486
13.3.4
Register Settings
Table 13.3 shows a bit map of the registers used by the smart card interface.
Bits indicated as 0 or 1 must be set to the value shown. The setting of other bits is described
below.
Table 13.3
Smart Card Interface Register Settings
Bit
Register
Bit 7
Bit 6
Bit 5
Bit 4
O/
E
Bit 3
Bit 2
Bit 1
Bit 0
SMR
GM
0
1
1
0
CKS1
CKS0
BRR
BRR7
BRR6
BRR5
BRR4
BRR3
BRR2
BRR1
BRR0
SCR
TIE
RIE
TE
RE
0
0
CKE1
*
CKE0
TDR
TDR7
TDR6
TDR5
TDR4
TDR3
TDR2
TDR1
TDR0
SSR
TDRE
RDRF
ORER
ERS
PER
TEND
0
0
RDR
RDR7
RDR6
RDR5
RDR4
RDR3
RDR2
RDR1
RDR0
SCMR
Notes: — : Unused bit.
*
:
—
—
—
—
SDIR
SINV
—
SMIF
The CKE1 bit must be cleared to 0 when the GM bit in SMR is cleared to 0.
SMR Setting:
The GM bit is cleared to 0 in normal smart card interface mode, and set to 1 in
GSM mode. The O/
E
bit is cleared to 0 if the IC card is of the direct convention type, and set to 1
if of the inverse convention type.
Bits CKS1 and CKS0 select the clock source of the on-chip baud rate generator. See section
13.3.5, Clock.
BRR Setting:
BRR is used to set the bit rate. See section 13.3.5, Clock, for the method of
calculating the value to be set.
SCR Setting:
The function of the TIE, RIE, TE, and RE bits is the same as for the normal SCI.
For details, see section 12, Serial Communication Interface.
Bits CKE1 and CKE0 specify the clock output. When the GM bit in SMR is cleared to 0, set these
bits to B'00 if a clock is not to be output, or to B'01 if a clock is to be output. When the GM bit in
SMR is set to 1, clock output is performed. The clock output can also be fixed high or low.