參數資料
型號： OX16PCI952
廠商： Electronic Theatre Controls, Inc.
英文描述： Integrated High Performance Dual UARTs, Parallel Port and 5.0v PCI interface
中文描述： 集成高性能的雙UART，并行端口和5.0V PCI接口
文件頁數： 40/76頁
文件大?。?/td> 1386K
代理商： OX16PCI952
Level 6:
CTS or RTS changed interrupt (ISR[5:0]=’100000’):
This interrupt is set whenever any of the CTS# or RTS#
pins changes state fromlow to high. It is cleared on an ISR
read of a level 6 interrupt.
7.6.4
Sleep Mode
For a channel to go into sleep mode, all of the following
conditions must be met:
Sleep mode enabled (IER[4]=1 in 650/950 modes, or
IER[5]=1 in 750 mode):
The transmtter is idle, i.e. the transmtter shift register
and FIFO are both empty.
SIN is high.
The receiver is idle.
The receiver FIFO is empty (LSR[0]=0).
7.7
Modem Interface
DataSheet Revision 1.1
Page 40
OX16PCI952
OXFORD SEMICONDUCTOR LTD.
The UART is not in loopback mode (MCR[4]=0).
Changes on modeminput lines have been
acknowledged (i.e. MSR[3:0]=0000).
No interrupts are pending.
A read of IER[4] (or IER[5] if a 1 was written to that bit
instead) shows whether the power-down request was
successful. The UART will retain its programmed state
whilst in power-down mode.
The channel will automatically exit power-down mode when
any of the conditions 1 to 7 becomes false. It may be
woken manually by clearing IER[4] (or IER[5] if the
alternate sleep mode is enabled).
Sleep mode operation is not available in IrDA mode.
7.7.1
MCR[0]: DTR
logic 0
Force DTR#output to inactive (high).
logic 1
Force DTR# output to active (low).
Note that DTR# can be used for automatic outof-band flow
control when enabled using ACR[4:3] (see section 7.11.3).
MCR[1]: RTS
logic 0
Force RTS#output to inactive (high).
logic 1
Force RTS#output to active (low).
Note that RTS# can be used for automatic outof-band flow
control when enabled using EFR[6] (see section 7.9.4).
MCR[2]: OUT1
logic 0
Force OUT1#output low when loopback mode
is disabled.
logic 1
Force OUT1# output high.
MCR[3]: OUT2/External interrupt enable
logic 0
Force OUT2#output low when loopback mode
is disabled. If INT_SEL#is low the external
interrupt is in high-impedance state when
MCR[3] is cleared. If INT_SEL#is high MCR[3]
does not affect the interrupt.
logic 1
Force OUT2#output high. If INT_SEL#is low
the external interrupt is enabled and operating
in normal active (forcing) mode when MCR[3] is
high. If INT_SEL#is high MCR[3] does not
affect the interrupt.
Modem Control Register ‘MCR’
MCR[4]: Loopback mode
logic 0
Normal operating mode.
logic 1
Enable local loop-back mode (diagnostics).
In local loop-back mode, the transmtter output (SOUT) and
the four modemoutputs (DTR# RTS# OUT1#and
OUT2#) are set in-active (high), and the receiver inputs
SIN, CTS#, DSR# DCD# and RI# are all disabled.
Internally the transmtter output is connected to the receiver
input and DTR# RTS# OUT1#and OUT2#are connected
to modemstatus inputs DSR# CTS# RI# and DCD#
respectively.
In this mode, the receiver and transmtter interrupts are
fully operational. The modemcontrol interrupts are also
operational, but the interrupt sources are now the lower
four bits of the ModemControl Register instead of the four
modemstatus inputs. The interrupts are still controlled by
the IER.
MCR[5]: Enable XON-Any in Enhanced mode or enable
out-of-band flow control in non-Enhanced mode
650/950 (enhanced) modes:
logic 0
XON-Any is disabled.
logic 1
XON-Any is enabled.
In enhanced mode (EFR[4]=1), this bit enables the Xon-
Any operation. When Xon-Any is enabled, any received
data will be accepted as a valid XON (see in-band flow
control, section 7.9.3).
相關PDF資料
PDF描述
OX16PCI952-TQFP-A Integrated High Performance Dual UARTs, Parallel Port and 5.0v PCI interface
OX16PCI954 Integrated Quad UART and PCI interface
OX16PCI954-TQC60-A Integrated Quad UART and PCI interface
OX4240 OCXO
OX1040 OCXO
相關代理商/技術參數
參數描述
OX16PCI952_05 制造商:OXFORD 制造商全稱:OXFORD 功能描述:Integrated High Performance Dual UARTs, Parallel Port and 5.0v PCI interface
OX16PCI952-TQAG 制造商:PLX Technology 功能描述: 制造商:Oxford Semiconductor 功能描述:IC PCI BRIDGE DUAL PORT UART SMD
OX16PCI952-TQC60-A 制造商:OXFORD 制造商全稱:OXFORD 功能描述:Integrated High Performance Dual UARTs, Parallel Port and 5.0v PCI interface
OX16PCI952-TQFP-A 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Integrated High Performance Dual UARTs, Parallel Port and 5.0v PCI interface
OX16PCI954 制造商:OXFORD 制造商全稱:OXFORD 功能描述:Integrated Quad UART and PCI interface
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*