- 您現在的位置：買賣IC網 > PDF目錄376454 > XR16L2552 (Exar Corporation) 2.25V TO 5.5V DUART WITH 16-BYTE FIFO PDF資料下載
參數資料
| 型號： | XR16L2552 |
| 廠商： | Exar Corporation |
| 英文描述： | 2.25V TO 5.5V DUART WITH 16-BYTE FIFO |
| 中文描述： | 2.25V至5.5V的杜阿爾特16字節FIFO |
| 文件頁數： | 19/47頁 |
| 文件大?。?/td> | 748K |
| 代理商： | XR16L2552 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁
xr
REV. 1.1.1
XR16L2552
2.25V TO 5.5V DUART WITH 16-BYTE FIFO
19
2.19
The L2552 supports low voltage system designs, hence, a sleep mode is included to reduce its power
consumption when the chip is not actively used.
All of these conditions must be satisfied for the L2552 to enter sleep mode:
Sleep Mode with Auto Wake-Up
■
no interrupts pending for both channels of the L2552 (ISR bit-0 = 1)
■
divisor is a non-zero value (ie. DLL = 0x1)
■
sleep mode of both channels are enabled (IER bit-4 = 1)
■
modem inputs are not toggling (MSR bits 0-3 = 0)
■
RX input pins are idling at a logic 1
The L2552 stops its crystal oscillator to conserve power in the sleep mode. User can check the XTAL2 pin for
no clock output as an indication that the device has entered the sleep mode.
The L2552 resumes normal operation by any of the following:
■
a receive data start bit transition (logic 1 to 0)
■
a data byte is loaded to the transmitter, THR or FIFO
■
a change of logic state on any of the modem or general purpose serial inputs: CTS#, DSR#, CD#, RI#
If the L2552 is awakened by any one of the above conditions, it will return to the sleep mode automatically after
all interrupting conditions have been serviced and cleared. If the L2552 is awakened by the modem inputs, a
read to the MSR is required to reset the modem inputs. In any case, the sleep mode will not be entered while
an interrupt is pending from channel A or B. The L2552 will stay in the sleep mode of operation until it is
disabled by setting IER bit-4 to a logic 0.
If the address lines, data bus lines, IOW#, IOR#, CSA#, CSB#, and modem input lines remain steady when the
L2552 is in sleep mode, the maximum current will be in the microamp range as specified in the DC Electrical
Characteristics on
page 36
. If the input lines are floating or are toggling while the L2552 is in sleep mode, the
current can be up to 100 times more. If any of those signals are toggling or floating, then an external buffer
would be required to keep the address, data and control lines steady to achieve the low current. As an
alternative, please refer to the XR16L2551 with the PowerSave feature that eliminates any unnecessary
external buffer.
A word of caution: owing to the starting up delay of the crystal oscillator after waking up from sleep mode, the
first few receive characters may be lost. The number of characters lost during the restart also depends on your
operating data rate. More characters are lost when operating at higher data rate. Also, it is important to keep
RX A/B inputs idling at logic 1 or “marking” condition during sleep mode to avoid receiving a “break” condition
upon the restart. This may occur when the external interface transceivers (RS-232, RS-485 or another type)
are also put to sleep mode and cannot maintain the “marking” condition. To avoid this, the designer can use a
47k-100k ohm pull-up resistor on the RXA and RXB pins.
相關PDF資料 |
PDF描述 |
|---|---|
| XR16L2750CJ | 2.25V TO 5.5V DUART WITH 64-BYTE FIFO |
| XR16L2750CM | 2.25V TO 5.5V DUART WITH 64-BYTE FIFO |
| XR16L2750IJ | 2.25V TO 5.5V DUART WITH 64-BYTE FIFO |
| XR16L2750IM | 2.25V TO 5.5V DUART WITH 64-BYTE FIFO |
| XR16L2750 | 2.25V TO 5.5V DUART WITH 64-BYTE FIFO |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XR16L2552IJ | 制造商:Rochester Electronics LLC 功能描述: 制造商:Exar Corporation 功能描述: |
| XR16L2552IJ-0A-EB | 功能描述:UART 接口集成電路 Supports L2552 44 ld PLCC, ISA Interface RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| XR16L2552IJ-F | 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| XR16L2552IJTR | 制造商:Rochester Electronics LLC 功能描述: 制造商:Exar Corporation 功能描述: |
| XR16L2552IJTR-F | 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。