- 您現在的位置：買賣IC網 > PDF目錄373982 > ADF4193BCPZ (ANALOG DEVICES INC) Low Phase Noise, Fast Settling PLL Frequency Synthesizer PDF資料下載
參數資料
| 型號： | ADF4193BCPZ |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | XO, clock |
| 英文描述： | Low Phase Noise, Fast Settling PLL Frequency Synthesizer |
| 中文描述： | PLL FREQUENCY SYNTHESIZER, 3500 MHz, QCC32 |
| 封裝： | 5 X 5 MM, ROHS COMPLIANT, MO-220VHHD-2, LFCSP-32 |
| 文件頁數： | 11/28頁 |
| 文件大?。?/td> | 437K |
| 代理商： | ADF4193BCPZ |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
ADF4193
THEORY OF OPERATION
The ADF4193 is targeted at GSM base station requirements,
specifically to eliminate the need for ping-pong solutions. It
works based on fast lock, using a wide loop bandwidth during a
frequency change and narrowing the loop bandwidth once
frequency lock is achieved. Widening the loop bandwidth is
achieved by increasing the charge pump current. Switches are
included to change the loop filter component values to maintain
stability with the changing charge pump current. The narrow
loop bandwidth ensures that phase noise and spur specifications
are met. A differential charge pump and loop filter topology are
used to ensure that the fast lock time benefit from widening the
loop bandwidth is maintained when the loop is restored to
narrow bandwidth mode for normal operation.
Rev. B | Page 11 of 28
REFERENCE INPUT SECTION
The reference input stage is shown in Figure 20. Switches S1 and
S2 are normally closed, and S3 is normally open. During power-
down, S3 is closed, and S1 and S2 are opened to ensure that
there is no loading of the REF
IN
pin. The falling edge of REF
IN
is
the active edge at the positive edge triggered PFD.
0
BUFFER
TO R COUNTER
REF
IN
100k
Ω
NC
S2
S3
NO
NC
S1
POWER-DOWN
CONTROL
Figure 20. Reference Input Stage
R Counter and Doubler
The 4-bit R counter allows the input reference frequency to be
divided down to produce the reference clock to the phase
frequency detector (PFD). A toggle flip-flop can be optionally
inserted after the R counter to give a further divide-by-2. Using
this option has the additional advantage of ensuring that the
PFD reference clock has a 50/50 mark-space ratio. This ratio
gives the maximum separation between the fast lock timer
clock, which is generated off the falling edge of the PFD
reference, and the rising edge, which is the active edge in the
PFD. It is recommended that this toggle flip-flop be enabled for
all even R divide values greater than 2. It must be enabled if
dividing down a REF
IN
frequency that is greater than 120 MHz.
An optional doubler before the 4-bit R counter can be used for
low REF
IN
frequencies, up to 20 MHz. With these programmable
options, reference division ratios from 0.5 to 30 between REF
IN
and the PFD are possible.
RF INPUT STAGE
The RF input stage is shown in Figure 21. It is followed by a
2-stage limiting amplifier to generate the CML clock levels
needed for the prescaler. Two prescaler options are selectable: a
4/5 and an 8/9. The 8/9 prescaler is selected for N divider values
greater than 80.
0
BIAS
GENERATOR
1.6V
AGND
AV
DD
500
Ω
500
Ω
RF
IN–
RF
IN+
Figure 21. RF Input Stage
RF N Divider
The RF N divider allows a fractional division ratio in the PLL
feedback path. The integer and fractional parts of the division
are programmed using separate registers, as shown in Figure 22
and described in the INT, FRAC, and MOD Relationship
section. Integer division ratios from 26 to 255 are allowed and a
third-order, Σ-Δ modulator interpolates the fractional value
between the integer steps.
0
THIRD-ORDER
FRACTIONAL
INTERPOLATOR
FRAC
VALUE
MOD
REG
INT
REG
RF N DIVIDER
N = INT + FRAC/MOD
FROM RF
INPUT STAGE
TO PFD
N COUNTER
Figure 22. Fractional-N Divider
INT, FRAC, and MOD Relationship
The INT, FRAC, and MOD values, programmed through the
serial interface, make it possible to generate RF output frequencies
that are spaced by fractions of the PFD reference frequency.
The N divider value, shown inside the brackets of the following
equation for the RF VCO frequency (RF
OUT
), is made up of an
integer part (INT) and a fractional part (FRAC/MOD):
RF
OUT
=
F
PFD
× [
INT
+ (
FRAC
/
MOD
)]
where:
RF
OUT
is the output frequency of the external VCO.
F
PFD
is the PFD reference frequency.
相關PDF資料 |
PDF描述 |
|---|---|
| ADF4193BCPZ-RL | Low Phase Noise, Fast Settling PLL Frequency Synthesizer |
| ADF4193BCPZ-RL7 | Low Phase Noise, Fast Settling PLL Frequency Synthesizer |
| ADF4207BRU | Dual RF PLL Frequency Synthesizers |
| ADF4208BRU | Dual RF PLL Frequency Synthesizers |
| ADF4206 | Dual RF PLL Frequency Synthesizers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADF4193BCPZ-RL | 功能描述:IC PLL FREQ SYNTHESIZER 32LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:2,000 系列:- 類型:PLL 時鐘發生器 PLL:帶旁路 輸入:LVCMOS，LVPECL 輸出:LVCMOS 電路數:1 比率 - 輸入:輸出:2:11 差分 - 輸入:輸出:是/無 頻率 - 最大:240MHz 除法器/乘法器:是/無 電源電壓:3.135 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:32-LQFP 供應商設備封裝:32-TQFP（7x7） 包裝:帶卷 (TR) |
| ADF4193BCPZ-RL7 | 功能描述:IC PLL FREQ SYNTHESIZER 32LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:2,000 系列:- 類型:PLL 時鐘發生器 PLL:帶旁路 輸入:LVCMOS，LVPECL 輸出:LVCMOS 電路數:1 比率 - 輸入:輸出:2:11 差分 - 輸入:輸出:是/無 頻率 - 最大:240MHz 除法器/乘法器:是/無 電源電壓:3.135 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:32-LQFP 供應商設備封裝:32-TQFP（7x7） 包裝:帶卷 (TR) |
| ADF4193SP1BCPZ | 制造商:Analog Devices 功能描述: |
| ADF4193SP1BCPZ-RL7 | 制造商:Analog Devices 功能描述: |
| ADF4193SP2BCPZ-RL7 | 制造商:Analog Devices 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。