參數資料
型號： TPS51315RGFT
廠商： TEXAS INSTRUMENTS INC
元件分類： 穩壓器
英文描述： SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PQCC40
封裝： GREEN, PLASTIC, QFN-40
文件頁數： 10/32頁
文件大?。?/td> 1028K
代理商： TPS51315RGFT
R1
R2
VoltageDivider
+
V
FB
+
0.75V
PWM
Control
Logic
and
Divider
V
IN
Lx
ESR
C
O
V
C
R
L
I
L
I
O
UDG-09062
I
C
SwitchingModulator
Output
Capacitor
fSW
0
OUT
1
f
2
ESR
C
4
=
p
OUT
RIPPLE
V
15 mV
0.75
=
÷
è
SLUS881A
– MAY 2009 – REVISED MAY 2011
APPLICATION INFORMATION
Loop Compensation and External Parts Selection
Figure 25. Simplified Modulator Block Diagram
The feedback voltage (VVFB) is compared to the internal reference voltage after the divider resistors. The PWM
comparator determines when to turn on the upper MOSFET. The gain and speed of the comparator is high
enough to maintain the voltage level relatively constant at the beginning of each on cycle, or at the end of each
off cycle . The dc output voltage may have line regulation due to ripple amplitude that slightly increases as the
input voltage increases.
For loop stability, the 0 dB frequency, f0, defined in Equation 6 must be lower than 1/4 of the switching frequency.
(6)
Because f0 is determined solely by the output capacitor characteristics, the loop stability of the D-CAP Mode is
determined by capacitor chemistry. For example, specialty polymer capacitors (SP-CAP) have and output
capacitance on the order of several hundred micro-farads and and ESR of approximately 10 m
. These values
make f0 on the order of 100 kHz or less and create a stable loop. However, ceramic capacitors have an f0 of
more than 700 kHz, which is not suitable for this operating mode, although the D-CAP
Mode provides many
advantages such as ease-of-use, minimum external component configuration, and extremely short response
time. These advantages are realized because there is no error amplifier in the loop, so a sufficient feedback
signal is required from an external circuit to reduce the jitter level. The required signal level is approximately 15
mV at the comparing point. This generates output ripple at the output node that can be calculated in Equation 7.
The output capacitor ESR should meet this requirement.
(7)
For applications with all ceramic output capacitors, a few external components need to be added to ensure the
loop stability. Please refer to Figure 29. Since ceramics capacitors have low ESR, feedback ripple in phase with
inductor current is recommended. R-C network across the output inductor can mimic inductor current when RC
≈
L / DCR, the ripple current can be coupled to the feedback through a 1-
μF capacitor.
18
Copyright
2009–2011, Texas Instruments Incorporated
相關PDF資料
PDF描述
TPS51317RGBT SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PQCC20
TPS51317RGBR SWITCHING REGULATOR, 1500 kHz SWITCHING FREQ-MAX, PQCC20
TPS51427ARHBR DUAL SWITCHING CONTROLLER, PQCC32
TPS51427ARHBT DUAL SWITCHING CONTROLLER, PQCC32
TPS51461RGET SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PQCC24
相關代理商/技術參數
參數描述
TPS51317 制造商:TI 制造商全稱:Texas Instruments 功能描述:3.3-V/5-V Input, 6-A, D-CAP+? Mode Synchronous Step-Down Integrated FETs Converter
TPS51317RGBR 功能描述:直流/直流開關轉換器 3.3V/5Vin,6A,DCAP Mode Sync Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT
TPS51317RGBT 功能描述:直流/直流開關轉換器 3.3V/5Vin,6A,DCAP Mode Sync Converter RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT
TPS51362RVER 制造商:Texas Instruments 功能描述:22V INPUT, 10A INTEGRATED FET 制造商:Texas Instruments 功能描述:IC REG BUCK SYNC ADJ 10A 28VQFN
TPS51362RVET 制造商:Texas Instruments 功能描述:22V INPUT, 10A INTEGRATED FET 制造商:Texas Instruments 功能描述:IC REG BUCK SYNC ADJ 10A 28VQFN
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*