFN |
| TRS202IDWR | IC DVR/RCVR RS232 ESD DL 16SOIC |
| TS117PTR | RELAY OPTO TELCOM 120MA 8 FLTPK |
| TS117P | RELAY OPTO MULTIFUNC 120MA 8FLPK |
| TS118P | RELAY OPTOMULTIFUNC 120MA 8FLTPK |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPA6140A2YFFT | 功能描述:音頻放大器 25mW Class-G Direct Path St Headph Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| TPA6140A2YFFT | 制造商:Texas Instruments 功能描述:Audio Power Amplifier IC |
| TPA6141A2 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:CLASS-G DIRECTPATH? STEREO HEADPHONE AMPLIFIER |
| TPA6141A2YFFEVM | 功能描述:音頻 IC 開發工具 TPA6141A2YFF Eval Mod RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| TPA6141A2YFFR | 功能描述:音頻放大器 25mW Class-G Direct Path St Headph Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。