- 您現在的位置：買賣IC網 > PDF目錄370035 > 28222-14 (Conexant Systems, Inc.) ATM Transmitter/Receiver with UTOPIA Interface PDF資料下載
參數資料
| 型號： | 28222-14 |
| 廠商： | Conexant Systems, Inc. |
| 英文描述： | ATM Transmitter/Receiver with UTOPIA Interface |
| 中文描述： | 自動柜員機發射機/接收機的UTOPIA接口 |
| 文件頁數： | 75/161頁 |
| 文件大?。?/td> | 1832K |
| 代理商： | 28222-14 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁當前第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁
allocation ranges from 0.8 % to 100 %. Programming a port
’
s rate value to zero
disables transmissions from that port and causes the transmit circuitry to ignore
FIFO flag indications from that port.
The programmed rate value is an upper bound on the transmission from a
particular port, and the exact ratio may not be achieved if multiple ports are active
at the same time.
CN8223
2.0 Functional Description
ATM Transmitter/Receiver with UTOPIA Interface
2.7 FIFO Port/UTOPIA Interface
100046C
Conexant
2-41
If a higher priority port indicates that it has a cell ready during servicing of a
lower priority port, service switches to the higher priority port after completion of
the cell currently being formatted and transmitted. Servicing of ports and priority
levels continues in this manner until the lowest priority ports are serviced and
empty.
Port priority programming is not intended to be dynamic and should be used
only as a configuration setup. Changes in port priority cannot take place until
ports are inactive (via FIFO empty flag or transmit rate shaping).
Unused ports should be programmed to the lowest priority level, and their
empty flag inputs should be connected to ground.
2.7.3 Transmit Rate Shaping Control
Each of the four transmit data ports has a rate shaping control to allow the
allocation of programmable bandwidth to cells originating from this port. The
TX_RATE_01 [0x09] and TX_RATE_23 [0x08] registers control this function.
The transmit circuitry contains a mod-256 master counter to control rate
shaping. This counter is incremented for every ATM cell that is transmitted, and it
rolls over to 0 when count 255 is reached.
The programmed rate value for a port in the TX_RATE_xx registers
determines the count range for which transmission from that port is allowed. For
instance, if Port 0 is programmed with a rate value of 63, transmission of cells
queued at Port 0 will be allowed for 64 (one more than the programmed value) of
the 256 counts of the master counter.
The transmission is spread over all counts of the counter so that transmission
is not bursty. This gives Port 0 a bandwidth allocation of 25 % of the total
outgoing bandwidth even if all of the other ports are inactive.
This allocation scheme is valid for rate values from 1 to 255 resulting in
2.7.4 Receive Port Addressing
Received cells are routed to each of the four FIFO ports depending on the values
in the Header Value and Header Mask registers. These registers allow a range of
ATM cells to be routed to one of the four FIFO ports. Also, the same ATM cell
can be routed to multiple receive FIFO ports if desired.
The HDR_VALx_12 and HDR_VALx_34 register contents are used to match
incoming ATM cell headers. There are four sets of these registers (x = 0, 1, 2, 3),
one set for each of the four receive FIFO ports. If HDR_VALx_12 and
HDR_VALx_34 are a bitwise match to the incoming cell, then this cell is routed
to the x receive FIFO port.
相關PDF資料 |
PDF描述 |
|---|---|
| 28233-11 | ATM Transmitter/Receiver with UTOPIA Interface |
| 28C010TRPDB-12 | 150 x 32 pixel format, LED Backlight available |
| 28C010TRT1DE-15 | 1 Megabit (128K x 8-Bit) EEPROM |
| 28C010TRT1DE-20 | 1 Megabit (128K x 8-Bit) EEPROM |
| 28C010TRT1FB-15 | 1 Megabit (128K x 8-Bit) EEPROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 282222-003 | 制造商:TE Connectivity 功能描述:81044/12-16-2 - Cable Rools/Shrink Tubing |
| 282223-003 | 制造商:TE Connectivity 功能描述:81044/12-16-3 - Cable Rools/Shrink Tubing |
| 282224-003 | 制造商:TE Connectivity 功能描述:81044/12-16-4 - Cable Rools/Shrink Tubing |
| 282224-1 | 功能描述:汽車連接器 ECONOSEAL RCPT CONT .5MM RoHS:否 制造商:Amphenol SINE Systems 產品:Contacts 系列:ATP 位置數量: 型式:Female 安裝風格: 端接類型: 觸點電鍍:Nickel |
| 282225-001 | 制造商:TE Connectivity 功能描述:81044/12-16-5 - Cable Rools/Shrink Tubing |
發布緊急采購，3分鐘左右您將得到回復。