參數資料
型號: 29F400T-90TC
廠商: Electronic Theatre Controls, Inc.
英文描述: 4MEGABIT (512K x 8/ 256K x 16) 5VOLT SECTOR ERASE CMOS FLASH MEMORY
中文描述: 4MEGABIT(為512k × 8 / 256K × 16)5VOLT扇區擦除的CMOS閃存
文件頁數: 14/38頁
文件大小: 240K
代理商: 29F400T-90TC
BRIGHT Preliminary BM29F400T/BM29F400B
Microelectronics
Inc.
- 14 -
DQ6
Toggle Bit
The BM29F400 also features the "Toggle Bit" as a method to indicate to the host system the status of
the Internal Programming and Erase Algorithms (see Figure 4 for Toggle Bit (DQ6) flowchart.
During an Internal Programming or Erase Algorithm cycle, successive attempts to read (
OE
toggling)
data from the device will result in DQ6 toggling between one and zero. Once Internal Programming or
Erase operation is completed, DQ6 will stop toggling and valid data will be read on the next
successive attempts. During
BYTE
Programming, Toggle Bit is valid after the rising edge of the
fourth
WE
pulse in the four write pulse sequence. For Chip Erase, Toggle Bit is valid after the rising
edge of the sixth
WE
pulse in the six write pulse sequence. For Sector Erase, Toggle Bit is valid after
the last rising edge of the sector erase
WE
pulse. Toggle Bit is also active during sector erase time-
out window.
In Byte/Word Programming, if the sector being written to is protected, the Toggle Bit will toggle for
about 300 nS and then stop toggling without the data having changed. In Chip Erase or Sector Erase,
the device will erase all the selected sectors except for the ones that are protected. If all selected
sectors are protected, the chip will toggle the Toggle Bit for about 300ns and then drop back into read
mode, having changed none of the data. Either CE or
OE
toggling will cause the DQ6 Toggle Bit I to
toggle.
DQ5
Exceeded Timing Limits
DQ5 will indicate if the Byte/Word Programming, Chip Erase, or Sector Erase time has exceeded the
specified limits (internal pulse count) of the device. Under these conditions DQ5 will produce a logical
"1". This is a failure condition which indicates that the program or erase cycle was not successfully
completed. Data Polling is the only operating function of the device under this condition. The
OE
and
WE
pins will control the output disable functions as described in Table 1.
If this failure condition occurs during Sector Erase operation, it specifies that particular sector is bad
and it may not be reused. However, other sectors are still functional and may continue to be used for
the program or erase operation. The device must be
RESET
to the Read mode to use other sectors
of the device. Write the Read/Reset command sequence to the device, and then execute the
Byte/Word Programming or Sector Erase command sequence. This allows the system to continue to
use the other active sectors in the device.
If this failure condition occurs during Chip Erase operation, it specifies that the entire chip is bad or
combination of sectors are bad. In so, the chip should not be reused.
If this failure condition occurs during Byte/Word Programming operation, it indicates the entire sector
containing that
BYTE
is bad and this sector may not be reused (other sectors are still functional and
can be reused.)
The DQ5 failure condition may also appear if a user tries to program a non blank location without
erasing. In this case, the device may exceed time limits and not complete the Internal Algorithm
operation. Hence, the system never reads a valid data on DQ7 bit and DQ6 never stops toggling.
Once the device has exceeded timing limits, the DQ5 bit will indicate a "1".
相關PDF資料
PDF描述
29F400T-90TI 4MEGABIT (512K x 8/ 256K x 16) 5VOLT SECTOR ERASE CMOS FLASH MEMORY
29F400B-12PC 4MEGABIT (512K x 8/ 256K x 16) 5VOLT SECTOR ERASE CMOS FLASH MEMORY
29F400C-55 4M-BIT [512Kx8/256Kx16] CMOS SINGLE VOLTAGE 5V ONLY BOOT SECTOR FLASH MEMORY
29F400C-70 4M-BIT [512Kx8/256Kx16] CMOS SINGLE VOLTAGE 5V ONLY BOOT SECTOR FLASH MEMORY
29F400C-90 4M-BIT [512Kx8/256Kx16] CMOS SINGLE VOLTAGE 5V ONLY BOOT SECTOR FLASH MEMORY
相關代理商/技術參數
參數描述
29F400T-90TI 制造商:未知廠家 制造商全稱:未知廠家 功能描述:4MEGABIT (512K x 8/ 256K x 16) 5VOLT SECTOR ERASE CMOS FLASH MEMORY
29F516S050B 制造商:Micro Plastics Inc 功能描述:
29F519G4 制造商: 功能描述: 制造商:undefined 功能描述:
29F52 制造商:FAIRCHILD 制造商全稱:Fairchild Semiconductor 功能描述:8-Bit Registered Transceiver
29F52 WAF 制造商:Fairchild Semiconductor Corporation 功能描述: