- 您現在的位置：買賣IC網 > PDF目錄369546 > BU-6586NEW MIL-STD-1553 Components |PCI Mini-ACE? Mark3 PDF資料下載
參數資料
| 型號： | BU-6586NEW |
| 英文描述： | MIL-STD-1553 Components |PCI Mini-ACE? Mark3 |
| 中文描述： | 符合MIL - STD - 1553器件|迷你的PCI ACE論壇？ Mark3 |
| 文件頁數： | 43/60頁 |
| 文件大?。?/td> | 410K |
| 代理商： | BU-6586NEW |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁當前第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁
43
Data Device Corporation
www.ddc-web.com
BU-64743/64843/64863
C-03/03-300
TRANSFORMERS
In selecting isolation transformers to be used with the Mini-ACE
Mark3, there is a limitation on the maximum amount of leakage
inductance. If this limit is exceeded, the transmitter rise and fall
times may increase, possibly causing the bus amplitude to fall
below the minimum level required by MIL-STD-1553. In addition,
an excessive leakage imbalance may result in a transformer
dynamic offset that exceeds 1553 specifications.
The maximum allowable leakage inductance is a function of the
coupling method. For Transformer Coupled applications, it is a
maximum of 5.0 μH. For Direct it is a maximum of 10.0 μH, and
is measured as follows:
The side of the transformer that connects to the Mark3 is defined
as the "primary" winding. If one side of the primary is shorted to
the primary center-tap, the inductance should be measured
across the "secondary" (stub side) winding. This inductance
must be less than 5.0 μH (Transformer Coupled) and 10.0 μH
(Direct Coupled). Similarly, if the other side of the primary is
shorted to the primary center-tap, the inductance measured
across the "secondary" (stub side) winding must also be less
than 5.0 μH (Transformer Coupled) and 10.0 μH (Direct
Coupled).
The difference between these two measurements is the "differ-
ential" leakage inductance. This value must be less than 1.0 μH
(Transformer Coupled) and 2.0 μH (Direct Coupled).
Beta Transformer Technology Corporation (BTTC), a subsidiary
of DDC, manufactures transformers in a variety of mechanical
configurations with the required turns ratios of 1:3.75 direct cou-
pled, and 1:2.7 transformer coupled.TABLE 46 provides a listing
of these transformers.
For further information, contact BTTC at 631-244-7393 or at
www.bttc-beta.com.
B-3383
B-3372
Single epoxy transformer, through hole, direct coupled only, 0.625" X 0.630", 0.300" max height
B-3389
Single epoxy transformer, surface mount, transformer coupled only, 85°C max, 0.625" X 0.625",
0.130" max height
Single epoxy transformer, through hole, transformer coupled only, 0.625" X 0.630", 0.300" max
height
BTTC PART NO.
TRANSFORMER CONFIGURATION
TABLE 46. BTTC TRANSFORMERS FOR USE WITH MINI-ACE MARK3
相關PDF資料 |
PDF描述 |
|---|---|
| BU-69200 | MIL-STD-1553 Components |ACE-Core |
| BU05MC | COMMON MODE CHOKE COILS (FOR DC AND SIGNAL LINES) SMD TYPE |
| BU105 | Transient Voltage Suppressor Diodes |
| BUY11 | Bipolar NPN Device |
| BU12006 | Transient Voltage Suppressor Diodes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| BU-65-9 | 功能描述:測試電夾 HEAVY DUTY LARGE JAW GATOR CLIP WHITE RoHS:否 制造商:Pomona Electronics 類型:Minigrabber clip 顏色:Black |
| BU6650NUX | 制造商:ROHM 制造商全稱:Rohm 功能描述:3ch CMOS LDO Regulators |
| BU6650NUX_11 | 制造商:ROHM 制造商全稱:Rohm 功能描述:3ch CMOS LDO Regulators |
| BU6650NUX-TR | 功能描述:低壓差穩壓器 - LDO LDO REG 0.2A 8PIN 2.8V 2.8V 1.8V RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| BU6651NUX | 制造商:ROHM 制造商全稱:Rohm 功能描述:High-speed Load Response Full CMOS LDP Regulators |
發布緊急采購，3分鐘左右您將得到回復。