參數資料
型號: TPS40055MPWPREPG4
廠商: TEXAS INSTRUMENTS INC
元件分類: 穩壓器
英文描述: SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
封裝: PLASTIC, HTSSOP-16
文件頁數: 4/35頁
文件大?。?/td> 2348K
代理商: TPS40055MPWPREPG4
SGLS310B – JULY 2005 – REVISED OCTOBER 2010
www.ti.com
Stepping the load from a heavy load to a light load results in an output overshoot. Excess energy stored in the
inductor must be absorbed by the output capacitance. The energy stored in the inductor is described in
(6)
where:
(7)
IOH is the output current under heavy load conditions
IOL is the output current under light load conditions
Some applications may require an additional circuit to prevent false restarts at the UVLO voltage level. This
applies to applications which have high impedance on the input voltage line or which have excessive ringing on
the VIN line. The input voltage impedance can cause the input voltage to sag enough at start-up to cause a
UVLO shutdown and subsequent restart. Excessive ringing can also affect the voltage seen by the device and
cause a UVLO shutdown and restart. A simple external circuit provides a selectable amount of hysteresis to
prevent the nuisance UVLO shutdown.
Assuming a hysteresis current of 10% IKFF and the peak detector charges to 8 V and VIN(min) = 10 V, the value of
RA is calculated by Equation 8 using a RKFF = 71.5 k.
(8)
CA is chosen to maintain the peak voltage between switching cycles. To keep the capacitor charge from drooping
0.1 V, or from 8 V to 7.9 V.
(9)
The value of CA may calculate to less than 10 pF, but some standard value up to 47 pF works adequately. The
diode can be a small signal switching diode or Schottky rated for more then 20 V. Figure 9 illustrates a typical
implementation using a small switching diode.
The tolerance on the UVLO set point also affects the maximum duty cycle achievable. If the UVLO starts the
device at 10% below the nominal start up voltage, the maximum duty cycle is reduced approximately 10% at the
nominal start up voltage.
12
Copyright 2005–2010, Texas Instruments Incorporated
Product Folder Link(s): TPS40055-EP
相關PDF資料
PDF描述
TPS40055QPWPRQ1 SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS40054QPWPRQ1 SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS40070PWPRG4 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS40071PWPR 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
TPS40070PWPR 2 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO16
相關代理商/技術參數
參數描述
TPS40055PWP 功能描述:DC/DC 開關控制器 Wide Input Sync Buck Cntrlr source/sink RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS40055PWPG4 功能描述:DC/DC 開關控制器 Wide Input Sync Buck Cntrlr source/sink RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS40055PWPR 功能描述:DC/DC 開關控制器 Wide Input Sync Buck Cntrlr source/sink RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS40055PWPRG4 功能描述:DC/DC 開關控制器 Wide Input Sync Buck Cntrlr source/sink RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
TPS40056 制造商:TI 制造商全稱:Texas Instruments 功能描述:WIDE-INPUT SYNCHRONOUS, TRACKING BUCK CONTROLLER