- 您現在的位置：買賣IC網 > PDF目錄1932 > LPC2103FBD48,151 (NXP Semiconductors)IC ARM7 MCU FLASH 32K 48-LQFP PDF資料下載
參數資料
| 型號： | LPC2103FBD48,151 |
| 廠商： | NXP Semiconductors |
| 文件頁數： | 9/37頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ARM7 MCU FLASH 32K 48-LQFP |
| 產品培訓模塊： | Migrating from 8/16-Bit MCUs to 32-Bit ARMs ARM7 Architecture ARM7 Memory |
| 標準包裝： | 250 |
| 系列： | LPC2100 |
| 核心處理器： | ARM7 |
| 芯體尺寸： | 16/32-位 |
| 速度： | 70MHz |
| 連通性： | I²C，Microwire，SPI，SSI，SSP，UART/USART |
| 外圍設備： | POR，PWM，WDT |
| 輸入/輸出數： | 32 |
| 程序存儲器容量： | 32KB（32K x 8） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 8K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 1.65 V ~ 3.6 V |
| 數據轉換器： | A/D 8x10b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 48-LQFP |
| 包裝： | 托盤 |
| 產品目錄頁面： | 704 (CN2011-ZH PDF) |
| 配用： | 568-4310-ND - EVAL BOARD LPC2158 W/LCD 568-4302-ND - BOARD EVAL LPC210X KS2103 JLINK 568-4301-ND - BOARD EVAL LPC210X KS2103 568-4300-ND - BOARD EVAL LPC210X MCB2103 568-4297-ND - BOARD EVAL LPC21XX MCB2100 MCB2103UME-ND - BOARD EVAL MCB2103 + ULINK-ME MCB2103U-ND - BOARD EVAL MCB2103 + ULINK2 622-1013-ND - BOARD FOR LPC2103 48-LQFP 622-1008-ND - BOARD FOR LPC9103 10-HVSON 622-1005-ND - USB IN-CIRCUIT PROG ARM7 LPC2K |
| 其它名稱： | 568-2094 935280966151 LPC2103FBD48-S |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁
LPC2101_02_03_4
NXP B.V. 2009. All rights reserved.
Product data sheet
Rev. 04 — 2 June 2009
17 of 37
NXP Semiconductors
LPC2101/02/03
Single-chip 16-bit/32-bit microcontrollers
Incorrect/Incomplete feed sequence causes reset/interrupt if enabled.
Flag to indicate watchdog reset.
Programmable 32-bit timer with internal pre-scaler.
Selectable time period from (TPCLK × 256 × 4) to (TPCLK × 232 × 4) in multiples of
TPCLK × 4.
6.16 Real-time clock
The Real-Time Clock (RTC) is designed to provide a set of counters to measure time
when normal or idle operating mode is selected. The RTC has been designed to use little
power, making it suitable for battery powered systems where the CPU is not running
continuously (Idle mode).
6.16.1 Features
Measures the passage of time to maintain a calendar and clock.
Ultra-low power design to support battery powered systems.
Provides Seconds, Minutes, Hours, Day of Month, Month, Year, Day of Week, and Day
of Year.
Can use either the RTC dedicated 32 kHz oscillator input or clock derived from the
external crystal/oscillator input at XTAL1. The programmable reference clock divider
allows ne adjustment of the RTC.
Dedicated power supply pin can be connected to a battery or the main 3.3 V.
6.17 System control
6.17.1 Crystal oscillator
The on-chip integrated oscillator operates with external crystal in range of 1 MHz to
25 MHz. The oscillator output frequency is called fosc and the ARM processor clock
frequency is referred to as CCLK for purposes of rate equations, etc. fosc and CCLK are
the same value unless the PLL is running and connected. Refer to Section 6.17.2 “PLL”
and Section 10.1 “XTAL1 input” for additional information.
6.17.2 PLL
The PLL accepts an input clock frequency in the range of 10 MHz to 25 MHz. The input
frequency is multiplied up into the range of 10 MHz to 70 MHz with a Current Controlled
Oscillator (CCO). The multiplier can be an integer value from 1 to 32 (in practice, the
multiplier value cannot be higher than 6 on this family of microcontrollers due to the upper
frequency limit of the CPU). The CCO operates in the range of 156 MHz to 320 MHz, so
there is an additional divider in the loop to keep the CCO within its frequency range while
the PLL is providing the desired output frequency. The output divider may be set to divide
by 2, 4, 8, or 16 to produce the output clock. Since the minimum output divider value is 2,
it is insured that the PLL output has a 50 % duty cycle. The PLL is turned off and
bypassed following a chip reset and may be enabled by software. The program must
congure and activate the PLL, wait for the PLL to lock, and then connect to the PLL as a
clock source. The PLL settling time is 100
s.
相關PDF資料 |
PDF描述 |
|---|---|
| LPC2106FBD48,151 | IC ARM7 MCU FLASH 128K 48-LQFP |
| LPC2292FBD144,551 | IC ARM7 MCU FLASH 256K 144-LQFP |
| LPC3240FET296,551 | IC ARM9 MCU 256K 296-TFBGA |
| LT1025ACN8 | IC THERMO COMPNSATR MICRPWR 8DIP |
| LT1030CS#PBF | IC LINE DRVR LOWPWR QUAD 14-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC2103FBD48CP3255 | 制造商:NXP Semiconductors 功能描述:- Tape and Reel |
| LPC2103FBD48-S | 制造商:NXP Semiconductors 功能描述:IC, 32BIT MCU, ARM7, 75MHZ, LQFP-48; Controller Family/Series:(ARM7); Core Size:32bit; No. of I/O's:32; Supply Voltage Min:1.65V; Supply Voltage Max:1.95V; Digital IC Case Style:LQFP; No. of Pins:48; Program Memory Size:32KB ;RoHS Compliant: Yes |
| LPC2103FBD48-T | 功能描述:ARM微控制器 - MCU 32K FL/8K RAM/8CH 10-B ADC RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC2103FHN48 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single-chip 16-bit/32-bit microcontrollers; 8 kB/16 kB/32 kB flash with ISP/IAP, fast ports and 10-bit ADC |
| LPC2103FHN48,551 | 功能描述:ARM微控制器 - MCU 32K FL/8K RAM 8CH 10-B ADC RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。