SBAS452 – SEPTEMBER 2008 ......................................................................................................................................................................................... www.ti.com
DEC
HEX
B7
B6
B5
B4
B3
B2
B1
B0
66
42
OPEDA3
OPEDA2
OPEDA1
OPEDA0
FLT3
FLT2
FLT1
FLT0
OPEDA[3:0] DAC Operation control
These bits control the DAC operation mode. In operation disable mode, the DAC output is cut off
from DIN with a fade-out sequence, and the internal DAC data is reset. DAC output is forced into
VCOMDA if PSMDA = 1, or DAC output is forced into AGNDDA and goes into a power-down
state if PSMDA = 0. For normal operating mode, a fade-in sequence is applied on the DAC
output in resume process. The serial mode control is effective during operation disable mode. A
wait time greater than tDACDLY2 is required for the status change because of power-save control
turning on/off.
Default value: 0000.
OPEDA
DAC Operation control
xxx0
DAC1/2 normal operation
xxx1
DAC1/2 operation disable with or without power save
xx0x
DAC3/4 normal operation
xx1x
DAC3/4 operation disable with or without power save
x0xx
DAC5/6 normal operation
x1xx
DAC5/6 operation disable with or without power save
0xxx
DAC7/8 normal operation
1xxx
DAC7/8 operation disable with or without power save
FLT[3:0]
DAC Digital filter roll-off control
The FLT[3:0] bits allow users to select the digital filter roll-off that is best suited to their
applications. Sharp and Slow filter roll-off selections are available. The filter responses for these
Default value: 0000.
FLT
DAC Digital filter roll-off control
xxx0
DAC1/2 sharp roll-off
xxx1
DAC1/2 slow roll-off
xx0x
DAC3/4 sharp roll-off
xx1x
DAC3/4 slow roll-off
x0xx
DAC5/6 sharp roll-off
x1xx
DAC5/6 slow roll-off
0xxx
DAC7/8 sharp roll-off
1xxx
DAC7/8 slow roll-off
40
Copyright 2008, Texas Instruments Incorporated