- 您現在的位置：買賣IC網 > PDF目錄377770 > LTC2439-1 (Linear Technology Corporation) 8-/16-Channel 16-Bit No Latency Delta-Sigma ADC PDF資料下載
參數資料
| 型號： | LTC2439-1 |
| 廠商： | Linear Technology Corporation |
| 元件分類： | ADC |
| 英文描述： | 8-/16-Channel 16-Bit No Latency Delta-Sigma ADC |
| 中文描述： | 8-/16-Channel 16位無延遲增量累加模數轉換器 |
| 文件頁數： | 12/28頁 |
| 文件大?。?/td> | 288K |
| 代理商： | LTC2439-1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
LTC2439-1
12
24391f
(Bit 18) for the next conversion cycle. Table 3 summarizes
the output data format.
In order to remain compatible with some SPI
microcontrollers, more than 19 SCK clock pulses may be
applied. As long as these clock pulses are complete before
the conversion ends, they will not effect the serial data.
However, switching SCK during a conversion may gener-
ate ground currents in the device leading to extra offset
and noise error sources.
As long as the voltage applied to any channel (CH0-CH15,
COM) is maintained within the –0.3V to (V
CC
+ 0.3V)
absolute maximum operating range, a conversion result is
generated for any differential input voltage V
IN
from
–FS = –0.5 V
REF
to +FS = 0.5 V
REF
. For differential input
voltages greater than +FS, the conversion result is clamped
to the value corresponding to the +FS + 1LSB. For differ-
ential input voltages below –FS, the conversion result is
clamped to the value corresponding to –FS – 1LSB.
Simultaneous Frequency Rejection
The LTC2439-1 internal oscillator provides better than
87dB normal mode rejection over the range of 49Hz to
61.2Hz as shown in Figure 4. For simultaneous 50Hz/60Hz
rejection using the internal oscillator, F
O
should be con-
nected to GND.
When a fundamental rejection frequency different from
the range 49Hz to 61.2Hz is required or when the converter
must be sychronized with an outside source, the LTC2439-1
APPLICATIOU
W
U
U
can operate with an external conversion clock. The conveter
automatically detects the presence of an external clock
signal at the F
O
pin and turns off the internal oscillator. The
frequency f
EOSC
of the external signal must be at least
2560Hz to be detected. The external clock signal duty cycle
is not significant as long as the minimum and maximum
specifications for the high and low periods, t
HEO
and t
LEO
,
are observed.
While operating with an external conversion clock of a
frequency f
EOSC
, the LTC2439-1 provides better than 110dB
normal mode rejection in a frequency range f
EOSC
/2560
±
4%. The normal mode rejection as a function of the input
frequency deviation from f
EOSC
/2560 is shown in Figure 5.
Whenever an external clock is not present at the F
O
pin the
converter automatically activates its internal oscillator and
enters the Internal Conversion Clock mode. The LTC2439-1
operation will not be disturbed if the change of conversion
clock source occurs during the sleep state or during the data
output state while the converter uses an external serial clock.
If the change occurs during the conversion state, the result
of the conversion in progress may be outside specifications
but the following conversions will not be affected. If the
change occurs during the data output state and the con-
verter is in the Internal SCK mode, the serial clock duty cycle
may be affected but the serial data stream will remain valid.
Table 4 summarizes the duration of each state and the
achievable output data rate as a function of F
O
.
Figure 4. LTC2439-1 Normal Mode Rejection
When Using an Internal Oscillator
48
DIFFERENTIAL INPUT SIGNAL FREQUENCY (Hz)
50
52
54
56
58
60
62
N
24391 F04a
–80
–90
–100
–100
–120
–130
–140
Figure 5. LTC2439-1 Normal Mode Rejection When
Using an External Oscillator of Frequency f
EOSC
DIFFERENTIAL INPUT SIGNAL FREQUENCY
DEVIATION FROM NOTCH FREQUENCY f
EOSC
/2560(%)
–12
–8
–4
0
4
8
12
N
24361 F04b
–80
–85
–90
–95
–100
–105
–110
–115
–120
–125
–130
–135
–140
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2439-1IGN | 8-/16-Channel 16-Bit No Latency Delta-Sigma ADC |
| LTC2440CGN | 24-Bit High Speed Differential delta-sigma ADC with Selectable Speed/Resolution |
| LTC2440IGN | 24-Bit High Speed Differential delta-sigma ADC with Selectable Speed/Resolution |
| LTC2444 | 24-Bit High Speed 8-/16-Channel ADCs with Selectable Speed/Resolution |
| LTC2444C | 24-Bit High Speed 8-/16-Channel ADCs with Selectable Speed/Resolution |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC2439-1CGN | 功能描述:IC ADC 16BIT 16CH MCRPWR 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2439-1CGN#PBF | 功能描述:IC ADC 16BIT 16CH MCRPWR 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2439-1CGN#TR | 功能描述:IC ADC 16BIT 16CH MCRPWR 28SSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC2439-1CGN#TRPBF | 功能描述:IC ADC 16BIT 16CH MCRPWR 28SSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率（每秒）:45k 數據接口:串行 轉換器數目:2 功率耗散（最大）:315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端，單極 |
| LTC24391IGN | 制造商:Linear Technology 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。