參數資料
型號： MT9074AP
廠商： Mitel Networks Corporation
英文描述： T1/E1/J1 Single Chip Transceiver
中文描述： T1/E1/J1收發單芯片收發器
文件頁數： 27/122頁
文件大?。?/td> 372K
代理商： MT9074AP
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁
Advance Information
MT9074
27
updated by each end of packet (closing flag)
received and therefore should be read when an end
of packet is received so that the next packet does not
overwrite the registers.
Slip Buffers
Slip Buffer in T1 mode
In T1 mode MT9074 contains two sets of slip buffers,
one on the transmit side, and one on the receive
side. Both sides may perform a controlled slip. The
mechanisms that govern the slip function are a
function of backplane timing and the mapping
between the ST-BUS channels and the DS1
channels. The slip mechanisms are different for the
transmit and receive slip buffers. The extracted 1.544
Mhz clock (E1.5o) and the internally generated
transmit 1.544 Mhz clock are distinct. Slips on the
transmit side are independent from slips on the
receive side.
The transmit slip buffer has data written to it from the
near end 2.048 Mb/s stream. The data is clocked out
of the buffer using signals derived from the transmit
1.544 Mhz clock. The transmit 1.544 Mhz clock is
always phase locked to the DSTi 2.048 Mb/s stream.
If the system 4.096 Mhz clock (C4b) is internally
generated (pin BS/LS low), then it is hard locked to
the 1.544 Mhz clock. No phase drift or wander can
exist between the two signals - therefore no slips will
occur. The delay through the transmit elastic buffer is
then fixed, and is a functions of the relative mapping
between the DSTi channels and the DS1 timeslots.
These delays vary with the position of the channel in
the frame. For example, DS1 timeslot 1 sits in the
elastic buffer for approximately 1 usec and DS1
timeslot 24 sits in the elastic buffer for approximately
32 usec.
If the system 4.096 Mhz clock (C4b) is externally
generated (pin BS/LS high), the transmit 1.544 Mhz
clock is phase locked to it, but the PLL is designed to
filter jitter present in the C4b clock. As a result phase
drift will result between the two signals. The delay
through the transmit elastic buffer will vary in
accordance with the input clock drift, as well as being
a function of the relative mapping between the DSTi
channels and the DS1 timeslots. If the read pointers
approach the write pointers (to within approximately
1 usec) or the delay through the transmit buffer
exceeds 218 usecs a controlled slip will occur. The
contents of a single frame of DS1 data will be
skipped or repeated; a maskable interrupt (masked
by setting bit 1 - TxSLPI high in Interrupt Mask Word
Zero - page 1H, address 1bH) will be generated, and
the status bit TSLIP (page 3H, address 17H) of MSB
Transmit Slip Buffer register will toggle. The direction
of the slip is indicated by bit 6 of the same register
Figure 12 - Read and write pointers in the transmit slip buffers
Write
Pointer
221 uS
4 uS
188 uS
62 uS
129 uS
512 Bit
Elastic
Store
92 uS
92 uS
Wander Tolerance
Read Pointer
Read Pointer
Read Pointer
Read Pointer
0 uS
Frame 0
Frame 1
Frame 0
Frame 1
Frame 0
Frame 1
Write Vectors
Read Vectors
Minimum Delay
Read Vectors - Maximum Delay
96 uS
相關PDF資料
PDF描述
MT9074 T1/E1/J1 Single Chip Transceiver(T1/E1/J1單片收發器)
MT9075B E1 Single Chip Transceiver
MT9075B E1 Single Chip Transceiver(E1單片收發器)
MT9075 E1 Single Chip Transceiver
MT9075A E1 Single Chip Transceiver
相關代理商/技術參數
參數描述
MT9074AP1 制造商:Microsemi Corporation 功能描述:T1/E1/J1 SGLE CHIP XSCR 制造商:Microsemi Corporation 功能描述:FRAMER E1/J1/T1 5V 68PLCC - Rail/Tube 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC TXRX SGL T1/E1 68PLCC 制造商:Microsemi Corporation 功能描述:IC TXRX SGL T1/E1 68PLCC
MT9074APR 制造商:ZARLINK 制造商全稱:Zarlink Semiconductor Inc 功能描述:T1/E1/J1 Single Chip Transceiver
MT9074APR1 制造商:Microsemi Corporation 功能描述:FRAMER E1/J1/T1 5V 68PLCC - Tape and Reel 制造商:Zarlink Semiconductor Inc 功能描述:FRAMER E1/J1/T1 5V 68PLCC - Tape and Reel
MT9075 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:E1 Single Chip Transceiver
MT9075A 制造商:MITEL 制造商全稱:Mitel Networks Corporation 功能描述:E1 Single Chip Transceiver
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*