參數資料
型號: PEB3065
廠商: SIEMENS AG
元件分類: Codec
英文描述: Signal Processing Subscriber Line Interface Codec Filter SLICOF
中文描述: 信號處理用戶線路接口編解碼器SLICOF
文件頁數: 78/102頁
文件大?。?/td> 563K
代理商: PEB3065
PEB 3065
PEF 3065
Appendix
Semiconductor Group
78
01.98
Monitor Handshake Procedure
The monitor channel works in 3 states
Idle state
A pair of inactive (set to ‘1’) MR- and MX-bits during two or more
consecutive frames: End of Message (EOM)
MX-bit is activated (set to ‘0’) by the Monitor-transmitter, together
with data-bytes (can be changed) on the Monitor-channel
MR-bit is set to active (set to ‘0’) by the Monitor-receiver, together
with a data-byte remaining in the Monitor-channel.
A start of transmission is initiated by a Monitor-transmitter in sending out an active MX-bit
together with the first byte of data (the address of the receiver) to be transmitted in the
Monitor-channel.
This state remains until the addressed Monitor-Receiver acknowledges the received
data by sending out an active MR-bit, which means that the data-transmission is
repeated each 125
μ
s frame (minimum is one repetition). During this time the
Monitor-transmitter evaluates the MR-bit.
Flow control, means in the form of transmission delay, can only take place when the
transmitters MX and the receivers MR bit are in active state.
Since the receiver is able to receive the monitor data at least twice (in two consecutive
frames), it is able to check for data errors. If two different bytes are received the receiver
will wait for the receipt of two identical successive bytes (last look function)
A collision resolution mechanism (check if another device is trying to send data during
the same time) is implemented in the transmitter. This is done by looking for the inactive
(‘1’) phase of the MX-bit and making a per bit collision check on the transmitted monitor
data (check if transmitted ‘1’s are on DU/DD-line; DU/DD-line are open-drain lines).
Any abort leads to a reset of the SLICOFI command stack, the device is ready to receive
new commands.
To obtain a maximum speed data transfer, the transmitter anticipates the falling edge of
the receivers acknowledgment.
Due to the inherent programming structure, duplex operation is not possible. It is not
allowed
to send any data to the SLICOFI, while transmission is active.
Sending state
Acknowledging
相關PDF資料
PDF描述
PEB3065NV3.2 Signal Processing Subscriber Line Interface Codec Filter SLICOF
PEF3065NV3.2 Signal Processing Subscriber Line Interface Codec Filter SLICOF
PEB3086 ISDN SUBSCRIBER ACCESS CONTROLLER
PEB31665 NMultichannel Subscriber Line Interface Concept MuSLIC
PEB3465 NMultichannel Subscriber Line Interface Concept MuSLIC
相關代理商/技術參數
參數描述
PEB3065NV3.2 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Signal Processing Subscriber Line Interface Codec Filter SLICOF
PEB3065-NV3.2 制造商:Infineon Technologies AG 功能描述:A/MU-LAW, PCM CODEC, 44 Pin Plastic PLCC 制造商:Siemens 功能描述:A/MU-LAW, PCM CODEC, 44 Pin Plastic PLCC
PEB3065NV3.2SLICOFI 制造商:Rochester Electronics LLC 功能描述:- Bulk
PEB3065NV3.2-SLICOFI 制造商:Rochester Electronics LLC 功能描述:- Bulk
PEB3081 制造商:未知廠家 制造商全稱:未知廠家 功能描述:3.3 V S-Bus Interface Circuit eXtended