參數(shù)資料
型號: MQ80C52CXXX-20/883R
廠商: ATMEL CORP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CQFP44
封裝: CERAMIC, QFP-44
文件頁數(shù): 61/101頁
文件大小: 3398K
代理商: MQ80C52CXXX-20/883R
85
8168C-MCU Wireless-02/10
AT86RF212
The sub-register CCA_ED_THRES of register 0x09 (CCA_THRES) defines the receive
power threshold of the “energy above threshold” algorithm. The threshold is calculated
by
V_THRES [dBm] = RSSI_BASE_VAL + 2.07
CCA_ED_THRES .
Any received power above this level is interpreted as a busy channel.
Note that it is not recommended to manually initiate a CCA request when using the
Extended Operating Mode.
6.6.3 Data Interpretation
The current channel status (CCA_STATUS) and the CCA completion status
(CCA_DONE) are accessible through register 0x01 (TRX_STATUS). Note that register
bits CCA_DONE and CCA_STATUS are cleared in response to a CCA_REQUEST.
The completion of a measurement cycle is indicated by CCA_DONE = 1. If the radio
transceiver detects no signal (idle channel) during the CCA evaluation period, the
CCA_STATUS bit is set to 1; otherwise, it is set to 0.
When using the “energy above threshold” algorithm, a received power above V_THRES
level is interpreted as a busy channel.
When using the “carrier sense” algorithm (i.e. CCA_MODE = 0, 2, and 3), the
AT86RF212 reports a busy channel upon detection of a PHY mode specific
IEEE 802.15.4 signal above RSSI_BASE_VAL [dBm] (see Table 6-25). The
AT86RF212 is also capable of detecting signals below this value, but the detection
probability decreases with decreasing signal power. It is almost zero at the radio
transceivers sensitivity level (see parameter 10.7.1 on page 154).
6.6.4 Interrupt Handling
Interrupt IRQ_4 (CCA_ED_DONE) is issued at the end of a manually initiated CCA
measurement.
Note
A CCA request should only be initiated in Basic Operating Mode RX states.
Otherwise, the radio transceiver generates IRQ_4 (CCA_ED_DONE) and sets the
register bit CCA_DONE = 1, without actually performing a CCA measurement.
6.6.5 Measurement Time
The response time of a manually initiated CCA measurement depends on the receiver
state.
In RX_ON state, the CCA measurement is done over 8 symbol periods and the result is
accessible upon the event IRQ_4 (CCA_ED_DONE) or upon CCA_DONE = 1 (register
0x01, TRX_STATUS).
In BUSY_RX state, the CCA measurement duration depends on the CCA mode and the
CCA request relative to the detection of the SHR. The end of the CCA measurement is
indicated by IRQ_4 (CCA_ED_DONE). The variation of a CCA measurement period in
BUSY_RX state is described in Table 6-29.
相關PDF資料
PDF描述
MJ80C31U-36:D MICROCONTROLLER
R80C52XXX-12SHXXX 8-BIT, MROM, 12 MHz, MICROCONTROLLER, CQCC44
MQ80C32-12SBR 8-BIT, 12 MHz, MICROCONTROLLER, CQFP44
IF180C52XXX-36D 8-BIT, MROM, 36 MHz, MICROCONTROLLER, PQFP44
IV80C32XXX-36 8-BIT, 36 MHz, MICROCONTROLLER, PQFP44
相關代理商/技術參數(shù)
參數(shù)描述
MQ82370-20 制造商:Rochester Electronics LLC 功能描述:- Bulk
MQ8238020 制造商:Intel 功能描述:CONTROLLER: OTHER
MQ82380-20 制造商:Rochester Electronics LLC 功能描述:- Bulk
MQ82380-20/R 制造商:Rochester Electronics LLC 功能描述:
MQ82592 制造商:Rochester Electronics LLC 功能描述:- Bulk