- 您現在的位置：買賣IC網 > PDF目錄1913 > DS1865T+ (Maxim Integrated Products)IC PON TRIPLEXER CTRLR 28TQFN-EP PDF資料下載
參數資料
| 型號： | DS1865T+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 7/67頁 |
| 文件大小： | 0K |
| 描述： | IC PON TRIPLEXER CTRLR 28TQFN-EP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 1 |
| 系列： | * |
| 類型： | * |
| 應用： | * |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-WFQFN 裸露焊盤 |
| 供應商設備封裝： | 28-TQFN-EP（5x5） |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁
DS1865
PON Triplexer Control and
Monitoring Circuit
____________________________________________________________________
15
inadequate VCC exists to operate the laser driver. Once
adequate VCC is present to clear the VCC low alarm, the
outputs are enabled following the same sequence as the
power-up sequence.
As previously mentioned, the FETG is an output used to
disable the laser current through a series nMOSFET or
pMOSFET. This requires that the FETG output can sink
or source current. Because the DS1865 does not know
if it should sink or source current before VCC exceeds
VPOA, which triggers the EE recall, this output will
be high impedance when VCC is below VPOA (see the
Low-Voltage Operation section for details and
diagram). The application circuit must use a pullup or
pulldown resistor on this pin that pulls FETG to the
alarm/shutdown state (high for a pMOS, low for a
nMOS). Once VCC is above VPOA, the DS1865 pulls the
FETG output to the state determined by the FETG DIR
bit (Table 02h, Register 89h). FETG DIR is 0 if an nMOS
is used and 1 if a pMOS is used.
Determining Alarm Causes
Using the I2C Interface
To determine the cause of the TX-F or FETG alarm, the
system processor can read the DS1865’s Alarm Trap
Bytes (ATB) through the I2C interface (in Table 01h). The
ATB has a bit for each alarm. Any time an alarm occurs,
regardless of the mask bit’s state, the DS1865 sets the
corresponding bit in the ATB. Active ATB bits remain set
until written to zeros through the I2C interface. On power-
up, the ATB is zeros until alarms dictate otherwise.
Die Identification
The DS1865 has an ID hard coded to its die. Two regis-
ters (Table 02h bytes 86h–87h) are assigned for this
feature. Byte 86h reads 65h to identify the part as the
DS1865, byte 87h reads the die revision.
Low-Voltage Operation
The DS1865 contains two power-on reset (POR) levels.
The lower level is a digital POR (VPOD) and the higher
level is an analog POR (VPOA). At startup, before the
supply voltage rises above VPOA, the outputs are dis-
abled (FETG and BIAS outputs are high impedance,
MOD is low), all SRAM locations are low (including
shadowed EEPROM), and all analog circuitry is dis-
abled. When VCC reaches VPOA, the SEE is recalled,
and the analog circuitry is enabled. While VCC remains
above VPOA, the device is in its normal operating state,
and it responds based on its nonvolatile configuration.
If during operation VCC falls below VPOA but is still
above VPOD, the SRAM retains the SEE settings from
TX-F LATCHED OPERATION
TX-F NON LATCHED OPERATION
DETECTION OF
TX-F FAULT
TX-D OR
TX-F RESET
TX-F
DETECTION OF
TX-F FAULT
TX-F
Figure 5. TX-F Timing
Table 4. TX-F as a Function of TX-D and
Alarm Sources
VCC > VPOA
TX-D
NONMASKED
TX-F ALARM
TX-F
No
X
1
Yes
0
Yes
0
1
Yes
1
X
0
相關PDF資料 |
PDF描述 |
|---|---|
| DS1866Z/T&R | IC POT TRIM LOG 2.7-5.5V 8-SOIC |
| DS1867S-010+T&R | IC POT W/EEPROM DUAL 10K 16-SOIC |
| DS1868E-010/T&R | IC POT DIGITAL DUAL 10K 20-TSSOP |
| DS1869S-C10+T&R | IC RHEOSTAT DALLAST 8SOIC |
| DS1875T+T&R | IC SFP CTRLR/TRIPLEXER 38-TQFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| DS1865T TR | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:PON Triplexer Control and Monitoring Circuit |
| DS1865T+ | 功能描述:電流和電力監控器、調節器 PON Triplexer Cntrl & Monitoring Circuit RoHS:否 制造商:STMicroelectronics 產品:Current Regulators 電源電壓-最大:48 V 電源電壓-最小:5.5 V 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:HPSO-8 封裝:Reel |
| DS1865T+T&R | 制造商:Maxim Integrated Products 功能描述:TRIPLEXER CONTROL AND MONITORING CIRCUIT 1TX 1RX 1.25GBPS 28 - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC PON CONTROL TRI 28-TQFN 制造商:Maxim Integrated Products 功能描述:Current & Power Monitors & Regulators PON Triplexer Cntrl & Monitoring Circuit |
| DS1865T+T&R | 功能描述:電流和電力監控器、調節器 PON Triplexer Cntrl & Monitoring Circuit RoHS:否 制造商:STMicroelectronics 產品:Current Regulators 電源電壓-最大:48 V 電源電壓-最小:5.5 V 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:HPSO-8 封裝:Reel |
| DS1865T+TR | 制造商:MAXIM 制造商全稱:Maxim Integrated Products 功能描述:PON Triplexer Control and Monitoring Circuit |
發布緊急采購，3分鐘左右您將得到回復。