參數資料
型號: M38259EFFS
元件分類: 微控制器/微處理器
英文描述: 8-BIT, UVPROM, 4 MHz, MICROCONTROLLER, CQCC100
封裝: CERAMIC, LCC-100
文件頁數: 21/73頁
文件大?。?/td> 1323K
代理商: M38259EFFS
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER
MITSUBISHI MICROCOMPUTERS
3825 Group
25
Timer X
Timer X is a 16-bit timer that can be selected in one of four modes
and can be controlled the timer X write and the real time port by
setting the timer X mode register.
(1) Timer mode
The timer counts f(XIN)/16 (or f(XCIN)/16 in low-speed mode).
(2) Pulse output mode
Each time the timer underflows, a signal output from the CNTR0
pin is inverted. Except for this, the operation in pulse output mode
is the same as in timer mode. When using a timer in this mode,
set the corresponding port P54 direction register to output mode.
(3) Event counter mode
The timer counts signals input through the CNTR0 pin.
Except for this, the operation in event counter mode is the same
as in timer mode. When using a timer in this mode, set the corre-
sponding port P54 direction register to input mode.
(4) Pulse width measurement mode
The count source is f(XIN)/16 (or f(XCIN)/16 in low-speed mode). If
CNTR0 active edge switch bit is “0”, the timer counts while the in-
put signal of CNTR0 pin is at “H”. If it is “1”, the timer counts while
the input signal of CNTR0 pin is at “L”. When using a timer in this
mode, set the corresponding port P54 direction register to input
mode.
qTimer X Write Control
If the timer X write control bit is “0”, when the value is written in the
address of timer X, the value is loaded in the timer X and the latch
at the same time.
If the timer X write control bit is “1”, when the value is written in the
address of timer X, the value is loaded only in the latch. The value
in the latch is loaded in timer X after timer X underflows.
If the value is written in latch only, unexpected value may be set in
the high-order counter when the writing in high-order latch and the
underflow of timer X are performed at the same timing.
qReal Time Port Control
While the real time port function is valid, data for the real time port
are output from ports P52 and P53 each time the timer X
underflows. (However, if the real time port control bit is changed
from “0” to “1” after set of the real time port data, data are output
independent of the timer X operation.) If the data for the real time
port is changed while the real time port function is valid, the
changed data are output at the next underflow of timer X.
Before using this function, set the corresponding port direction
registers to output mode.
sNote on CNTR0 interrupt active edge selection
CNTR0 interrupt active edge depends on the CNTR0 active edge
switch bit.
Fig. 20 Structure of timer X mode register
Timer X mode register
(TXM : address 002716)
Timer X write control bit
0 : Write value in latch and counter
1 : Write value in latch only
Real time port control bit
0 : Real time port function invalid
1 : Real time port function valid
P52 data for real time port
P53 data for real time port
Timer X operating mode bits
b5 b4
00 : Timer mode
01 : Pulse output mode
10 : Event counter mode
11 : Pulse width measurement mode
CNTR0 active edge switch bit
0 : Count at rising edge in event counter mode
Start from “H” output in pulse output mode
Measure “H” pulse width in pulse width measurement
mode
Falling edge active for CNTR0 interrupt
1 : Count at falling edge in event counter mode
Start from “L” output in pulse output mode
Measure “L” pulse width in pulse width measurement
mode
Rising edge active for CNTR0 interrupt
Timer X stop control bit
0 : Count start
1 : Count stop
b7
b0
相關PDF資料
PDF描述
M38254M6DXXXFP 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP100
M38258MCDXXXFP 8-BIT, MROM, 4 MHz, MICROCONTROLLER, PQFP100
M38257M8-XXXFP 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP100
M38254M6-XXXGP 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP100
M38257E8GP 8-BIT, OTPROM, 8 MHz, MICROCONTROLLER, PQFP100
相關代理商/技術參數
參數描述
M3826 功能描述:電纜固定件和配件 LTRSCG 1000 BLACK RoHS:否 制造商:Heyco 類型:Cable Grips, Liquid Tight 材料:Nylon 顏色:Black 安裝方法:Cable 最大光束直徑:11.4 mm 抗拉強度:
M3826 BK001 制造商:Alpha Wire Company 功能描述:CBL 2COND 16AWG BLK 1000'
M3826 BK002 制造商:Alpha Wire Company 功能描述:CBL 2COND 16AWG BLK 500'
M3826 BK005 制造商:Alpha Wire Company 功能描述:CBL 2COND 16AWG BLK 100'
M3826 BK199 制造商:Alpha Wire Company 功能描述:CBL 2COND 16AWG BLK 3000=3000'