- 您現在的位置：買賣IC網 > PDF目錄11733 > ORSO82G5-3FN680C (Lattice Semiconductor Corporation)IC TRANCEIVERS FPSC 680FPBGA PDF資料下載
參數資料
| 型號： | ORSO82G5-3FN680C |
| 廠商： | Lattice Semiconductor Corporation |
| 文件頁數： | 118/153頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TRANCEIVERS FPSC 680FPBGA |
| 產品變化通告： | Product Discontinuation 01/Aug/2011 |
| 標準包裝： | 24 |
| 系列： | * |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁當前第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁
Lattice Semiconductor
ORCA ORSO42G5 and ORSO82G5 Data Sheet
67
Reference Clock Requirements
There are two pairs of reference clock inputs in the ORSO42G5 and ORSO82G5 devices. Each reference clock is
distributed to all channels in a block. Each channel has a differential buffer to isolate the clock from the other chan-
nels. The input clock is preferably a differential signal; however, the device can operate with a single-ended input.
The input reference clock directly impacts the transmit data eye, so the clock should have low jitter. In particular, jit-
ter components in the DC to 5 MHz range should be minimized. The required electrical characteristics for the refer-
ence clock are given in Table 46.
Synthesized and Recovered Clocks
The SERDES Embedded Core block contains its own dedicated PLLs for transmit and receive clock generation.
The user provides a reference clock of the appropriate frequency, as described in the previous section. The trans-
mitter PLL uses the REFCLK_[A,B] inputs to synthesize the internal high-speed serial bit clocks. The receiver PLLs
extract the clock from the serial input data and retime the data with the recovered clock.
The receive PLL for each channel has two modes of operation - lock to reference and lock to data with retiming.
When no data or invalid data is present on the HDINP_xx and HDINN_xx pins, the receive VCO will not lock to data
and its frequency can drift outside of the nominal ±100 ppm range. Under this condition, the receive PLL will lock to
REFCLK_[A,B] for a xed time interval and then will attempt to lock to receive data. The process of attempting to
lock to data, then locking to clock will repeat until valid input data exists. There is also a control register bit per
channel to force the receive PLL to always lock to the reference clock.
The high-speed transmit and receive serial data links can run at 0.6 to 2.7 Gbps, depending on the frequency of the
reference clock and the state of the control bits from the internal transmit control register. The interface to the seri-
alizer/deserializer block runs at 1/8th the bit rate of the data lane. Additionally, the MUX/DEMUX logic converts the
data rate and bit-width so the FPGA core can run at 1/4th this frequency which gives a range of 18.8 to 84.4 MHz
for the data in and out of the FPGA in SONET mode. In cell mode, there is a clock domain transfer to a 2x clock
domain, which gives a range of 37.5 to 168.8 MHz for the data in and out of the FPGA.
Internal Clock Signals at the FPGA/Core Interface
There are several clock signals dened at the FPGA/Embedded Core interface in addition to the external reference
clock for each SERDES block. All of the ORSO42G5 and ORSO82G5 clock signals are shown in Figure 47 and are
described following the gure.
相關PDF資料 |
PDF描述 |
|---|---|
| PIC32MX675F256L-80I/PT | IC MCU 32BIT 256KB FLASH 100TQFP |
| D38999/26FE26SC | CONN PLUG 26POS STRAIGHT W/SCKT |
| MSP430F4783IPZ | IC MCU 16BIT 48KB FLASH 100LQFP |
| MS27656T17F99S | CONN RCPT 23POS WALL MNT W/SCKT |
| VI-J4B-IW-F3 | CONVERTER MOD DC/DC 95V 100W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ORSO82G5-3FN680C1 | 功能描述:FPGA - 現場可編程門陣列 10368 LUT 372 I/O RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256 |
| ORSO82G5-G2-PAC-EV | 功能描述:可編程邏輯 IC 開發工具 ORCA ORSO82G5-FPSC Eval Brd RoHS:否 制造商:Altera Corporation 產品:Development Kits 類型:FPGA 工具用于評估:5CEFA7F3 接口類型: 工作電源電壓: |
| ORSPI4 | 制造商:LATTICE 制造商全稱:Lattice Semiconductor 功能描述:Dual SPI4 Interface and High-Speed SERDES FPSC |
| ORSPI4-1F1156C | 功能描述:FPGA - 現場可編程門陣列 16192 LUT RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256 |
| ORSPI4-1F1156I | 功能描述:FPGA - 現場可編程門陣列 16192 LUT RoHS:否 制造商:Altera Corporation 系列:Cyclone V E 柵極數量: 邏輯塊數量:943 內嵌式塊RAM - EBR:1956 kbit 輸入/輸出端數量:128 最大工作頻率:800 MHz 工作電源電壓:1.1 V 最大工作溫度:+ 70 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-256 |
發布緊急采購，3分鐘左右您將得到回復。