- 您現在的位置：買賣IC網 > PDF目錄45048 > M38D24G4HP 8-BIT, FLASH, 6.25 MHz, MICROCONTROLLER, PQFP64 PDF資料下載
參數資料
| 型號： | M38D24G4HP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, FLASH, 6.25 MHz, MICROCONTROLLER, PQFP64 |
| 封裝： | 10X 10 MM, 0.50 MM PITCH, PLASTIC, LQFP-64 |
| 文件頁數： | 80/138頁 |
| 文件大?。?/td> | 2880K |
| 代理商： | M38D24G4HP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁當前第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁
Rev.3.02
Apr 10, 2008
Page 44 of 131
REJ03B0177-0302
38D2 Group
A/D CONVERTER
The 38D2 Group has a 10-bit A/D converter. The A/D converter
performs successive approximation conversion. The 38D2 Group
has the ADKEY function which perform A/D conversion of the
“L” level analog input from the ADKEY pin automatically.
[AD Conversion Register (ADL, ADH)]
One of these registers is a high-order register, and the other is a
low-order register. The high-order 8 bits of a conversion result is
stored in the AD conversion register (high-order) (address
001716), and the low-order 2 bits of the same result are stored in
bit 7 and bit 6 of the AD conversion register (low-order) (address
001616).
During A/D conversion, do not read these registers.
Also, the connection between the resistor ladder and reference
voltage input pin (VREF) can be controlled by the VREF input
switch bit (bit 0 of address 001616). When “1” is written to this
bit, the resistor ladder is always connected to VREF. When “0” is
written to this bit, the resistor ladder is disconnected from VREF
except during the A/D conversion.
[AD Control Register (ADCON)]
This register controls A/D converter. Bits 2 to 0 are analog input
pin selection bits. Bit 3 is an AD conversion completion bit and
“0” during A/D conversion. This bit is set to “1” upon
completion of A/D conversion.
A/D conversion is started by setting “0” in this bit.
Bit 5 is the ADKEY enable bit. The ADKEY function is enabled
by setting “1” to this bit. When this function is valid, the analog
input pin selection bits are ignored. Also, when bit 5 is “1”, do
not set “0” to bit 3 by program.
[Comparison Voltage Generator]
The comparison voltage generator divides the voltage between
AVSS and VREF, and outputs the divided voltages.
[Channel Selector]
The channel selector selects one of the input ports P47/AN7
P40/AN0 and inputs it to the comparator.
[Comparator and Control Circuit]
The comparator and control circuit compare an analog input
voltage with the comparison voltage and store the result in the
AD conversion register. When an A/D conversion is completed,
the control circuit sets the AD conversion completion bit and the
AD conversion interrupt request bit to “1”.
The comparator is constructed linked to a capacitor. The
conversion accuracy may be low because the change is lost if the
conversion speed is not enough.
Accordingly, set f(XIN) to at least 500 kHz during A/D
conversion in the XIN mode.
Also, do not execute the STP and WIT instructions during the
A/D conversion.
In the low-speed mode and on-chip oscillator mode, there is no
limit on the oscillation frequency because the on-chip oscillator
is used as the A/D conversion clock. In the low-speed mode, on-
chip oscillator starts oscillation automatically at the A/D
conversion is executed and stops oscillation automatically at the
A/D conversion is finished even though it is not oscillating.
Fig. 36 Block diagram of A/D converter
(Address 001716)
(Address 001616)
ADKEY
control circuit
A/D control circuit
AVSS
b7
b0
Data bus
C
ha
nn
el
se
le
cto
r
AD conversion register (H)
Resistor ladder
Comparator
A/D interrupt request
AD control register
P40/AN0
P41/AN1
P42/AN2/ADKEY
P43/AN3
P44/AN4
P45/AN5
P46/AN6
P47/AN7
AD conversion register (L)
VREF
1/8
1/2
φ
SOURCE
Note: In frequency/2, frequency/4, or frequency/8 mode, φSOURCE is the XIN input.
In low-speed mode, or on-chip oscillator mode, φSOURCE is the on-chip
oscillator frequency divided by 4.
相關PDF資料 |
PDF描述 |
|---|---|
| M38D29GC-XXXHP | 8-BIT, FLASH, 6.25 MHz, MICROCONTROLLER, PQFP64 |
| M38D24G4-XXXFP | 8-BIT, FLASH, 6.25 MHz, MICROCONTROLLER, PQFP64 |
| M38D29GF-XXXHP | 8-BIT, FLASH, 6.25 MHz, MICROCONTROLLER, PQFP64 |
| M38D29GFFP | 8-BIT, FLASH, 6.25 MHz, MICROCONTROLLER, PQFP64 |
| M38D29GCHP | 8-BIT, FLASH, 6.25 MHz, MICROCONTROLLER, PQFP64 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M38D24G4HP#U0 | 功能描述:IC 740/38D2 MCU QZ-ROM 64LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:740/38000 標準包裝:250 系列:80C 核心處理器:8051 芯體尺寸:8-位 速度:16MHz 連通性:EBI/EMI，I²C，UART/USART 外圍設備:POR，PWM，WDT 輸入/輸出數:40 程序存儲器容量:- 程序存儲器類型:ROMless EEPROM 大小:- RAM 容量:256 x 8 電壓 - 電源 (Vcc/Vdd):4.5 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:68-LCC（J 形引線） 包裝:帶卷 (TR) |
| M38D24G4XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M38D24G4XXXHP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M38D24G5XXXFP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
| M38D24G5XXXHP | 制造商:RENESAS 制造商全稱:Renesas Technology Corp 功能描述:SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER |
發布緊急采購，3分鐘左右您將得到回復。