- 您現在的位置：買賣IC網 > PDF目錄17076 > EVAL-AD5424EBZ (Analog Devices Inc)BOARD EVALUATION FOR AD5424 PDF資料下載
參數資料
| 型號： | EVAL-AD5424EBZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 15/29頁 |
| 文件大小： | 0K |
| 描述： | BOARD EVALUATION FOR AD5424 |
| 產品培訓模塊： | DAC Architectures |
| 標準包裝： | 1 |
| DAC 的數量： | 1 |
| 位數： | 8 |
| 采樣率（每秒）： | 20.4M |
| 數據接口： | 并聯 |
| 設置時間： | 30µs |
| DAC 型： | 電流 |
| 工作溫度： | -40°C ~ 125°C |
| 已供物品： | 板，CD |
| 已用 IC / 零件： | AD5424 |
| 相關產品： | AD5424YRUZ-REEL7-ND - IC DAC 8BIT MULTIPLYING 16-TSSOP AD5424YRUZ-REEL-ND - IC DAC 8BIT MULTIPLYING 16-TSSOP AD5424YRUZ-ND - IC DAC 8BIT MULTIPLYING 16-TSSOP AD5424YRU-REEL7-ND - IC DAC 8BIT MULTIPLYING 20-TSSOP AD5424YRU-ND - IC DAC 8BIT MULTIPLYING 16-TSSOP AD5424YCPZ-REEL7-ND - IC DAC 8BIT MULTIPLYING 20-LFCSP AD5424YCPZ-ND - IC DAC 8BIT MULTIPLYING 20-LFCSP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
Data Sheet
AD5424/AD5433/AD5445
Rev. D | Page 21 of 28
ADDING GAIN
In applications where the output voltage is required to be
greater than VIN, gain can be added with an additional external
amplifier or it can be achieved in a single stage. It is important
to consider the effect of the temperature coefficients of the thin
film resistors of the DAC. Simply placing a resistor in series with
the RFB resistor causes mismatches in the temperature coefficients
and results in larger gain temperature coefficient errors. Instead,
the circuit shown in Figure 54 is a recommended method of
increasing the gain of the circuit. R1, R2, and R3 should have
similar temperature coefficients, but they need not match
the temperature coefficients of the DAC. This approach is
recommended in circuits where gains greater than 1 are
required.
03160-
054
8-/10-/12-BIT
DAC
GND
VDD
RFB
VDD
VOUT
VREF
VIN
ADDITIONAL PINS OMITTED FOR CLARITY
C1 PHASE COMPENSATION (1pF TO 2pF) MAY BE
REQUIRED IF A1 IS A HIGH SPEED AMPLIFIER.
NOTES:
1.
2.
C1
R1
IOUT1
IOUT2
R1 =
GAIN =
R2 + R3
R2
R3
R2
R2R3
R2 + R3
Figure 54. Increasing the Gain of the Current Output DAC
DACS USED AS A DIVIDER OR PROGRAMMABLE
GAIN ELEMENT
Current steering DACs are very flexible and lend themselves to
many different applications. If this type of DAC is connected as
the feedback element of an op amp and RFB is used as the input
resistor, as shown in Figure 55, then the output voltage is
inversely proportional to the digital input fraction, D.
For D = 1 – 2–n the output voltage is
VOUT = –VIN/D = –VIN/(1 2–n)
As D is reduced, the output voltage increases. For small values
of D, it is important to ensure that the amplifier does not saturate
and that the required accuracy is met.
For example, in the circuit shown in Figure 55, an 8-bit DAC
driven with the binary code 0x10 (00010000), that is, 16 decimal,
should cause the output voltage to be 16 × VIN. However, if the
DAC has a linearity specification of ±0.5 LSB, then D can in fact
have a weight anywhere in the range 15.5/256 to 16.5/256 so
that the possible output voltage falls in the range 15.5 VIN to
16.5 VIN—an error of 3% even though the DAC itself has a
maximum error of 0.2%.
03160-055
GND
RFB
VDD
VOUT
VREF
VIN
NOTE:
ADDITIONAL PINS OMITTED FOR CLARITY
IOUT1
IOUT2
Figure 55. Current-Steering DAC Used as a Divider or
Programmable Gain Element
DAC leakage current is also a potential error source in divider
circuits. The leakage current must be counterbalanced by an
opposite current supplied from the op amp through the DAC.
Since only a fraction, D, of the current into the VREF terminal is
routed to the IOUT1 terminal, the output voltage has to change
as follows:
Output Error Voltage due to DAC Leakage = (Leakage × R)/D
where R is the DAC resistance at the VREF terminal.
For a DAC leakage current of 10 nA, R = 10 kΩ, and a gain
(that is, 1/D) of 16, the error voltage is 1.6 mV.
相關PDF資料 |
PDF描述 |
|---|---|
| 0210490943 | CABLE JUMPER 1.25MM .030M 25POS |
| VI-B0K-EY | CONVERTER MOD DC/DC 40V 50W |
| VI-B4D-EY | CONVERTER MOD DC/DC 85V 50W |
| VI-B4B-EY | CONVERTER MOD DC/DC 95V 50W |
| VI-B44-EY | CONVERTER MOD DC/DC 48V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EVAL-AD5425EB | 制造商:Analog Devices 功能描述:EVALUATION BOARD I.C. - Bulk |
| EVAL-AD5425EBZ | 功能描述:BOARD EVALUATION FOR AD5425 RoHS:是 類別:編程器，開發系統 >> 評估板 - 數模轉換器 (DAC) 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- DAC 的數量:4 位數:12 采樣率（每秒）:- 數據接口:串行，SPI? 設置時間:3µs DAC 型:電流/電壓 工作溫度:-40°C ~ 85°C 已供物品:板 已用 IC / 零件:MAX5581 |
| EVAL-AD5426EB | 制造商:Analog Devices 功能描述:EVAL BD FOR AD5426, 0BIT HIGH BANDWIDTH MULTIPLYING DACS W/ - Bulk |
| EVAL-AD5428EBZ | 制造商:Analog Devices 功能描述:EVAL BD FOR 8-/10-/12-BIT, PARALLEL INPUT, DUAL-CH, CURRENT - Bulk |
| EVAL-AD5429EB | 制造商:Analog Devices 功能描述:EVALUATION BOARD I.C. - Bulk |
發布緊急采購，3分鐘左右您將得到回復。