- 您現在的位置：買賣IC網 > PDF目錄361239 > Q67121C452 IC-SM-8-BIT CPU-12MHZ PDF資料下載
參數資料
| 型號： | Q67121C452 |
| 英文描述： | IC-SM-8-BIT CPU-12MHZ |
| 中文描述： | 集成電路釤8位CPU - 12MHz的 |
| 文件頁數： | 76/121頁 |
| 文件大小： | 1000K |
| 代理商： | Q67121C452 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁當前第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁
Semiconductor Group
6-42
On-Chip Peripheral Components
C501
6.3.6 Details about Modes 2 and 3
Eleven bits are transmitted (through TxD), or received (through RxD): a start bit (0), 8 data bits (LSB
first), a programmable 9th data bit, and a stop bit (1). On transmit, the 9th data bit (TB8) can be
assigned the value of 0 or 1. On receive, the 9th data bit goes into RB8 in SCON. The baud rate is
programmable to either 1/32 or 1/64 the oscillator frequency in mode 2 (When bit SMOD in SFR
PCON (87H) is set, the baud rate is
f
OSC
/32). Mode 3 may have a variable baud rate generated from
either timer 1 or 2 depending on the state of TCLK and RCLK (SFR T2CON).
Figure 6-23
shows a functional diagram of the serial port in modes 2 and 3. The receive portion is
exactly the same as in mode 1. The transmit portion differs from mode 1 only in the 9th bit of the
transmit shift register. The associated timings for transmit/receive are illustrated in
figure 6-24
.
Transmission is initiated by any instruction that uses SBUF as a destination register. The “Write to
SBUF” signal also loads TB8 into the 9th bit position of the transmit shift register and flags the TX
control unit that a transmission is requested. Transmission starts at the next rollover in the divide-
by-16 counter. (Thus, the bit times are synchronized to the divide-by-16 counter, not to the “Write
to SBUF” signal.)
The transmision begins with activation of SEND, which puts the start bit at TxD. One bit time later,
DATA is activated, which enables the output bit of the transmit shift register to TxD. The first shift
pulse occurs one bit time after that. The first shift clocks a 1 (the stop bit) into the 9th bit position of
the shift register. Thereafter, only zeroes are clocked in. Thus, as data bits shift out to the right,
zeroes are clocked in from the left. When TB8 is at the output position of the shift register, then the
stop bit is just to the left of TB8, and all positions to the left of that contain zeroes. This conditon
flags the TX control unit to do one last shift and then deactivate SEND and set TI. This occurs at
the 11th divide-by-16 rollover after “Write to SBUF”.
Reception is initiated by a detected 1-to-0 transition at RxD. For this purpose RxD is sampled at a
rate of 16 times whatever baud rate has been established. When a transition is detected, the divide-
by-16 counter is immediately reset, and 1FFH is written to the input shift register.
At the 7th, 8th and 9th counter states of each bit time, the bit detector samples the value of RxD.
The value accepted is the value that was seen in at least 2 of the 3 samples. If the value accepted
during the first bit time is not 0, the receive circuits are reset and the unit goes back to looking for
another 1-to-0 transition. If the start bit proves valid, it is shifted into the input shift register, and
reception of the rest of the frame will proceed.
As data bit come from the right, 1s shift out to the left. When the start bit arrives at the leftmost
position in the shift register (which in modes 2 and 3 is a 9-bit register), it flags the RX control block
to do one last shift, load SBUF and RB8, and to set RI. The signal to load SBUF and RB8, and to
set RI, will be generated if, and only if, the following conditions are met at the time the final shift
pulse is generated:
1) RI = 0, and
2) Either SM2 = 0 or the received 9th data bit = 1
If either of these conditions is not met, the received frame is irretrievably lost, and RI is not set. If
both conditions are met, the received 9th data bit goes into RB8, and the first 8 data bit goes into
SBUF. One bit time later, whether the above conditions were met or not, the unit goes back to
looking for a 1-to-0 transition at the RxDTxD input.
Note that the value of the received stop bit is irrelevant to SBUF, RB8 or RI.
相關PDF資料 |
PDF描述 |
|---|---|
| Q67126-C2088 | RF inductor, ceramic core, 2% tol, SMT, RoHS |
| Q67127-C2036SAB-C161R1-L16M | IC-SM-16 BIT CPU |
| Q67120-C2200 | 16-Bit Single-Chip Microcontroller Bare Die Delivery |
| Q67120-C1054 | High Speed CMOS Logic Triple 3-Input NOR Gates 14-SOIC -55 to 125 |
| Q67120-C1056 | High Speed CMOS Logic Triple 3-Input NOR Gates 14-SOIC -55 to 125 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| Q67121-C848 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16-Bit CMOS Single-Chip Microcontroller |
| Q67121-C862 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:C16x-Family of High-Performance CMOS 16-Bit Microcontrollers |
| Q67121-C900 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16-Bit CMOS Single-Chip Microcontroller |
| Q67121-C923 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:C16x-Family of High-Performance CMOS 16-Bit Microcontrollers |
| Q67121-C942 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:16-Bit CMOS Single-Chip Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。