936
SAM9G45 [DATASHEET]
6438K–ATARM–12-Feb-13
41.4
Functional Description
41.4.1
Basic Definitions
Source peripheral: Device on an AMBA layer from where the DMAC reads data, which is then stored in the channel
FIFO. The source peripheral teams up with a destination peripheral to form a channel.
Destination peripheral: Device to which the DMAC writes the stored data from the FIFO (previously read from the
source peripheral).
Memory: Source or destination that is always “ready” for a DMAC transfer and does not require a handshaking
interface to interact with the DMAC.
Channel: Read/write datapath between a source peripheral on one configured AMBA layer and a destination
peripheral on the same or different AMBA layer that occurs through the channel FIFO. If the source peripheral is
not memory, then a source handshaking interface is assigned to the channel. If the destination peripheral is not
memory, then a destination handshaking interface is assigned to the channel. Source and destination handshaking
interfaces can be assigned dynamically by programming the channel registers.
Master interface: DMAC is a master on the AHB bus reading data from the source and writing it to the destination
over the AHB bus.
Slave interface: The APB interface over which the DMAC is programmed. The slave interface in practice could be
on the same layer as any of the master interfaces or on a separate layer.
Handshaking interface: A set of signal registers that conform to a protocol and handshake between the DMAC and
source or destination peripheral to control the transfer of a single or chunk transfer between them. This interface is
used to request, acknowledge, and control a DMAC transaction. A channel can receive a request through one of
two types of handshaking interface: hardware or software.
Hardware handshaking interface: Uses hardware signals to control the transfer of a single or chunk transfer
between the DMAC and the source or destination peripheral.
Software handshaking interface: Uses software registers to contr5ol the transfer of a single or chunk transfer
between the DMAC and the source or destination peripheral. No special DMAC handshaking signals are needed
on the I/O of the peripheral. This mode is useful for interfacing an existing peripheral to the DMAC without modify-
ing it.
Flow controller: The device (either the DMAC or source/destination peripheral) that determines the length of and
terminates a DMAC buffer transfer. If the length of a buffer is known before enabling the channel, then the DMAC
should be programmed as the flow controller. If the length of a buffer is not known prior to enabling the channel, the
source or destination peripheral needs to terminate a buffer transfer. In this mode, the peripheral is the flow
controller.
the transfer hierarchy for memory.