參數資料
型號: M37641M8-XXXFP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 24 MHz, MICROCONTROLLER, PQFP80
封裝: 14 X 20 MM, 0.80 MM PITCH, PLASTIC, QFP-80
文件頁數: 65/136頁
文件大小: 1672K
代理商: M37641M8-XXXFP
34
7641 Group
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
MITSUBISHI MICROCOMPUTERS
UTXD output (P84/UTXD1,
P80/UTXD2/SRDY)
D0
D1
SP
ST
D2
D3
D4
D5
D6
D7
P
SP
Transfer clock
Tranmit enable bit
Transmit buffer
empty flag
Transmit complete flag
D0
D1
D2
D3
D4
D5
D6
D7
ST
P
D0
D1
ST
Data set into UARTx transmit buffer register 1
Data transferring from UARTx transmit
buffer register 1 to Transmit shift register 1
This timing applies to the conditions:
Character length = 8 bits
Parity enabled
1 stop bit
RTS (Request-to-Send) Function
As a receiver, the UART can be configured to generate the Re-
quest-to-Send (RTSx) handshaking signal. This is enabled by
setting the RTS Function Enable Bit (bit 6 of UxCON) to “1”.
When reception is enabled, that is the Receive Enable Bit is “1”,
the RTSx pin goes “L” to inform a transmitter that reception is pos-
sible. The RTSx pin goes “H” at reception starting and does “L” at
receiving of the last bit.
The delay time from the reception of the last stop bit to the asser-
tion of RTSx is selectable using the RTS Assertion Delay Count
Select Bits.
BRGx (x = 1, 2)
count source
D0
URXD (P85/URXD1,
P81/URXD2/SCLK)
ST
SP
D1
D7
RTSx pin (P87/RTS1,
P83/RTS2/STXD)
Receive enable bit
Receive buffer
empty flag
Transfer clock
Transfer clock generated at falling edge
of start bit and receive started
Receive data latched
Data transferring from UARTx receive register
1 to Receive buffer register 1 (Note)
Note: When no RTS assertion delay, the RTSx pin goes “L”.
The RTS assertion delay counts are selected by bits 4 to 7 of UARTx RTS control register.
This timing applies to the conditions:
Character length = 8 bits
Parity enabled
1 stop bit
Fig. 28 UARTx transmit timing (CTS function disbled)
When the Receive Enable Bit is set to “0” or the Receive initializa-
tion bit is set to “1”, the RTSx pin goes “H”. Even when the
Receive Enable Bit is set to “1”, the RTSx pin goes “H” if detecting
an invalid start bit.
Figure 29 shows the UARTx receive timing.
Fig. 29 UARTx transmit timing (RTS function enabled)
相關PDF資料
PDF描述
M37643M8-XXXFP 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80
M37643F8HP 8-BIT, FLASH, 12 MHz, MICROCONTROLLER, PQFP80
M37643M8-XXXHP 8-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP80
M37700M2-XXXFP 16-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP80
M37701M2-001SP 16-BIT, MROM, 8 MHz, MICROCONTROLLER, PDIP64
相關代理商/技術參數
參數描述
M37641M8-XXXHP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
M376420RS 制造商:OKI 功能描述:3764-20 NOTES
M3764-20RS 制造商:OKI 功能描述:3764-20 NOTES 制造商: 功能描述:Dynamic RAM, Page Mode, 64K x 1, 16 Pin, Plastic, DIP 制造商:OK International 功能描述:Dynamic RAM, Page Mode, 64K x 1, 16 Pin, Plastic, DIP
M3-7643A-S 制造商:Harris Corporation 功能描述:
M37643F8E8-XXXFP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER