- 您現在的位置：買賣IC網 > PDF目錄8999 > CS4361-CZZ (Cirrus Logic Inc)IC DAC STER 6CH 103DB 20TSSOP PDF資料下載
參數資料
| 型號： | CS4361-CZZ |
| 廠商： | Cirrus Logic Inc |
| 文件頁數： | 8/24頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DAC STER 6CH 103DB 20TSSOP |
| 標準包裝： | 74 |
| 位數： | 24 |
| 數據接口： | 串行 |
| 轉換器數目： | 6 |
| 電壓電源： | 單電源 |
| 功率耗散（最大）： | 455mW |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 20-TSSOP |
| 包裝： | 管件 |
| 輸出數目和類型： | 6 電壓，單極 |
| 采樣率（每秒）： | 192k |
| 產品目錄頁面： | 757 (CN2011-ZH PDF) |
| 配用： | 598-1153-ND - BOARD EVAL FOR CS4361 |
| 其它名稱： | 598-1057-5 |
16
CS4361
Confidential Draft
9/30/11
4.6
Output Transient Control
The CS4361 uses Popguard technology to minimize the effects of output transients during power-up and
power-down. When implemented with external DC-blocking capacitors connected in series with the audio
outputs, this feature eliminates the audio transients commonly produced by single-ended, single-supply
converters. To make the best use of this feature, it is necessary to understand its operation.
4.6.1
Power-Up
When the device is initially powered up, the audio outputs, AOUT1-6, are clamped to VQ, which is initially
low. After RST is released and MCLK is applied, the outputs begin to ramp with VQ towards the nominal
quiescent voltage. This ramp takes approximately 200 ms to complete. The gradual voltage ramping al-
lows time for the external DC-blocking capacitors to charge to VQ, effectively blocking the quiescent DC
voltage. Audio output begins approximately 2000 sample periods after valid LRCK and SDIN are supplied
(and SCLK, if used).
4.6.2
Power-Down
To prevent audio transients at power-down, the DC-blocking capacitors must fully discharge before turn-
ing off the power. In order to do this, either stop MCLK or hold RST low for a period of about 250 ms before
removing power. During this time, voltage on VQ and the audio outputs discharge gradually to GND. If
power is removed before this 250 ms time period has passed, a transient will occur when the VA supply
drops below that of VQ. There is no minimum time for a power cycle; power may be reapplied at any time.
When changing clock ratio or sample rate, it is recommended that zero data (or near zero data) be present
on SDIN for at least 10 LRCK samples before the change is made. During the clocking change, the DAC
outputs will always be in a zero data state. If non-zero audio is present at the time of switching, a slight
click or pop may be heard as the DAC output automatically goes to its zero data state.
4.7
Grounding and Power Supply Decoupling
As with any high-resolution converter, the CS4361 requires careful attention to power supply and grounding
arrangements to optimize performance. Figure 6 shows the recommended power arrangement, with VA
connected to a clean +5 V supply. For best performance, decoupling and filter capacitors should be located
as close to the device package as possible, with the smallest capacitors placed closest.
4.8
Analog Output and Filtering
The analog filter present in the CS4361 is a switched-capacitor filter followed by a continuous-time, low-
pass filter. Its response, combined with that of the digital interpolator, is given in Figures 14 - 21. The rec-
ommended external analog circuitry is shown in the “Typical Connection Diagram” on page 11.
The analog outputs are named AOUT1-6. The SDIN1 feeds AOUT1 as the ‘Left’ marked data and AOUT2
as the ‘Right’ marked data. The SDIN2 feeds AOUT3 as the ‘Left’ marked data and AOUT4 as the ‘Right’
marked data. The SDIN3 feeds AOUT5 as the ‘Left’ marked data and AOUT6 as the ‘Right’ marked data.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-J5Y-MZ-F1 | CONVERTER MOD DC/DC 3.3V 16.5W |
| VI-J5X-MZ-F4 | CONVERTER MOD DC/DC 5.2V 25W |
| VI-JT3-MZ-F3 | CONVERTER MOD DC/DC 24V 25W |
| VI-JT3-MZ-F2 | CONVERTER MOD DC/DC 24V 25W |
| M83723/96R1412N | CONN PLUG 12POS STRAIGHT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| CS4361-CZZR | 功能描述:數模轉換器- DAC IC 105dB 24-bit 192kHz 6ch DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| CS4361-DZZ | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:20-pin, 24-bit, 192 kHz, 6-channel D/A Converter |
| CS4362 | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:114 dB, 192 kHz 6-Channel D/A Converter |
| CS4362_04 | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:114 dB, 192 kHz 6-channel D/A Converter |
| CS4362_08 | 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:114 dB, 192 kHz 6-Channel D/A Converter |
發布緊急采購，3分鐘左右您將得到回復。