參數資料
型號： MT9074AP
廠商： Mitel Networks Corporation
英文描述： T1/E1/J1 Single Chip Transceiver
中文描述： T1/E1/J1收發單芯片收發器
文件頁數： 20/122頁
文件大?。?/td> 372K
代理商： MT9074AP
MT9074
Advance Information
20
successive read/write operations to the HDLC FIFO
is required.
Table 13 associates the MT9074 control and status
pages with access and page descriptions.
Identification Code
The MT9074 shall be identified by the code
10101111, read from the identification code status
register (page 03H, address 1FH).
ST-BUS Streams
In T1 mode, there is one control and one status ST-
BUS stream that can be used to program / access
channel associated signalling nibbles. CSTo contains
the received channel associated signalling bits, and
for those channels whose Per Time Slot Control word
bit 1 "RPSIG" is set low, CSTi is used to control the
transmit channel associated signalling. The DSTi
and DSTo streams contain the transmit and receive
voice and digital data. Only 24 of the 32 ST-BUS
channels are used for each of DSTi, DSTo, CSTi and
CSTo. In each case individual channel mapping is as
illustrated in Table , “Table 6 - STBUS vs. DS1 to
Channel Relationship(T1),” on page 14.
In E1 mode, the ST-BUS stream can also be used to
access channel associated signalling nibbles. CSTo
contains the received channel associated signalling
bits (e.g., ITU-T R1 and R2 signalling),and for those
channels whose Per Time Slot Control word bit 1
"RPSIG" is set low, CSTi is used to control the
transmit channel associated signalling. The DSTi
and DSTo streams contain the transmit and receive
voice and digital data.
Only 30 of the 32 ST-BUS channels are used for
each of DSTi, DSTo, CSTi and CSTo. In each case
individual channel mapping is as illustrated in Table
10 Time slot to Channel Relationship.
Reset Operation (Initialization)
The MT9074 can be reset using the hardware
RESET pin (see pin description for external reset
circuit requirements) for T1 and (pin 11 in PLCC, pin
84 in MQFP) or the software reset bit RST (page 1H,
address 1AH) for E1/T1. When the device emerges
from its reset state it will begin to function with the
default settings described in Table 14 (T1) and Table
15 (E1), all control registers default to 00H. A reset
operation takes 1 full frame (125 us) to complete.
Table 15 - Reset Status(E1)
Transmit Data All Ones (TxAO
)
Operation
The TxAO (Transmit all ones) pin allows the PRI
interface to transmit an all ones signal from the point
of power-up without writing to any control registers.
During this time the IRQ pin is tristated. After the
interface has been initialized normal operation can
take place by making TxAO high.
Function
Mode
Loopbacks
SLC-96
Zero Coding
Line Codes
Data Link
Signalling
AB/ABCD Bit
Debounce
Interrupts
Error Insertion
HDLC0,1
Counters
Transmit Data
Status
D4
Deactivated
Deactivated
Deactivated
Deactivated
Serial Mode
CAS Registers
Deactivated
masked
Deactivated
Deactivated
Cleared
All Ones
Table 14 - Reset Status(T1)
Function
Mode
Loopbacks
Transmit FAS
Transmit non-FAS
Transmit MFAS (CAS)
Data Link
CRC Interworking
Signalling
ABCD Bit Debounce
Interrupts
RxMF Output
Error Insertion
HDLCs
Counters
Transmit Data
Status
Termination
Deactivated
C
n
0011011
1/S
n
1111111
00001111
Deactivated
Activated
CAS Registers
Deactivated
Masked
Signalling Multiframe
Deactivated
Deactivated
Cleared
All Ones
相關PDF資料
PDF描述
MT9074 T1/E1/J1 Single Chip Transceiver(T1/E1/J1單片收發器)
MT9075B E1 Single Chip Transceiver
MT9075B E1 Single Chip Transceiver(E1單片收發器)
MT9075 E1 Single Chip Transceiver
MT9075A E1 Single Chip Transceiver
相關代理商/技術參數
參數描述
MT9074AP1 制造商:Microsemi Corporation 功能描述:T1/E1/J1 SGLE CHIP XSCR 制造商:Microsemi Corporation 功能描述:FRAMER E1/J1/T1 5V 68PLCC - Rail/Tube 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC TXRX SGL T1/E1 68PLCC 制造商:Microsemi Corporation 功能描述:IC TXRX SGL T1/E1 68PLCC
MT9074APR 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:T1/E1/J1 Single Chip Transceiver
MT9074APR1 制造商:Microsemi Corporation 功能描述:FRAMER E1/J1/T1 5V 68PLCC - Tape and Reel 制造商:Zarlink Semiconductor Inc 功能描述:FRAMER E1/J1/T1 5V 68PLCC - Tape and Reel
MT9075 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:E1 Single Chip Transceiver
MT9075A 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:E1 Single Chip Transceiver
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*