- 您現在的位置：買賣IC網 > PDF目錄16924 > AD8330-EVALZ (Analog Devices Inc)BOARD EVAL FOR AD8330 PDF資料下載
參數資料
| 型號： | AD8330-EVALZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 18/32頁 |
| 文件大小： | 0K |
| 描述： | BOARD EVAL FOR AD8330 |
| 標準包裝： | 1 |
| 每 IC 通道數： | 1 - 單 |
| 放大器類型： | 可變?cè)鲆?br> |
| 輸出類型： | 差分，滿擺幅 |
| 轉換速率： | 1500 V/µs |
| -3db帶寬： | 150MHz |
| 工作溫度： | -40°C ~ 85°C |
| 電流供應（主 IC）： | 20mA |
| 電壓 - 電源，單路/雙路(±)： | 2.7 V ~ 6 V |
| 板類型： | 完全填充 |
| 已供物品： | 板 |
| 已用 IC / 零件： | AD8330 |
| 產品目錄頁面： | 775 (CN2011-ZH PDF) |
| 相關產品： | AD8330ACPZ-R7DKR-ND - IC AMP VGA 150MHZ LN LP 16LFCSP AD8330ACPZ-R2-ND - IC AMP VGA 150MHZ LN LP 16LFCSP AD8330ACPZ-RL-ND - IC AMP VGA 150MHZ LN LP 16LFCSP AD8330ACPZ-R7CT-ND - IC AMP VGA 150MHZ LN LP 16LFCSP AD8330ACPZ-R7TR-ND - IC AMP VGA 150MHZ LN LP 16LFCSP AD8330ARQZ-RL-ND - IC AMP VGA 150MHZ LN LP 16QSOP AD8330ARQZ-R7-ND - IC AMP VGA 150MHZ LN LP 16QSOP AD8330ARQZ-ND - IC AMP VGA 150MHZ LN LP 16QSOP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
Data Sheet
AD8330
Rev. F | Page 25 of 32
APPLICATIONS INFORMATION
The versatility of the AD8330, its very constant ac response over
a wide range of gains, the large signal dynamic range, output
swing, single supply operation, and low power consumption
commend this VGA to a diverse variety of applications. Only a
few can be described here, including the most basic uses and some
unusual ones.
ADC DRIVING
The AD8330 is well-suited to drive a high speed converter.
There are many high speed converters available, but to illustrate
the general features, the example in this data sheet uses one of
the least expensive, the AD9214. This is available in three
grades for operation at 65 MHz, 80 MHz, and 105 MHz; the
AD9214BRS-80 is a good complement to the general capabili-
ties of this VGA.
Figure 63 shows the connections to drive an ADC. A 3.3 V
supply is used for both parts. The ADC requires that its input
pins be positioned at one third of the supply, or 1.1 V. Given
that the default output level of the VGA is one-half the supply
or 1.65 V, a small correction is introduced by the 8 kΩ resistor
from CNTR to ground. The ADC specifications require that the
common-mode input be within ±0.2 V of the nominal 1.1 V;
variations of up to ±20% in the AD8330 on-chip resistors change
this voltage by only ±70 mV. With the connections shown in
Figure 63, the AD9214 is able to receive an input of 2 V p-p; the
peak output of the AD8330 can be reduced if desired by adding
a resistor
from VMAG to ground. An overrange condition is signaled by a
high state on Pin OR of the AD9214. DFS/GAIN is unconnected
in this example producing an offset-binary output. To provide a
twos complement output, it should be connected to the REF pin.
For ADCs running at sampling rates substantially below the
bandwidth of the AD8330, an intervening noise filter is
recommended to limit the noise bandwidth. A one-pole filter
can easily be created with a single differential capacitor between
the OPHI and OPLO outputs. For a corner frequency of fC, the
capacitor should have a value of
CFILT = 1/942 fC
(26)
For example, a 10 MHz corner requires about 100 pF.
SIMPLE AGC AMPLIFIER
Figure 64 illustrates the use of the inverted gain mode and the
offset gain range (0.2 V < VDBS < 1.7 V) in supporting a low cost
AGC loop. Q1 is used as a detector. When OPHI is sufficiently
higher than CNTR, due to the signal swing, it conducts and
charges C1. This raises VDBS and rapidly lowers the gain. Note
that MODE is grounded (see Figure 48). The minimum voltage
needed across R1 to set up the full gain is 0.2 V because CMGN
is dc open-circuited (this does not alter VMAG) and the maxi-
mum voltage is 1.7 V.
COMM
OPHI
INLO
OPLO
INHI
VPSI
VPSO
CMOP
MODE
VDBS
CMGN
OFST
CNTR
ENBL
VPOS
BIAS AND
V-REF
CM MODE AND
OFFSET CONTROL
OUTPUT
STAGES
OUTPUT
CONTROL
VGA CORE
AD9214BRS-80
DAT
A
O
UT
P
UT
S
D0
D1
D2
D3
D4
D5
D6
D7
D8
D9
DGND
CLK
AGND
CLOCK
REF
0.1F
REFSENSE
NC
ANALOG GROUND
AIN
DFS/GAIN
PWRDN
DIGITAL
GROUND
GAIN BIAS,
VDBS, 0V–1.5V
NC
INPUT,
±2V MAX
0.1F
10
GAIN INTERFACE
CHPF
8k
0.1F
AVDD
OR
DrVDD
3.3
OVER-
RANGE
3.3
0.1F
VS, 3.3V
03217-
064
VMAG
Figure 63. Driving an Analog-to-Digital Converter (Preliminary)
相關PDF資料 |
PDF描述 |
|---|---|
| 202D163-3-0 | BOOT MOLDED |
| RCC06DRTS-S93 | CONN EDGECARD 12POS DIP .100 SLD |
| VI-B5Z-EX | CONVERTER MOD DC/DC 2V 30W |
| 234A032-100-0 | BOOT MOLDED |
| LQW15AN1N5D00D | INDUCTOR 1.5NH 1000MA 0402 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8331 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Ultralow Noise VGAs with Preamplifier and Programmable RIN |
| AD8331_06 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Ultralow Noise VGAs with Preamplifier and Programmable RIN |
| AD8331_10 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Ultralow Noise VGAs with Preamplifier and Programmable RIN |
| AD8331ARQ | 功能描述:IC VGA SINGLE W/PREAMP 20-QSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:X-AMP® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變?cè)鲆娣糯笃?應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP（5x5） 包裝:托盤 |
| AD8331ARQ-REEL | 功能描述:IC VGA SINGLE W/PREAMP 20-SSOP RoHS:否 類別:集成電路 (IC) >> 線性 - 放大器 - 專用 系列:X-AMP® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:60 系列:- 類型:可變?cè)鲆娣糯笃?應用:CATV 安裝類型:表面貼裝 封裝/外殼:20-WQFN 裸露焊盤 供應商設備封裝:20-TQFN-EP（5x5） 包裝:托盤 |
發布緊急采購，3分鐘左右您將得到回復。