參數資料
型號: 101-0411
廠商: Rabbit Semiconductor
文件頁數: 47/90頁
文件大?。?/td> 0K
描述: INTERFACE 12KEYDISP ETHNT OP6700
標準包裝: 25
系列: SBC
模塊/板類型: 單板計算機模塊
適用于相關產品: OP6700
User’s Manual
47
5.2 Running TCP/IP Sample Programs
We have provided a number of sample programs demonstrating various uses of TCP/IP for
networking embedded systems. These programs require that the user connect his PC and
the Intellicom board together on the same network. This network can be a local private
network (preferred for initial experimentation and debugging), or a connection via the
Internet.
Obtaining IP addresses to interact over an existing, operating, network can involve a num-
ber of complications, and must usually be done with cooperation from your ISP and/or
network systems administrator (if your company has one). For this reason, it is suggested
that the user begin instead by using a direct connection between a PC and the Intellicom
board using an Ethernet crossover cable or a simple arrangement with a hub. (A crossover
cable should not be confused with regular straight through cables.) The hub and a wide
variety of cables can also be purchased from a local computer store.
In order to set up this direct connection, the user will have to use a new PC (right out of
the box), or disconnect a PC from the corporate network, or as yet another approach install
a second Ethernet adapter and set up a separate private network attached to the second
Ethernet adapter. Disconnecting your PC from the corporate network may be easy or
nearly impossible, depending on how it is set up. Mobile PCs, such as laptops, are
designed to be connected and disconnected, and will present the least problem. If your PC
boots from the network or is dependent on the network for some or all of its disks, then it
probably should not be disconnected. If a second Ethernet adapter is used, be aware that
Windows TCP/IP will send messages to one adapter or the other, depending on the IP
address and the binding order in Microstate products. Thus you should have different
ranges of IP addresses on your private network from those used on the corporate network.
If both networks service the same IP address, then Windows may send a packet intended
for your private network to the corporate network. A similar situation will take place if
you use a dial-up line to send a packet to the Internet. Windows may try to send it via the
local Ethernet network if it is also valid for that network.
The following private IP addresses are set aside for local networks and are not allowed on
the Internet: 10.0.0.0 to 10.255.255.255, 172.16.0.0 to 172.31.255.255, and 192.168.0.0 to
192.168.255.255.
The Intellicom board uses a 10Base-T type of Ethernet connection, which is the most
common scheme. The RJ-45 connectors are similar to U.S. style telephone connectors, are
except larger and have 8 contacts.
An alternative to the direct connection using a crossover cable is a direct connection using
a hub. The hub relays packets received on any port to all of the ports on the hub. Hubs are
low in cost and are readily available. The Intellicom board uses 10 Mbps Ethernet, so the
hub or Ethernet adapter must be either a 10 Mbps unit or a 10/100 Mbps unit.
相關PDF資料
PDF描述
AT24C02A-10PI-2.7 IC EEPROM 2KBIT 400KHZ 8DIP
AT24C02A-10PI-1.8 IC EEPROM 2KBIT 400KHZ 8DIP
25FMN-BMT-A-TF CONN FMN HSNG 25POS SNGL NOR SMD
046239012001800+ CONN FPC ONE-TOUCH LCK .5MM 12
AT24C01-10PI-1.8 IC EEPROM 1KBIT 400KHZ 8DIP
相關代理商/技術參數
參數描述
10104110 制造商:FCI-CONNECTOR 制造商全稱:FCI connector 功能描述:MICRO USB B TYPE RECEPTACLE
10104110-0001LF 功能描述:USB接頭 5P Quick Connect Micro USB TypeB Rcpt RoHS:否 制造商:FCI 產品:USB Type A Connectors 標準:USB 3.0 端口數量: 位置/觸點數量:9 型式:Female 電流額定值:1.8 A 安裝風格:Through Hole 端接類型:Solder Pin 連接器類型:USB 3.0 Receptacle
10104110-0001LF 制造商:FCI 功能描述:MICRO USB B, RECEPTACLE, 5POS, SMT RT AN
10-104-11-01 制造商:Concord Electronics Inc 功能描述:Contact Solder ST Thru-Hole
10-104-11-03 制造商:Concord Electronics Inc 功能描述: