- 您現在的位置：買賣IC網 > PDF目錄24774 > 935086530518 (NXP SEMICONDUCTORS) 8-BIT, 16 MHz, MICROCONTROLLER, PQCC68 PDF資料下載
參數資料
| 型號： | 935086530518 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, 16 MHz, MICROCONTROLLER, PQCC68 |
| 封裝： | PLASTIC, LCC-68 |
| 文件頁數： | 40/112頁 |
| 文件大小： | 693K |
| 代理商： | 935086530518 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁當前第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁
1996 Jun 27
33
Philips Semiconductors
Product specication
8-bit microcontroller with on-chip CAN
P8xC592
Notes to the description of the CR bits
1. The test mode is intended for factory testing and not for customer use.
2. A modification of the bits Reference Active and Sync is only possible with Reset Request = HIGH (present). It is
allowed to set these bits while Reset Request is changed from a HIGH level to a LOW level. After an external reset
(pin RST = HIGH) the Reference Active bit is set HIGH (output), the Sync bit is undefined.
3. During an external reset (RST = HIGH) or when the Bus Status bit is set HIGH (Bus-OFF), the IML forces the
Reset Request HIGH (present). After the Reset Request bit is set LOW (absent) the CAN-controller will wait for:
a) One occurrence of the Bus-Free signal (11 recessive bits, see Section 13.6.9.6), if the preceding reset (Reset
Request = HIGH) has been caused by an external reset or a CPU initiated reset.
b) 128 occurrences of Bus-Free, if the preceding reset (Reset Request = HIGH) has been caused by a
CAN-controller initiated Bus-OFF, before re-entering the Bus-On mode, see Section 13.6.9.
c) When Reset Request is set HIGH (present), for whatever reason, the Control, Command, Status and Interrupt
bits are affected, see Table 40. The registers at addresses 4 to 8 are only accessible when the Reset Request is
set HIGH (present).
5RA
Reference Active (notes 2). If the value of RA is:
HIGH (output), then the pin REF is an 1
2AVDD reference output.
LOW (input), then a reference voltage may be input.
4
OIE
Overrun Interrupt Enable. If the value of OIE is:
HIGH (enabled) and the Data Overrun bit is set (see Section 13.5.5) then the CPU
receives an Overrun Interrupt signal.
LOW (disabled), then the CPU receives no Overrun Interrupt signal from the
CAN-controller.
3
EIE
Error Interrupt Enable. If the value of EIE is:
HIGH (enabled) and the Error or Bus Status change (see Section 13.5.5) then the CPU
receives an Error Interrupt signal.
LOW (disabled), then the CPU receives no Error Interrupt signal.
2
TIE
Transmit Interrupt Enable. If the value of TIE is:
HIGH (enabled) and when a message has been successfully transmitted or the
Transmit Buffer is accessible again, (e.g. after an Abort Transmission command), then
the CAN-controller transmits a Transmit Interrupt signal to the CPU.
LOW (disabled), then there is no transmission of the Transmit Interrupt signal by the
CAN-controller to the CPU.
1
RIE
Receive Interrupt Enable. If the value of RIE is:
HIGH (enabled) and when a message has been received without errors, then the
CAN-controller transmits a Receive Interrupt signal to the CPU.
LOW (disabled), then there is no transmission of the Receive Interrupt signal by the
CAN-controller to the CPU.
0RR
Reset Request (note 3). If the value of RR is:
HIGH (present), then detection of a Reset Request results in the CAN-controller
aborting the current transmission/reception of a message entering the reset state
synchronously to the system clock (tSCL, see Section 13.5.9).
LOW (absent), on the HIGH-to-LOW transition of the Reset Request bit, the
CAN-controller returns to its normal operating state.
BIT
SYMBOL
FUNCTION
相關PDF資料 |
PDF描述 |
|---|---|
| 935266795557 | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PQCC68 |
| 935086530512 | 8-BIT, 16 MHz, MICROCONTROLLER, PQCC68 |
| 935210470512 | 8-BIT, OTPROM, 16 MHz, MICROCONTROLLER, PQCC68 |
| 935089010512 | 8-BIT, 16 MHz, MICROCONTROLLER, PQCC68 |
| 935085020512 | 8-BIT, OTPROM, 16 MHz, MICROCONTROLLER, PQCC68 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 935087-000 | 制造商:TE Connectivity 功能描述:301A511-51-05/164-0 - Bulk |
| 935087N001 | 制造商:TE Connectivity 功能描述:301A511-51-05/164-CS7092 制造商:TE Connectivity 功能描述:301A511-51-05/164-CS7092 - Bulk |
| 9350DC-200-0GZZZA | 制造商:Siemens 功能描述: |
| 9350DC-200-0ZZZTA | 制造商:Siemens 功能描述: |
| 9350DC-200-0ZZZZA | 制造商:Siemens 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。