- 您現在的位置：買賣IC網 > PDF目錄9689 > XRT91L32IQ (Exar Corporation)IC TXRX SONET/SDH 8BIT 100QFP PDF資料下載
參數資料
| 型號： | XRT91L32IQ |
| 廠商： | Exar Corporation |
| 文件頁數： | 21/37頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX SONET/SDH 8BIT 100QFP |
| 產品變化通告： | XRT91L32IQ(TR) Obsolescence 12/Oct/2010 |
| 標準包裝： | 90 |
| 類型： | 收發器 |
| 規程： | SONET/SDH |
| 電源電壓： | 3.3V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 100-BQFP |
| 供應商設備封裝： | 100-QFP（14x20） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁當前第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
XRT91L32
xr
STS-12/STM-4 OR STS-3/STM-1 SONET/SDH TRANSCEIVER
REV. 1.0.3
26
4.0
DIAGNOSTIC FEATURES
4.1
Serial Remote Loopback
The serial remote loopback function is activated by setting RLOOPS "High". When serial remote loopback is
activated, the high-speed serial receive data from RXIP/N is presented at the high speed transmit output
TXOP/N, and the high-speed recovered clock is selected and presented to the high-speed transmit clock input
of the Retimer. During serial remote loopback, the high-speed receive data (RXIP/N) is also converted to
parallel data and presented at the low-speed receive parallel interface RXDO[7:0]. The recovered receive clock
is also divided by 8 and presented at the low-speed clock output RXPCLKO to synchronize the transfer of the
8-bit received parallel data. A simplified block diagram of serial remote loopback is shown in Figure 16.
4.2
Digital Local Loopback
The digital local loopback is activated when the DLOOP signal is set "High." When digital local loopback is
activated, the high-speed data from the output of the parallel to serial converter is looped back and presented
to the high-speed input of the receiver serial to parallel converter. The CMU output is also looped back to the
receive section and is used to synchronize the transfer of the data through the receiver. In Digital loopback
mode, the transmit data from the transmit parallel interface TXDI[7:0] is serialized and presented to the high-
speed transmit output TXOP/N using the high-speed 622.08/155.52 MHz transmit clock generated from the
clock multiplier unit and presented to the input of the Retimer and SIPO. A simplified block diagram of digital
loopback is shown in Figure 17. Receive Data mute upon LOS, as shown in Figure 7, applies to Digital Local
Loopback Mode
FIGURE 16. SERIAL REMOTE LOOPBACK
FIGURE 17. DIGITAL LOCAL LOOPBACK
PISO
Re-Tim er
LVPE CL
O utput Drivers
LVP ECL
Input Drivers
CD R
SIPO
R x Parallel O utput
Tx Serial O utput
S erial Rem ote Loopback
Rx S erial Input
PISO
Re-Timer
LVPECL
Output Drivers
LVPECL
Input Drivers
CDR
SIPO
Rx Parallel Output
Tx Serial Output
Digital Loopback
Tx Parallel Input
相關PDF資料 |
PDF描述 |
|---|---|
| M83723/78R1002N | CONN PLUG 2POS STRAIGHT W/PINS |
| VE-JTL-MX-F3 | CONVERTER MOD DC/DC 28V 75W |
| M83723/83A1006N | CONN RCPT 6POS WALL MT W/PINS |
| VE-JTL-MX-F1 | CONVERTER MOD DC/DC 28V 75W |
| MS27508E20B41PD | CONN RCPT 41POS BOX MNT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT91L32IQ-F | 功能描述:總線收發器 8-Bit TTL 3.3V temp -45 to 85C;UART RoHS:否 制造商:Fairchild Semiconductor 邏輯類型:CMOS 邏輯系列:74VCX 每芯片的通道數量:16 輸入電平:CMOS 輸出電平:CMOS 輸出類型:3-State 高電平輸出電流:- 24 mA 低電平輸出電流:24 mA 傳播延遲時間:6.2 ns 電源電壓-最大:2.7 V, 3.6 V 電源電壓-最小:1.65 V, 2.3 V 最大工作溫度:+ 85 C 封裝 / 箱體:TSSOP-48 封裝:Reel |
| XRT91L32IQTR | 功能描述:LIN 收發器 PHY Transceiver RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| XRT91L32IQTR-F | 功能描述:LIN 收發器 PHY Transceiver RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| XRT91L33 | 制造商:EXAR 制造商全稱:EXAR 功能描述:STS-12/STS-3 MULTIRATE CLOCK AND DATA RECOVERY UNIT |
| XRT91L33AIG-F | 制造商:Exar Corporation 功能描述:CDR 155.52Mbps/622.08Mbps SONET/SDH 20-Pin TSSOP |
發布緊急采購，3分鐘左右您將得到回復。