- 您現在的位置：買賣IC網 > PDF目錄1908 > CP2112-F01-GM (Silicon Laboratories Inc)IC HID USB-TO-SMBUS BRIDGE 24QFN PDF資料下載
參數資料
| 型號： | CP2112-F01-GM |
| 廠商： | Silicon Laboratories Inc |
| 文件頁數： | 5/22頁 |
| 文件大小： | 0K |
| 描述： | IC HID USB-TO-SMBUS BRIDGE 24QFN |
| 產品培訓模塊： | CP21xx USB Bridge |
| 標準包裝： | 75 |
| 應用： | USB 至 SMBus 電橋 |
| 接口： | SMBus，USB |
| 電源電壓： | 1.8V，3 V ~ 3.6 V |
| 封裝/外殼： | 24-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 24-QFN（4x4） |
| 包裝： | 管件 |
| 安裝類型： | 表面貼裝 |
| 配用： | 336-2010-ND - KIT EVAL FOR CP2112 |
| 其它名稱： | 336-2004-5 |
CP2112
Rev. 1.2
13
5. USB Function Controller and Transceiver
The Universal Serial Bus (USB) function controller in the CP2112 is a USB 2.0 compliant full-speed device with
integrated transceiver and on-chip matching and pullup resistors. The USB function controller manages all data
transfers between the USB and the SMBus interface as well as command requests generated by the USB host
controller and commands for controlling the function of the SMBus interface and GPIO pins.
The USB Suspend and Resume modes are supported for power management of both the CP2112 device and
external circuitry. The CP2112 enters Suspend mode when Suspend signaling is detected on the bus. Upon
entering Suspend mode, the Suspend signals are asserted. The Suspend signals are also asserted after a CP2112
reset until device configuration during USB enumeration is complete. SUSPEND is logic high when the device is in
the Suspend state and logic low when the device is in normal mode. The SUSPEND pin has the opposite logic
value of the SUSPEND pin.
The CP2112 exits Suspend mode when any of the following events occur: Resume signaling is detected or
generated, a USB Reset signal is detected, or a device reset occurs. SUSPEND and SUSPEND are weakly pulled
to VIO in a high-impedance state during a CP2112 reset. If this behavior is undesirable, a strong pulldown resistor
(10 k
) can be used to ensure SUSPEND remains low during reset. The eight GPIO pins will retain their state
during Suspend mode.
6. System Management Bus (SMBus) Interface
The SMBus I/O interface is a two-wire, bidirectional serial bus. The SMBus is compliant with the System
Management Bus Specification, Version 1.1, and compatible with the I2C serial bus. Reads and writes to the
interface by the system controller are byte-oriented with the SMBus interface autonomously controlling the serial
transfer of the data. The CP2112 operates as an SMBus master; however, it has an SMBus slave address that is
configurable. The CP2112 will only ACK this address and will not respond to any read or write requests. If the least
significant bit of the address is set, the device will ignore it.
6.1. SMBus Configuration
Figure 5 shows a typical SMBus configuration. The SMBus specification allows any recessive voltage between
3.0 V and 5.0 V; different devices on the bus may operate at different voltage levels. The bidirectional serial clock
(SCL) and serial data (SDA) lines must be connected to a positive power supply voltage through a pullup resistor or
similar circuit. Every device connected to the bus must have an open-drain or open-collector output for both the
SCL and SDA lines so that both are pulled high (recessive state) when the bus is free. The maximum number of
devices on the bus is limited only by the requirement that the rise and fall times on the bus not exceed 300 ns and
1000 ns, respectively. The SMBus provides control of SDA, SCL generation and synchronization, arbitration logic,
and START/STOP control and generation.
Figure 5. Typical SMBus Configuration
VDD = 5 V
CP2112
(Master Device)
Slave
Device 1
Slave
Device 2
VDD = 3 V
VDD = 5 V
VDD = 3 V
SDA
SCL
相關PDF資料 |
PDF描述 |
|---|---|
| CP2120-GM | IC I/O EXPANDER I2C/SPI 8B 20QFN |
| CP2200-GQ | IC ETH CTRLR SNGL-CHIP 48TQFP |
| CP80C86-2Z | IC CPU 16BIT 5V 8MHZ 40-PDIP |
| CP82C50A-5Z | IC ASYNC COMM ELEMENT UART 40DIP |
| CP82C89 | IC ARBITER BUS 5V 8MHZ 20-DIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CP2112-F01-GMR | 功能描述:輸入/輸出控制器接口集成電路 HID USB to SMBUS bridge RoHS:否 制造商:Silicon Labs 產品: 輸入/輸出端數量: 工作電源電壓: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-64 封裝:Tray |
| CP2112-F02-FM | 制造商:Silicon Labs 功能描述:HID USB-to-SMBus Master,400kHz,OTP,QFN24 |
| CP2112-F02-GM | 功能描述:輸入/輸出控制器接口集成電路 HID USB to SMBUS Bridge RoHS:否 制造商:Silicon Labs 產品: 輸入/輸出端數量: 工作電源電壓: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-64 封裝:Tray |
| CP2112-F02-GMR | 制造商:Silicon Laboratories Inc 功能描述:Single Chip HID USB to SMBus Master Bridge 24-Pin QFN EP 制造商:Silicon Laboratories Inc 功能描述:HID USB TO SMBUS BRIDGE - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC HID USB-TO-SMBUS BRIDGE 制造商:Silicon Laboratories Inc 功能描述:HID USB to SMBUS Bridge |
| CP2112-F03-GM | 功能描述:IC HID USB-TO-SMBUS BRIDGE 24QFN 制造商:silicon labs 系列:- 包裝:管件 零件狀態:在售 協議:USB 功能:橋，USB 至 SMBus 接口:SMBus 標準:USB 2.0 電壓 - 電源:1.8V，3 V ~ 3.6 V 電流 - 電源:15mA 工作溫度:-40°C ~ 85°C 封裝/外殼:24-WFQFN 裸露焊盤 供應商器件封裝:24-QFN（4x4） 標準包裝:91 |
發布緊急采購，3分鐘左右您將得到回復。