- 您現在的位置：買賣IC網 > PDF目錄372952 > XTR108EA 4-20mA, TWO-WIRE TRANSMITTER Smart Programmable with Signal Conditioning PDF資料下載
參數資料
| 型號： | XTR108EA |
| 英文描述： | 4-20mA, TWO-WIRE TRANSMITTER Smart Programmable with Signal Conditioning |
| 中文描述： | 的4 - 20mA，兩線制變送器可編程智能與信號調理 |
| 文件頁數： | 22/27頁 |
| 文件大?。?/td> | 497K |
| 代理商： | XTR108EA |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁
XTR108
SBOS187B
22
www.ti.com
APPLICATIONS
RTD CONNECTION METHODS
Two-Wire Connection
The simplest circuit that can be used to connect an RTD to
the XTR108 is the two-wire connection shown in Figure 9.
If the RTD is separated from the XTR108 by any distance
the resistance of the lead wires can cause significant error in
the reading. This wire resistance is noted as R
LINE1
and
R
LINE2
. If the RF filter is not required, then the PGA inputs
could be taken from the same pins as are used for the current
sources.
Three-Wire Connection
It is possible to minimize the errors caused by the lead-wire
resistance by connecting the RTD, see Figure 10. Operating
under the assumption that the wire connecting pin 1 to the
XTR108 is the same length as the wire at pin 2, and with the
current through the RTD identical to the current through R
Z
any error voltage caused by the lead-wire is the same on both
sides. This appears as a common-mode voltage and is
subtracted by the PGA.
The circuit in Figure 10 also shows a scheme where one
board can be optimized for a wide range of temperatures.
Consider a range of applications where there are up to five
different minimum temperatures. Select R
Z1
through R
Z5
to
be optimum for each of the minimum temperatures. The
configuration codes in the EEPROM can be set to select that
resistor for that unique situation.
Four-Wire Connection
For those applications where the resistance of the lead-wires
is not equal, it may be an advantage to add a precision op
amp to a four-wire connection, see Figure 11. The voltage
offset and drift are error terms that degrade the operation of
the system. This circuit does not suffer any loss of accuracy
for the resistance of the RTD lead-wires.
BRIDGE SENSOR CONNECTIONS
Fixed Voltage Excitation
There exists a class of sensors that are best supplied with a
voltage source excitation such as the bridge sensor shown in
Figure 12. The excitation voltage here is given by:
V
V
R
R
EX
REF
=
+
1
1
2
Uni-Directional Linearity Control
The circuit in Figure 13 shows a bridge sensor with an
excitation voltage that is adjusted to linearize the response
using the same algorithm as the RTD linearization.
V
I
R
EX
REF
I
=
2
FIGURE 9. Two-Wire RTD Connection with RF Filter at Input Terminals.
M
0.01
μ
F
0.01
μ
F
1k
1k
R
LINE2
R
LINE1
R
Z
1
2
RTD
R
CM
I
RET
0.01
μ
F
相關PDF資料 |
PDF描述 |
|---|---|
| XTR110L | LCC Precision Voltage-to-Current Converter/Transmitter |
| XTR501 | XTR501 - HIGH CURRENT BRIDGE DRIVER and 4-20mA Transmitter |
| XTTEK100Q56 | PSU 100W 4 O/P U FRAME |
| XTTEK100Q86 | PSU 100W 4 O/P U FRAME |
| XTTEK100S01 | PSU 5V 20A L FRAME |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XTR108EA/2K5 | 功能描述:接口 - 專用 4-20mA 2Wire Trsmtr ’Smart’ Prog RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
| XTR108EA/2K5G4 | 功能描述:接口 - 專用 4-20mA 2Wire Trsmtr ’Smart’ Prog RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
| XTR108EA-2K5 | 制造商:BB 制造商全稱:BB 功能描述:4-20mA, TWO-WIRE TRANSMITTER a??Smarta?? Programmable with Signal Conditioning |
| XTR108EA-2K5G4 | 制造商:BB 制造商全稱:BB 功能描述:4-20mA, TWO-WIRE TRANSMITTER a??Smarta?? Programmable with Signal Conditioning |
| XTR108EAG4 | 功能描述:接口 - 專用 4-20mA 2Wire Trsmtr ’Smart’ Prog RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
發布緊急采購，3分鐘左右您將得到回復。