參數資料
型號： XR16V598IQ-0A-EVB
廠商： Exar Corporation
文件頁數： 20/58頁
文件大小： 0K
描述： EVAL BOARD FOR XR16V598-A 100QFP
標準包裝： 1
系列： *
XR16V598
27
REV. 1.0.3
2.25V TO 3.6V HIGH PERFORMANCE OCTAL UART WITH 16-BYTE FIFO
TIMER OPERATION
The following paragraphs describe the operation of the 16-bit Timer/Counter. The following conventions will be
used in this discussion:
■ ’N’ is the 16-bit value programmed in the TIMER MSB, LSB registers
■ ‘N’ can take any value from 0x0002 to 0xFFFF.
Timer Interrupt
In the one-shot mode, the Timer will issue an interrupt ’N’ clocks after the Timer is started. This is the time
when the Timer times-out in the one-shot mode. In the re-triggerable mode, the Timer will keep issuing an
interrupt every ’N’ clocks. This is shown in Figure 15, where the time between successive time-outs (in re-
triggereble mode) is ’N’ clocks. The Timer interrupt can be cleared by reading the TIMERCNTL register. The
TIMERCNTL will read a value of 0x01 when there is an interrupt and a 0x00 at all other times.
TABLE 10: TIMER CONTROL COMMANDS
TIMERCNTL [7:4]
Reserved
TIMERCNTL [3:0]
These bits are used to invoke a series of commands that control the function of the Timer/Counter.
The commands 1011 to 1111 are reserved.
0001: Enable Timer Interrupt
0010: Disable Timer Interrupt (default)
0011: Select One-shot mode
0100: Select Re-triggerable mode (default)
0101: Select Internal Crystal Oscillator output as clock source for the Timer (default)
0110: Select External Clock source (through TMRCK pin) for the Timer
0111: Reserved
1000: Reserved
1001: Start Timer
1010: Stop Timer (default)
1011: Reset Timer
Upon power-up or reset, the default states are Timer interrupt disabled, Re-triggerable mode, Crystal
Oscillator as Timer clock source, and Timer stopped.
FIGURE 14. TIMER/COUNTER CIRCUIT
Timer Interrupt
TMRCK
OSC. CLOCK
TIMERCNTL
COMMANDS
16-Bit
Timer/Counter
Start/Stop
Timer Interrupt Enable/ Disable
Single shot/Re-triggerable
TIMERMSB and TIMERLSB
(16-bit Value)
0
1
Clock Select
0
1
Timer Interrupt
No Interrupt
相關PDF資料
PDF描述
APX809-46SRG-7 IC MPU RESET CIRC 4.63V SOT23R-3
176819-000 SOLDERSLEEVE LO-FIRE 11.5MM DIA
XR16M698IQ-0B-EVB EVAL BOARD FOR M698-B 100QFP
XR16M698IQ-0A-EVB EVAL BOARD FOR M698-A 100QFP
A3BBB-3018G IDC CABLE- ASR30B/AE30G/ASR30B
相關代理商/技術參數
參數描述
XR16V598IQ-0B-EVB 功能描述:界面開發工具 Supports V598 100 LD QFP, PCI Interface RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
XR16V598IQ100 制造商:EXAR 制造商全稱:EXAR 功能描述:2.25V TO 3.6V HIGH PERFORMANCE OCTAL UART WITH 16-BYTE FIFO
XR16V598IQ100-F 功能描述:UART 接口集成電路 UART RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR16V654 制造商:EXAR 制造商全稱:EXAR 功能描述:2.25V TO 3.6V QUAD UART WITH 64-BYTE FIFO
XR16V654_0709 制造商:EXAR 制造商全稱:EXAR 功能描述:2.25V TO 3.6V QUAD UART WITH 64-BYTE FIFO
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*