參數資料
型號: M37754M8C-XXXGP
元件分類: 微控制器/微處理器
英文描述: 16-BIT, MROM, 40 MHz, MICROCONTROLLER, PQFP100
封裝: PLASTIC, QFP-100
文件頁數: 33/115頁
文件大小: 1571K
代理商: M37754M8C-XXXGP
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁當前第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁
23
PRELIMINAR
Y
Notice:
This
is not
a final
specification.
Some
parametric
limits
are
subject
to change.
MITSUBISHI MICROCOMPUTERS
M37754M8C-XXXGP, M37754M8C-XXXHP
M37754S4CGP, M37754S4CHP
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
TIMER
There are eight 16-bit timers. They are divided by type into timer A(5)
and timer B(3).
The timer I/O pins are multiplexed with I/O pins for port P5 and P6.
To use these pins as timer input pins, the data direction register bit
corresponding to the pin must be cleared to “0” to specify input mode.
TIMER A
Figure 17 shows a block diagram of timer A.
Timer A has four modes: timer mode, event counter mode, one-shot
pulse mode, and pulse width modulation mode. The mode is se-
lected with bits 0 and 1 of the timer Ai mode register (i = 0 to 4). Each
of these modes is described below.
(1) Timer mode [00]
Figure 18 shows the bit configuration of the timer Ai mode register
during timer mode. Bits 0 and 1 of the timer Ai mode register must be
“0” in timer mode. Bits 3, 4, and 5 are used to select the gate func-
tion. Bits 4 and 5 must be “0” when not selecting the gate function.
Bit 3 is ignored if bit 4 is “0”.
Bits 6 and 7 are used to select the timer counter source.
The counting of the selected clock starts when the count start bit is
“1” and stops when it is “0”.
Figure 19 shows the bit configuration of the count start bit. The
counter is decremented, an interrupt is caused and the interrupt re-
quest bit in the timer Ai interrupt control register is set when the con-
tents becomes 000016. At the same time, the contents of the reload
register is transferred to the counter and count is continued.
When data is written to timer Ai register with timer Ai halted, the same
data is also written to the reload register and the counter. When data
is written to timer Ai which is busy, the data is written to the reload
register, but not to the counter. The new data is reloaded from the re-
load register to the counter at the next reload time and counting con-
tinues. The contents of the counter can be read at any time.
When the value set in the timer Ai register is n, the timer frequency
dividing ratio is 1/(n+1).
Fig. 17 Block diagram of timer A
Timer
One-shot
Pulse width modulation
Count start bit
(4016)
Down count
Data bus (odd)
Data bus (even)
Reload register(16)
Counter(16)
(Lower 8 bits)
(Higher 8 bits)
Always decremented
except in event count mode
Timer A0 4716 4616
Timer A1 4916 4816
Timer A2 4B16 4A16
Timer A3 4D16 4C16
Timer A4 4F16 4E16
Up/Down
Toggle flip-flop
Up-down bit
(4416)
Polarity
selection
Addresses
External trigger
Event counter
TAiIN
(i = 0–4)
TAiOUT
(i = 0–4)
Timer(gate function)
Clock source selection
Pulse output
Pf2
Pf16
Pf64
Pf512
Note: Perform write and read to/from timer Ai register in the condition of 16-bit data length : data length flag (m) = “0”.
相關PDF資料
PDF描述
M37777E9AGS 16-BIT, UVPROM, 16 MHz, MICROCONTROLLER, CQCC100
M34550M6A-XXXFP 4-BIT, MROM, 1.6 MHz, MICROCONTROLLER, PQFP80
M37776M5AXXXGP 16-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP100
M37775E9AGS 16-BIT, UVPROM, 16 MHz, MICROCONTROLLER, CQCC100
M34238MK-XXXGP 4-BIT, MROM, 4 MHz, MICROCONTROLLER, PDSO20
相關代理商/技術參數
參數描述
M37754M8C-XXXHP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16BIT CMOS MICROCOMPUTER
M37754S4CGP 制造商:MITSUBISHI 制造商全稱:Mitsubishi Electric Semiconductor 功能描述:SINGLE-CHIP 16BIT CMOS MICROCOMPUTER
M37754S4CHP 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M3775PR-H400CL 制造商:Bonitron 功能描述:OVERVOLTAGE BRAKING RESISTOR
M3775RK-0.75A 制造商:Bonitron 功能描述:OVERVOLTAGE BRAKING RESISTOR