參數資料
型號: CS4382A-DQZR
廠商: Cirrus Logic Inc
文件頁數: 19/50頁
文件大?。?/td> 0K
描述: IC DAC 8CH 114DB 192KHZ 48-LQFP
標準包裝: 2,000
位數: 24
數據接口: 串行
轉換器數目: 8
電壓電源: 模擬和數字
功率耗散(最大): 680mW
工作溫度: -40°C ~ 105°C
安裝類型: 表面貼裝
封裝/外殼: 48-LQFP
供應商設備封裝: 48-LQFP(7x7)
包裝: 帶卷 (TR)
輸出數目和類型: 16 電壓,單極
采樣率(每秒): 192k
配用: 598-1524-ND - BOARD EVAL FOR CS4382A DAC
26
DS618F2
CS4382A
4.8
Direct Stream Digital (DSD) Mode
In Stand-alone Mode, DSD operation is selected by holding DSD_EN(LRCK) high and applying the DSD
data and clocks to the appropriate pins. The M[2:0] pins set the expected DSD rate and MCLK ratio.
In Control Port Mode, the FM bits set the device into DSD Mode (DSD_EN pin is not required to be held
high). The DIF register then controls the expected DSD rate and MCLK ratio.
During DSD operation, the PCM related pins should either be tied low or remain active with clocks (except
LRCK in Stand-alone Mode). When the DSD related pins are not being used, they should either be tied static
low or remain active with clocks (except M3 in Stand-alone Mode).
4.9
Grounding and Power Supply Arrangements
As with any high-resolution converter, the CS4382A requires careful attention to power supply and ground-
ing arrangements if its potential performance is to be realized. The Typical Connection Diagram shows the
recommended power arrangements, with VA, VD, VLC, and VLS connected to clean supplies. If the ground
planes are split between digital ground and analog ground, the GND pins of the CS4382A should be con-
nected to the analog ground plane.
All signals, especially clocks, should be kept away from the FILT+ and VQ pins in order to avoid unwanted
coupling into the DAC.
4.9.1
Capacitor Placement
Decoupling capacitors should be placed as close to the DAC as possible, with the low-value ceramic ca-
pacitor being the closest. To further minimize impedance, these capacitors should be located on the same
layer as the DAC. If desired, all supply pins with similar voltage ratings may be connected to the same
supply, but a decoupling capacitor should still be placed on each supply pin.
Notes:
All decoupling capacitors should be referenced to analog ground.
The CDB4382A evaluation board demonstrates the optimum layout and power supply arrangements.
4.10
Analog Output and Filtering
The application note “Design Notes for a 2-pole Filter with Differential Input” discusses the second-order
Butterworth filter and differential-to-single-ended converter which was implemented on the CS4382A eval-
uation board, CDB4382A, as seen in Figure 16. The CS4382A does not include phase or amplitude com-
pensation for an external filter. Therefore, the DAC system phase and amplitude response will be dependent
on the external analog circuitry. The off-chip filter has been designed to attenuate the typical full-scale out-
put level to below 2 Vrms.
Figure 15 shows how the full-scale differential analog output level specification is derived.
相關PDF資料
PDF描述
V150A36H400BF3 CONVERTER MOD DC/DC 36V 400W
VI-23F-IV-S CONVERTER MOD DC/DC 72V 150W
LTC2617CDE-1#PBF IC DAC 14BIT R-R I2C 12-DFN
VI-23B-IV-S CONVERTER MOD DC/DC 95V 150W
VI-2NN-MW-F1 CONVERTER MOD DC/DC 18.5V 100W
相關代理商/技術參數
參數描述
CS4382A-EQZ 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:114 dB, 192 kHz 8-channel D/A Converter
CS4382A-EQZR 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:114 dB, 192 kHz 8-channel D/A Converter
CS4382-KQZ 功能描述:數模轉換器- DAC IC 114dB 24-bit 102kHz 8Ch DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube
CS4382-KQZR 功能描述:數模轉換器- DAC IC 114dB 24-bit 102kHz 8Ch DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube
CS4383 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:114 dB, 192 kHz 8-Channel D/A Converter