參數資料
XRT73LC03A
3 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT
REV. 1.0.1
5
35
8
9
TxLEV_0
TxLEV_1
TxLEV_2
I
Transmit Line Build-Out Enable/Disable Select - Channel (n):
This input pin permits the Transmit Line Build-Out circuit within Channel
(n) to be enabled or disabled. In E3 mode, this pin has no effect on the
transmit pulse shape.
Setting this pin to "High" disables the Line Build-Out circuit. In this
mode, Channel (n) outputs partially-shaped pulses onto the line via the
TTIP_(n) and TRing_(n) output pins.
Setting this pin to "Low" enables the Line Build-Out circuit within Chan-
nel (n). In this mode, Channel (n) outputs shaped pulses onto the line
via the TTIP_(n) and TRing_(n) output pins.
To comply with the Isolated DSX-3/STSX-1 Pulse Template Require-
ments per Bellcore GR-499-CORE or Bellcore GR-253-CORE:
a.
Set this input pin to "1" if the cable length between the Cross-
Connect and the transmit output of Channel (n) is greater than
225 feet.
b.
Set this input pin to "0" if the cable length between the Cross-
Connect and the transmit output of Channel (n) is less than 225
feet.
This pin is active only if the following two conditions are true:
a.
The XRT73LC03A is configured to operate in either the DS3 or
SONET STS-1 Modes.
b.
The XRT73LC03A is configured to operate in the Hardware
Mode.
N
OTE
:
This pin to should be tied to GND if the XRT73LC03A is going to
be operating in the HOST Mode, (internally pulled-down).
117
116
115
TxOFF_0
TxOFF_1
TxOFF_2
I
Transmitter OFF Input - Channel (n):
Setting this input pin "High" turns off all of the Transmitter Sections. In
this mode the TTIP and TRing outputs are tri-stated.
N
OTES
:
1. This input pin controls the TTIP and TRing outputs even when
the XRT73LC03A is operating in the HOST Mode.
2. For HOST Mode Operation, this pin is tied to GND if the Trans-
mitter is intended to be turned off via the Microprocessor Serial
Interface.
TRANSMIT INTERFACE
P
IN
#
N
AME
T
YPE
D
ESCRIPTION
相關PDF資料
PDF描述
XRT73LC04A 4 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT
XRT73LC04AIV 4 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT
XRT73R06 SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT
XRT73R06IB SIX CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT
XRT73R12 TWELVE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT
相關代理商/技術參數
參數描述
XRT73LC03AIVF 制造商:Exar Corporation 功能描述:Line Interface Unit 51.84Mbps DS3/E3/STS-1 Serial 120-Pin LQFP
XRT73LC03AIV-F 功能描述:外圍驅動器與原件 - PCI 3-Ch DS3, E3, STS-1 RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray
XRT73LC04A 制造商:EXAR 制造商全稱:EXAR 功能描述:4 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT
XRT73LC04A_08 制造商:EXAR 制造商全稱:EXAR 功能描述:4 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT
XRT73LC04AES 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流(最大值):595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray