- 您現在的位置：買賣IC網 > PDF目錄25623 > MR80C52TXXX-16/883:RD (ATMEL CORP) 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CQCC44 PDF資料下載
參數資料
| 型號： | MR80C52TXXX-16/883:RD |
| 廠商： | ATMEL CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CQCC44 |
| 封裝： | LCC-44 |
| 文件頁數： | 101/109頁 |
| 文件大?。?/td> | 10824K |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁當前第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁
77
ATtiny20 [DATASHEET]
8235E–AVR–03/2013
Most register and bit references in this section are written in general form. A lower case “n” replaces the Timer/Counter
number, and a lower case “x” replaces the Output Compare unit channel. However, when using the register or bit defines
in a program, the precise form must be used, i.e., TCNT1 for accessing Timer/Counter1 counter value and so on.
12.2.1 Registers
The Timer/Counter (TCNT1), Output Compare Registers (OCR1A/B), and Input Capture Register (ICR1) are all 16-bit
registers. Special procedures must be followed when accessing the 16-bit registers. These procedures are described in
section “Accessing 16-bit Registers” on page 93. The Timer/Counter Control Registers (TCCR1A/B) are 8-bit registers
and have no CPU access restrictions. Interrupt requests (abbreviated to Int.Req. in the figure) signals are all visible in the
Timer Interrupt Flag Register (TIFR). All interrupts are individually masked with the Timer Interrupt Mask Register
(TIMSK). TIFR and TIMSK are not shown in the figure.
The Timer/Counter can be clocked internally, via the prescaler, or by an external clock source on the T1 pin. The Clock
Select logic block controls which clock source and edge the Timer/Counter uses to increment (or decrement) its value.
The Timer/Counter is inactive when no clock source is selected. The output from the Clock Select logic is referred to as
the timer clock (clkT1).
The double buffered Output Compare Registers (OCR1A/B) are compared with the Timer/Counter value at all time. The
result of the compare can be used by the Waveform Generator to generate a PWM or variable frequency output on the
Output Compare pin (OC1A/B). See “Output Compare Units” on page 80. The compare match event will also set the
Compare Match Flag (OCF1A/B) which can be used to generate an Output Compare interrupt request.
The Input Capture Register can capture the Timer/Counter value at a given external (edge triggered) event on either the
Input Capture pin (ICP1) or on the Analog Comparator pins (See “Analog Comparator” on page 105). The Input Capture
unit includes a digital filtering unit (Noise Canceler) for reducing the chance of capturing noise spikes.
The TOP value, or maximum Timer/Counter value, can in some modes of operation be defined by either the OCR1A
Register, the ICR1 Register, or by a set of fixed values. When using OCR1A as TOP value in a PWM mode, the OCR1A
Register can not be used for generating a PWM output. However, the TOP value will in this case be double buffered
allowing the TOP value to be changed in run time. If a fixed TOP value is required, the ICR1 Register can be used as an
alternative, freeing the OCR1A to be used as PWM output.
12.2.2 Definitions
The following definitions are used extensively throughout the section:
Table 12-1. Definitions
12.3
Timer/Counter Clock Sources
The Timer/Counter can be clocked by an internal or an external clock source. The clock source is selected by the Clock
Select logic which is controlled by the Clock Select (CS1[2:0]) bits located in the Timer/Counter control Register B
(TCCR1B). For details on clock sources and prescaler, see “Timer/Counter Prescaler” on page 103.
Constant
Description
BOTTOM
The counter reaches BOTTOM when it becomes 0x00
MAX
The counter reaches its MAXimum when it becomes 0xFF (decimal 255)
TOP
The counter reaches TOP when it becomes equal to the highest value in the count sequence. The TOP
value can be assigned to be the fixed value 0xFF (MAX), the value stored in the OCR
1A register, or the
value stored in the ICR1 register. The assignment depends on the mode of operation
相關PDF資料 |
PDF描述 |
|---|---|
| MJ80C32U-25:D | MICROCONTROLLER |
| MQ80C32E-36:RD | 8-BIT, 36 MHz, MICROCONTROLLER, CQFP44 |
| S80C32-40:R | 8-BIT, 40 MHz, MICROCONTROLLER, PQCC44 |
| S80C52EXXX-30:D | 8-BIT, MROM, 30 MHz, MICROCONTROLLER, PQCC44 |
| SC80C52XXX-36/883 | 8-BIT, MROM, 36 MHz, MICROCONTROLLER, CDIP40 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MR80C86 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CMOS 16-Bit Microprocessor |
| MR80C86/B | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Harris Corporation 功能描述:Microprocessor, 16 Bit, 44 Pin, Ceramic, LCC |
| MR80C86-2 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:CMOS 16-Bit Microprocessor |
| MR80C86-2/883 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| MR80C86-2/B | 制造商:Intersil Corporation 功能描述:MPU 80C86 16BIT CMOS 8MHZ 44PLCC - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。