Sin" />
參數資料
型號： SC16IS741IPW,118
廠商： NXP Semiconductors
文件頁數： 2/17頁
文件大?。?/td> 0K
描述： IC UART SGL I2C BUS SPI 16TSSOP
標準包裝： 2,500
系列： *
SC16IS741_1
NXP B.V. 2010. All rights reserved.
Product data sheet
Rev. 01 — 29 April 2010
10 of 52
NXP Semiconductors
SC16IS741
Single UART with I2C-bus/SPI interface, 64-byte FIFOs, IrDA SIR
7.4 Hardware reset, Power-On Reset (POR) and software reset
These three reset methods are identical and will reset the internal registers as indicated in
Table 4 summarizes the state of register.
[1]
Registers DLL, DLH, SPR, XON1, XON2, XOFF1, XOFF2 are not reset by the top-level reset signal
RESET, POR or Software Reset, that is, they hold their initialization values during reset.
Table 5 summarizes the state of registers after reset.
Table 4.
Register reset[1]
Register
Reset state
Interrupt Enable Register
all bits cleared
Interrupt Identification Register
bit 0 is set; all other bits cleared
FIFO Control Register
all bits cleared
Line Control Register
reset to 0001 1101 (0x1D)
Modem Control Register
all bits cleared
Line Status Register
bit 5 and bit 6 set; all other bits cleared
Modem Status Register
bits 0:3 cleared; bits 4:7 input signals
Enhanced Feature Register
all bits cleared
Receiver Holding Register
pointer logic cleared
Transmitter Holding Register
pointer logic cleared
Transmission Control Register
all bits cleared.
Trigger Level Register
all bits cleared.
Transmit FIFO level
reset to 0100 0000 (0x40)
Receive FIFO level
all bits cleared
Extra Feature Register
all bits cleared
Table 5.
Output signals after reset
Signal
Reset state
TX
HIGH
RTS
HIGH
IRQ
HIGH by external pull-up
相關PDF資料
PDF描述
500DLBC-ACH OSC PROG LVDS 2.5V 250PPM OE SMD
W3A41C332KAT2A CAP ARRAY 4CH 3300PF 100V 0612
3362U-1-203RLF TRIMMER 20K OHM 0.5W TH
MB2411A2G13-FB SWITCH PUSH SPDT 0.4VA 28V
W3A41C222KAT2A CAP ARRAY 4CH 2200PF 100V 0612
相關代理商/技術參數
參數描述
SC16IS74Q900 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single UART with I2C-bus/SPI interface, 64 bytes of transmit and receive FIFOs
SC16IS750 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Single UART with I2C-bus/SPI interface, 64 bytes of transmit and receive FIFOs, IrDA SIR built-in support
SC16IS750IBS 功能描述:UART 接口集成電路 I2C/SPI-UARTBRIDGE W/IRDA AND GPIO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16IS750IBS,128 功能描述:UART 接口集成電路 I2C/SPI-UARTBRIDGE W/IRDA AND GPIO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16IS750IBS,151 功能描述:UART 接口集成電路 UART I2C/SPI RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*