- 您現在的位置：買賣IC網 > PDF目錄10084 > AD7634BCPZRL (Analog Devices Inc)IC ADC 18BIT DIFF BIPO 48-LFCSP PDF資料下載
參數資料
| 型號： | AD7634BCPZRL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 16/32頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 18BIT DIFF BIPO 48-LFCSP |
| 標準包裝： | 2,500 |
| 系列： | PulSAR® |
| 位數： | 18 |
| 采樣率（每秒）： | 670k |
| 數據接口： | 串行，并聯 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 225mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-VFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 48-LFCSP-VQ（7x7） |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 1 個差分，單極；1 個差分，雙極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
Data Sheet
AD7634
Rev. B | Page 23 of 32
capacitor with the 100 nF capacitor placed as close as possible
to the AD7634.
Power Sequencing
The AD7634 requires sequencing of the AVDD and DVDD
supplies. AVDD should come up prior to or simultaneously
with DVDD. This can be achieved using the configuration in
Figure 27 or sequencing the supplies in that manner. The
other supplies can be sequenced as desired as long as absolute
maximum ratings are observed. The AD7634 is very insensitive
to power supply variations on AVDD over a wide frequency
range, as shown in Figure 33.
30
35
40
45
50
55
60
65
70
75
1
10
100
1000
10000
0
6
406
-051
FREQUENCY (kHz)
P
SRR
(
d
B)
Figure 33. AVDD PSRR vs. Frequency
Power Dissipation vs. Throughput
In impulse mode, the AD7634 automatically reduces its power
consumption at the end of each conversion phase. During the
acquisition phase, the operating currents are very low, which allows
a significant power savings when the conversion rate is reduced
(see Figure 34). This feature makes the AD7634 ideal for very
low power, battery-operated applications.
It should be noted that the digital interface remains active even
during the acquisition phase. To reduce the operating digital supply
currents even further, drive the digital inputs close to the power
rails, that is, OVDD and OGND.
1000
1
1000000
100000
SAMPLING RATE (kSPS)
PO
W
ER
D
ISSI
PA
T
IO
N
(m
W
)
100
10
10000
1000
10
100
064
06-
0
48
IMPULSE MODE POWER
WARP MODE POWER
PDREF = PDBUF = HIGH
Figure 34. Power Dissipation vs. Sample Rate
Power Down
Setting PD = high powers down the AD7634, thus reducing
supply currents to their minimums, as shown in Figure 23.
When the ADC is in power down, the current conversion
(if any) is completed and the digital bus remains active. To
further reduce the digital supply currents, drive the inputs to
OVDD or OGND.
Power down can also be programmed with the configuration
register. See the Software Configuration section for details. Note
that when using the configuration register, the PD input is a don’t
care and should be tied to either high or low.
CONVERSION CONTROL
The AD7634 is controlled by the CNVST input. A falling edge
on CNVST is all that is necessary to initiate a conversion. A
detailed timing diagram of the conversion process is shown in
Figure 35. Once initiated, it cannot be restarted or aborted, even
by the power-down input, PD, until the conversion is complete.
The CNVST signal operates independently of CS and RD signals.
BUSY
MODE
CONVERT
ACQUIRE
CONVERT
CNVST
t1
t2
t4
t3
t5
t6
t7
t8
0
64
06
-0
33
Figure 35. Basic Conversion Timing
Although CNVST is a digital signal, it should be designed with
special care with fast, clean edges and levels with minimum
overshoot, undershoot, or ringing.
The CNVST trace should be shielded with ground and a low value
(such as 50 Ω) serial resistor termination should be added close
to the output of the component that drives this line.
For applications where SNR is critical, the CNVST signal should
have very low jitter. This can be achieved by using a dedicated
oscillator for CNVST generation, or by clocking CNVST with a
high frequency, low jitter clock, as shown in Figure 27.
相關PDF資料 |
PDF描述 |
|---|---|
| D38999/26WD15PC | CONN PLUG 15POS STRAIGHT W/PINS |
| IDT72V235L15TF8 | IC FIFO SYNC 2048X18 15NS 64QFP |
| AD774BJNZ | IC ADC 12BIT W/BUFF REF 28DIP |
| VE-2N1-IW-F3 | CONVERTER MOD DC/DC 12V 100W |
| IDT72245LB25TF8 | IC FIFO 1024X18 SYNC 25NS 64QFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7634BSTZ | 功能描述:IC ADC 18BIT DIFF BIPO 48-LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| AD7634BSTZRL | 功能描述:IC ADC 18BIT DIFF BIPO 48-LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:PulSAR® 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| AD7641 | 制造商:AD 制造商全稱:Analog Devices 功能描述:16-Bit, 750 kSPS, Unipolar/Bipolar Programmable Input PulSAR ADC |
| AD7641ACP | 制造商:Analog Devices 功能描述:ADC SGL SAR 2MSPS 18BIT PARALLEL/SERL 48LFCSP - Trays |
| AD7641ACPRL | 制造商:Analog Devices 功能描述:ADC SGL SAR 2MSPS 18BIT PARALLEL/SERL 48LFCSP - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。