- 您現在的位置：買賣IC網 > PDF目錄9994 > XRT73LC03AIV (Exar Corporation)IC LIU E3/DS3/STS-1 3CH 120LQFP PDF資料下載
參數資料
| 型號： | XRT73LC03AIV |
| 廠商： | Exar Corporation |
| 文件頁數： | 3/61頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC LIU E3/DS3/STS-1 3CH 120LQFP |
| 標準包裝： | 72 |
| 類型： | 線路接口裝置（LIU） |
| 驅動器/接收器數： | 3/3 |
| 規程： | DS3，E3，STS-1 |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 120-LQFP |
| 供應商設備封裝： | 120-LQFP（14x20） |
| 包裝： | 托盤 |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁
XRT73LC03A
9
REV. 1.0.4
3 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT
CONTROL AND ALARM INTERFACE
PIN #NAME
TYPE
DESCRIPTION
31
4
15
MRing_0
MRing_1
MRing_2
I
Monitor Ring Input - Channel (n):
The bipolar line output signal from TRing_(n) can be connected to this
pin via a 270-ohm resistor in order to check for line driver failure. This
pin is internally pulled "High".
30
5
16
MTIP_0
MTIP_1
MTIP_2
I
Monitor Tip Input - Channel (n):
The bipolar line output signal from TTIP_(n) can be connected to this pin
via a 270-ohm resistor in order to check for line driver failure. This pin is
internally pulled "High".
38
120
21
DMO_0
DMO_1
DMO_2
O
Drive Monitor Output - Channel (n):
If no transmitted AMI signal is present on MTIP_(n) and MRing_(n) input
pins for 128±32 TxClk periods, then DMO_(n) toggles and remains
"High" until the next AMI signal is detected.
36
6
7
TAOS_0
TAOS_1
TAOS_2
I
Transmit All Ones Select - Channel (n):
A "High" on this pin causes the Transmit Section, within Channel (n), to
generate and transmit a continuous AMI all “1’s" pattern onto the line.
The frequency of this "1’s" pattern is determined by TxClk_(n).
This input pin is ignored if the XRT73LC03A is operating in the HOST
Mode.
NOTE: This pin should be tied to GND if the XRT73LC03A is going to be
operating in the HOST Mode, (internally pulled-down).
55
107
58
RLOS_0
RLOS_1
RLOS_2
O
Receive Loss of Signal Output Indicator - Channel (n):
This output pin toggles "High" if Channel (n) has detected a Loss of Sig-
nal Condition in the incoming line signal.
The criteria that the XRT73LC03A uses to declare an LOS Condition
depends upon whether the device is operating in the E3 or STS-1/DS3
Mode.
57
105
60
RLOL_0
RLOL_1
RLOL_2
O
Receive Loss of Lock Output Indicator - Channel (n):
This output pin toggles "High" if Channel (n) has detected a Loss of Lock
Condition. Channel (n) declares an LOL (Loss of Lock) Condition if the
recovered clock frequency deviates from the Reference Clock frequency
(available at the EXClk(n) input pin) by more than 0.5%.
56
106
59
LCV_0
LCV_1
LCV_2
O
Line Code Violation Indicator - Channel 0:
Whenever the Receive Section of Channel (n) detects a Line Code Vio-
lation, it pulses this output pin "High". This output pin remains "Low" at
all other times.
NOTE: The XRT73LC03A outputs an NRZ pulse via this output pin. It is
advisable to sample this output pin via the RxClk_(n) clock output signal.
66
ICT
I
In-Circuit Test Input:
Setting this pin "Low" causes all digital and analog outputs to go into a
high-impedance state to allow for in-circuit testing. This pin should be
set to "High" for normal operation.
This pin is internally pulled "High".
67
89
75
LOSTHR_0
LOSTHR_1
LOSTHR_2
I
Loss of Signal Threshold Control - Channel (n):
Forcing the LOSTHR_(n) pin to GND or VDD provides two settings. This
pin must be set to a “High” or “Low” level upon power up and should not
be changed during operation.
This pin is only applicable during DS3 or STS-1 operations.
相關PDF資料 |
PDF描述 |
|---|---|
| MS3101A22-20S | CONN RCPT 9POS FREE HNG W/SCKT |
| IDT72V263L10PFI8 | IC FIFO 8192X18 10NS 80QFP |
| VI-B6B-IV-F1 | CONVERTER MOD DC/DC 95V 150W |
| IDT72615L50PF8 | IC FIFO BY SYNC 512X18X2 64QFP |
| MS27656T15F5PB | CONN RCPT 5POS WALL MNT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT73LC03AIVF | 制造商:Exar Corporation 功能描述:Line Interface Unit 51.84Mbps DS3/E3/STS-1 Serial 120-Pin LQFP |
| XRT73LC03AIV-F | 功能描述:外圍驅動器與原件 - PCI 3-Ch DS3, E3, STS-1 RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT73LC04A | 制造商:EXAR 制造商全稱:EXAR 功能描述:4 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT |
| XRT73LC04A_08 | 制造商:EXAR 制造商全稱:EXAR 功能描述:4 CHANNEL DS3/E3/STS-1 LINE INTERFACE UNIT |
| XRT73LC04AES | 功能描述:網絡控制器與處理器 IC RoHS:否 制造商:Micrel 產品:Controller Area Network (CAN) 收發器數量: 數據速率: 電源電流（最大值）:595 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PBGA-400 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。