參數資料
型號: EFM32TG232F32
廠商: Energy Micro
文件頁數: 61/136頁
文件大?。?/td> 0K
描述: IC MCU 32BIT 32KB FLASH 64LQFP
特色產品: EFM32 Tiny Gecko
標準包裝: 1
系列: Tiny Gecko
核心處理器: ARM? Cortex?-M3
芯體尺寸: 32-位
速度: 32MHz
連通性: I²C,IrDA,智能卡,SPI,UART/USART
外圍設備: 欠壓檢測/復位,DMA,I²S,POR,PWM,WDT
輸入/輸出數: 53
程序存儲器容量: 32KB(32K x 8)
程序存儲器類型: 閃存
RAM 容量: 4K x 8
電壓 - 電源 (Vcc/Vdd): 1.8 V ~ 3.8 V
數據轉換器: A/D 8x12b,D/A 1x12b
振蕩器型: 外部
工作溫度: -40°C ~ 85°C
封裝/外殼: 64-TQFP
包裝: 標準包裝
其它名稱: 914-1030-6
...the world's most energy friendly microcontrollers
2011-02-04 - d0002_Rev1.00
30
www.energymicro.com
Table 2.18. Fault status and fault address registers
Handler
Status register
name
Address register
name
Register description
Hard fault
HFSR
-
Memory management
fault
MMFSR
MMFAR
Bus fault
BFSR
BFAR
Usage fault
UFSR
-
2.4.4 Lockup
The processor enters a lockup state if a hard fault occurs when executing the NMI or hard fault handlers.
When the processor is in lockup state it does not execute any instructions. The processor remains in
lockup state until either:
it is reset
an NMI occurs.
Note
If lockup state occurs from the NMI handler a subsequent NMI does not cause the
processor to leave lockup state.
2.5 Power management
The Cortex-M3 processor sleep modes reduce power consumption:
Sleep mode (Energy Mode 1) stops the processor clock
Deep sleep mode (Energy Mode 2/3) stops the high frequency oscillators and HFPERCLK/
HFCORECLK as well as flash memory.
The SLEEPDEEP bit of the SCR selects which sleep mode is used, see Section 4.3.7 (p. 100) . For
more information about the behavior of the sleep modes see the EMU documentation in the reference
manual for the device.
This section describes the mechanisms for entering sleep mode, and the conditions for waking up from
sleep mode.
2.5.1 Entering sleep mode
This section describes the mechanisms software can use to put the processor into sleep mode.
The system can generate spurious wakeup events, for example a debug operation wakes up the
processor. Therefore software must be able to put the processor back into sleep mode after such an
event. A program might have an idle loop to put the processor back to sleep mode.
2.5.1.1 Wait for interrupt
The wait for interrupt instruction, WFI, causes immediate entry to sleep mode. When the processor
executes a WFI instruction it stops executing instructions and enters sleep mode. See Section 3.10.12 (p.
86) for more information.
2.5.1.2 Wait for event
The wait for event instruction, WFE, causes entry to sleep mode conditional on the value of an one-bit
event register. When the processor executes a WFE instruction, it checks this register:
相關PDF資料
PDF描述
P80C32X2FA,512 IC 80C51 MCU 256 ROMLESS 44PLCC
LPC1224FBD64/101,1 MCU 32BIT 32K FLASH 4K 64-LQFP
R5F72165GDFA#V0 MCU 512K FLASH 64K 176-LQFP
R5F72165ADFA#V0 MCU 512K FLASH 64K 176-LQFP
EFM32TG222F32 IC MCU 32BIT 32KB FLASH 48LQFP
相關代理商/技術參數
參數描述
EFM32TG232F32-QFP64 制造商:Energy Micro AS 功能描述:TINY GECKO MCU - Tape and Reel 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 32KB FLASH 64TQFP
EFM32TG232F32-QFP64T 制造商:Energy Micro AS 功能描述:32 BIT ARM MPU, TINY GECKO - Trays
EFM32TG232F32-QFP64-T 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 32KB FLASH 64TQFP
EFM32TG232F32-T 制造商:Energy Micro AS 功能描述:IC MCU 32BIT 32KB FLASH 64TQFP
EFM32TG232F8 功能描述:ARM微控制器 - MCU 8kb flash 2kb RAM RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT