參數資料
型號: CS5372-BSZR
廠商: Cirrus Logic Inc
文件頁數: 7/22頁
文件大小: 0K
描述: IC MODULATOR LP/HP 2CH 24-SSOP
標準包裝: 1,000
類型: 調制器
分辨率(位): 24 b
采樣率(每秒): 512k
電壓電源: 模擬和數字,雙 ±
電源電壓: ±2.5V,3.3 V ~ 5 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 24-SSOP(0.209",5.30mm 寬)
供應商設備封裝: 24-SSOP
包裝: 帶卷 (TR)
配用: 598-1778-ND - EVALUATION BOARD FOR CS5376
CS5371 CS5372
DS255F3
15
9.3.
SCR Latch-up Considerations
The VA- pin is tied to the CS5371/72 substrate and
should always be connected to the most negative
supply voltage to ensure SCR latch-up does not
occur. In general, latch-up may occur when any
pin voltage (including the analog inputs) is 0.7V or
more below VA-, or 7.6V or more above VA-.
Analog inputs INR+/- and INF+/- should be voltage
limited to ensure signals don’t exceed the (VA-)-
0.7V or (VA+)+7.6V requirement. Either the inputs
should be clamped to the VA+ and VA- rails using
reversed biased Schottky diodes (BAT85 or simi-
lar), or the current into the analog inputs should be
limited to less than 10mA. By current limiting the
analog inputs, the internal ESD diodes on the ana-
log input pads will clamp the input signal to the
proper level. Input currents greater than 10mA will
overdrive the internal diodes, so external compo-
nents are required.
When using dual analog power supplies, it is rec-
ommended to connect the VA- power supply pin to
system ground (DGND) using a reversed biased
Schottky diode. This configuration clamps the VA-
voltage a maximum of 0.3V above ground to en-
sure SCR latch-up does not occur during power
up. If the VA+ power supply ramps before the VA-
supply, the VA- voltage could be pulled above
ground through the CS5371/72. If the VA- supply
is unintentionally pulled 0.7 V above the DGND
pin, SCR latch-up can occur.
9.4.
DC-DC Converter Considerations
Many measurement systems are battery powered
and utilize DC-DC converters to generate the nec-
essary supply voltages for the system. To mini-
mize the effects of interference, it is desirable to
operate the DC-DC converter at a frequency which
is rejected by the digital filter.
9.5.
Power Supply Rejection
Power supply rejection of the CS5371/72 modula-
tors is frequency dependent. The digital filter re-
jects power supply noise for frequencies above the
filter corner frequency at 130 dB or greater. For
frequencies between DC and the digital filter cor-
ner frequency, power supply rejection is nearly
constant at 90 dB.
相關PDF資料
PDF描述
CS5372A-ISZ IC MODULATOR LP/HP 2CH 24-SSOP
CS5373A-ISZR IC DAC/MODULATOR LP/HP 28-SSOP
CS5376A-IQZ IC FILTER DGTL MULTI-CH 64-TQFP
CS61577-IL1Z IC LINE INTERFACE T1/E1 28PLCC
CS61584A-IQ3Z IC LINE INTERFACE T1/E1 64LQFP
相關代理商/技術參數
參數描述
CS5373A 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:Low-power, High-performance Modulator and Test DAC
CS5373A-IS 功能描述:模數轉換器 - ADC IC Dlt-Sgm Modulator w/Intgrtd Tst DAC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
CS5373A-ISR 功能描述:模數轉換器 - ADC IC Dlt-Sgm Modulator w/Intgrtd Tst DAC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
CS5373A-ISZ 功能描述:數模轉換器- DAC IC Dlt-Sgm Modulatr w/Intgrtd Tst DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube
CS5373A-ISZR 功能描述:模數轉換器 - ADC IC Dlt-Sgm Modulator w/Intgrtd Tst DAC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32