參數資料
型號： LTC1407AIMSE
廠商： LINEAR TECHNOLOGY CORP
元件分類： ADC
英文描述： Serial 12-Bit/14-Bit, 3Msps Simultaneous Sampling Simultaneous Sampling
中文描述： 2-CH 14-BIT PROPRIETARY METHOD ADC, SERIAL ACCESS, PDSO10
封裝： PLASTIC, MSOP-10
文件頁數： 11/24頁
文件大?。?/td> 443K
代理商： LTC1407AIMSE
11
LTC1407/LTC1407A
1407f
LinearView is a trademark of Linear Technology Corporation.
APPLICATIOU
DRIVING THE ANALOG INPUT
The differential analog inputs of the LTC1407/LTC1407A
are easy to drive. The inputs may be driven differentially or
as a single-ended input (i.e., the CH0
–
input is grounded).
All four analog inputs of both differential analog input
pairs, CH0
+
with CH0
–
and CH1
+
with CH1
–
, are sampled
at the same instant. Any unwanted signal that is common
to both inputs of each input pair will be reduced by the
common mode rejection of the sample-and-hold circuit.
The inputs draw only one small current spike while charg-
ing the sample-and-hold capacitors at the end of conver-
sion. During conversion, the analog inputs draw only a
small leakage current. If the source impedance of the
driving circuit is low, then the LTC1407/LTC1407A inputs
can be driven directly. As source impedance increases, so
will acquisition time. For minimum acquisition time with
high source impedance, a buffer amplifier must be used.
The main requirement is that the amplifier driving the
analog input(s) must settle after the small current spike
before the next conversion starts (settling time must be
39ns for full throughput rate). Also keep in mind, while
choosing an input amplifier, the amount of noise and
harmonic distortion added by the amplifier.
W
U
U
CHOOSING AN INPUT AMPLIFIER
Choosing an input amplifier is easy if a few requirements
are taken into consideration. First, to limit the magnitude
of the voltage spike seen by the amplifier from charging
the sampling capacitor, choose an amplifier that has a low
output impedance (< 100
) at the closed-loop bandwidth
frequency. For example, if an amplifier is used in a gain of
1 and has a unity-gain bandwidth of 50MHz, then the
output impedance at 50MHz must be less than 100
. The
second requirement is that the closed-loop bandwidth
must be greater than 40MHz to ensure adequate small-
signal settling for full throughput rate. If slower op amps
are used, more time for settling can be provided by
increasing the time between conversions. The best choice
for an op amp to drive the LTC1407/LTC1407A depends
on the application. Generally, applications fall into two
categories: AC applications where dynamic specifications
are most critical and time domain applications where DC
accuracy and settling time are most critical. The following
list is a summary of the op amps that are suitable for
driving the LTC1407/LTC1407A. (More detailed informa-
tion is available in the Linear Technology Databooks and
on the LinearView
TM
CD-ROM.)
LTC1566-1:
Low Noise 2.3MHz Continuous Time Low-
pass Filter.
LT
1630:
Dual 30MHz Rail-to-Rail Voltage FB Amplifier.
2.7V to
±
15V supplies. Very high A
VOL
, 500
μ
V offset and
520ns settling to 0.5LSB for a 4V swing. THD and noise
are –93dB to 40kHz and below 1LSB to 320kHz (A
V
= 1,
2V
P-P
into 1k
, V
S
= 5V), making the part excellent for AC
applications (to 1/3 Nyquist) where rail-to-rail perfor-
mance is desired. Quad version is available as LT1631.
LT1632:
Dual 45MHz Rail-to-Rail Voltage FB Amplifier.
2.7V to
±
15V supplies. Very high A
VOL
, 1.5mV offset and
400ns settling to 0.5LSB for a 4V swing. It is suitable for
applications with a single 5V supply. THD and noise are
–93dB to 40kHz and below 1LSB to 800kHz (A
V
= 1,
2V
P-P
into 1k
, V
S
= 5V), making the part excellent for AC
applications where rail-to-rail performance is desired.
Quad version is available as LT1633.
LT1801:
80MHz GBWP, –75dBc at 500kHz, 2mA/ampli-
fier, 8.5nV/
√
Hz.
LT1806/LT1807:
325MHz GBWP, –80dBc distortion at
5MHz, unity gain stable, rail-to-rail in and out,
10mA/amplifier, 3.5nV/
√
Hz.
LT1810:
180MHz GBWP, –90dBc distortion at 5MHz,
unity gain stable, rail-to-rail in and out, 15mA/amplifier,
16nV/
√
Hz.
相關PDF資料
PDF描述
LTC1407IMSE Serial 12-Bit/14-Bit, 3Msps Simultaneous Sampling Simultaneous Sampling
LTC1409C 12-Bit, 800ksps Sampling A/D Converter with Shutdown
LTC1409IG 12-Bit, 800ksps Sampling A/D Converter with Shutdown
LTC1409CG 12-Bit, 800ksps Sampling A/D Converter with Shutdown
LTC1409CSW 12-Bit, 800ksps Sampling A/D Converter with Shutdown
相關代理商/技術參數
參數描述
LTC1407AIMSE#PBF 功能描述:IC ADC 14BIT 3MSPS 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
LTC1407AIMSE#TR 功能描述:IC ADC 14BIT 3MSPS SAMPLE 10MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極
LTC1407AIMSE#TRPBF 功能描述:IC ADC 14BIT 3MSPS SAMPLE 10MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極
LTC1407AIMSE-1 功能描述:IC ADC 14BIT 3MSPS SAMPLE 10MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極
LTC1407AIMSE-1#PBF 功能描述:IC ADC 14BIT 3MSPS 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*