2-86
Intel
Integrated RAID Controller GSU31
User
’
s Manual
Rev 1.0
Advanced Installation Steps
2.6.3
Technical Training and Support
If you are registered in the Intel Processor Dealer Program (North America), the Genuine Intel
Dealer Program (Asia-Pacific Region), or the Intel Processor Integrator Program (Europe/Latin
America), you are eligible for technical training and support.
In U.S. and Canada: 1-800-538-3373, ext. 442 (M - F, 5:00
am -
5:00
pm
, PST)
In Europe: contact your distributor or fax your details to European Literature at
+44 (0) 1793 513142.
In Asia: +65-831-1379 (M - F, 8:30 am - 5:30 pm, Singapore local time) or via e-mail:
APAC_gid@ccm.isin.intel.com
2.7
Disclaimers and Warnings
2.7.1
FCC/Emissions Disclaimer
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules, CISPR 22, and EN55022. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio and television reception.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio and television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that which the receiver is
connected.
Consult an experienced radio/TV technician for help.
2.7.2
Warning
The connection of a non-shielded equipment interface cable to this equipment will invalidate the
FCC certification of this device and may cause interference levels that exceed the limits established
by the FCC for this equipment. It is the responsibility of the user to obtain and use a shielded
equipment interface cable with this device. If the equipment has more than one interface connector,
do not leave cables connected to unused interfaces unless otherwise instructed to do so in the user
manual.
Changes or modifications not expressly approved by the manufacturer could void the user
’
s
authority to operate the equipment.