參數資料
型號: ADM6926
廠商: Electronic Theatre Controls, Inc.
英文描述: 26 port 10/100 Mbps Ethernet Switch Controller
中文描述: 26端口10/100 Mbps以太網交換機控制器
文件頁數: 17/85頁
文件大?。?/td> 4222K
代理商: ADM6926
ADM6926
Function Description
Chapter 3 Function Description
3.1 Introduction
The ADM6926 uses a “store & forward” switching approach for the following reasons:
1)
Store & forward switches allow switching between different speed media (e.g.
10BaseX and 100BaseX). Such switches require the large elastic buffers, especially
bridging between a server on a 100Mbps network and clients on a 10Mbps segment.
2)
Store & forward switches improve overall network performance by acting as a
“network cache”
3)
Store & forward switches prevent the forwarding of corrupted packets by the frame
check sequence (FCS) before forwarding to the destination port.
3.1.1 Basic Operation
The ADM6926 receives incoming packets from one of its ports, uses the source address
(SA) and VID to update the address table, and then forwards the packet to the output
ports determined by the destination address (DA) and VID.
If the DA and VID are not found in the address table, the ADM6926 treats the packet as a
broadcast packet and forwards the packet to the other ports within the same group.
The ADM6926 automatically learns the port number of attached network devices by
examining the SA and VID of all incoming packets. If the SA and VID are not found in
the address table, the device adds it to the table.
3.1.2 Address Learning
The ADM6926 provides two ways to create the entry in the address table: dynamic
learning and manual learning. A four-way hash algorithm is implemented to allow 4
different addresses to be stored at the same location. Up to 4k entries can be created and
all entries are stored in the internal SSRAM. Two parameters, SA and VID, are combined
to generate the 10-bit hash key to allow that the same addresses with different port
number can exist in the table at the same time.
1. Dynamic Learning
The ADM6926 searches for SA and VID of an incoming packet in the address table and
acts as follows:
ADMtek Inc.
3-1
If the SA+VID was not found in the address table (a new address), the ADM6926 waits
until the end of the packet (non-error packet) and updates the address table. If the
相關PDF資料
PDF描述
ADM7008 Octal Ethernet 10/100M PHY
ADM9511 LAN/Modem Controller with Embedded Fast Ethernet PHY
ADS-238Q 12-Bit, 20MHz, Low Power Sampling A/D Converters
ADS-917GC 14-Bit, 1MHz, Low-Power Sampling A/D Converters
ADS-927GC 14-Bit, 1MHz, Low-Power Sampling A/D Converters
相關代理商/技術參數
參數描述
ADM6926ABT1 功能描述:IC SWITCH CNTRLR 10/100 128QFP RoHS:否 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN(6x6) 包裝:* 其它名稱:Q6396337A
ADM6926X-AB-T-1 功能描述:IC ETHERNET SW CTRLR 128-PQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN(6x6) 包裝:* 其它名稱:Q6396337A
ADM692A 制造商:AD 制造商全稱:Analog Devices 功能描述:Microprocessor Supervisory Circuits
ADM692AAN 制造商:Rochester Electronics LLC 功能描述:5V CMOS PROCESS - Bulk 制造商:Analog Devices 功能描述:
ADM692AANZ 功能描述:IC SUPERVISOR MPU 4.4V WD 8DIP RoHS:是 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 其它有關文件:STM6905 View All Specifications 標準包裝:1 系列:- 類型:多壓監控器 監視電壓數目:5 輸出:開路漏極或開路集電極 復位:低有效 復位超時:最小為 140 ms 電壓 - 閥值:2.188V,2.955V,可調,可調,可調 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP,8-MSOP(0.118",3.00mm 寬) 供應商設備封裝:8-TSSOP 包裝:Digi-Reel® 產品目錄頁面:1197 (CN2011-ZH PDF) 其它名稱:497-8728-6