REV. 5.0.3 2.90V TO 5.5V UART WITH 32-BYTE FIFO 4.3.2 IER versus Receive/Transmit FIFO Polled Mode Operation When FCR bit-0 equals" />
參數資料
型號： ST16C650AIQ48-F
廠商： Exar Corporation
文件頁數： 18/50頁
文件大小： 0K
描述： IC UART FIFO 32B 48TQFP
標準包裝： 250
特點： *
通道數： 1，UART
FIFO's： 32 字節
規程： 打印機，RS232，RS422，RS485
電源電壓： 2.9 V ~ 5.5 V
帶并行端口： 是
帶IrDA 編碼器/解碼器： 是
帶故障啟動位檢測功能： 是
帶調制解調器控制功能： 是
帶CMOS： 是
安裝類型： 表面貼裝
封裝/外殼： 48-TQFP
供應商設備封裝： 48-TQFP（7x7）
包裝： 托盤
ST16C650A
25
REV. 5.0.3
2.90V TO 5.5V UART WITH 32-BYTE FIFO
4.3.2
IER versus Receive/Transmit FIFO Polled Mode Operation
When FCR bit-0 equals a logic 1 for FIFO enable; resetting IER bits 0-3 enables the ST16C650A in the FIFO
polled mode of operation. Since the receiver and transmitter have separate bits in the LSR either or both can
be used in the polled mode by selecting respective transmit or receive control bit(s).
A. LSR bit-0 indicates there is data in RHR or RX FIFO.
B. LSR bit-1 indicates an overrun error has occurred and that data in the FIFO may not be valid.
C. LSR bits 2-4 provides the type of receive data errors encountered for the data byte in RHR, if any.
D. LSR bit-5 indicates THR is empty.
E. LSR bit-6 indicates when both the transmit FIFO and TSR are empty.
F. LSR bit-7 indicates a data error in at least one character in the RX FIFO.
IER[0]: RHR Interrupt Enable
The receive data ready interrupt will be issued when RHR has a data character in the non-FIFO mode or when
the receive FIFO has reached the programmed trigger level in the FIFO mode.
Logic 0 = Disable the receive data ready interrupt (default).
Logic 1 = Enable the receiver data ready interrupt.
IER[1]: THR Interrupt Enable
This bit enables the Transmit Ready interrupt which is issued whenever the THR becomes empty in the non-
FIFO mode or when data in the FIFO falls below the programmed trigger level in the FIFO mode. If the THR is
empty when this bit is enabled, an interrupt will be generated.
Logic 0 = Disable Transmit Holding Register empty interrupt (default).
Logic 1 = Enable Transmit Holding Register empty interrupt.
IER[2]: Receive Line Status Interrupt Enable
Any change of state of the LSR register bits 1, 2, 3 or 4 will generate an interrupt to inform the host controller
about the error status of the current data byte in FIFO. LSR bit-1 generates an interrupt immediately when the
character has been received. LSR bits 2-4 generate an interrupt either when the character with errors is next
to be read out of the FIFO (XFR[3] = 0) or when the received chracter is received (XFR[3] = 1).
Logic 0 = Disable the receiver line status interrupt (default).
Logic 1 = Enable the receiver line status interrupt.
IER[3]: Modem Status Interrupt Enable
Logic 0 = Disable the modem status register interrupt (default).
Logic 1 = Enable the modem status register interrupt.
IER[4]: Sleep Mode Enable (requires EFR bit-4 = 1)
Logic 0 = Disable Sleep Mode (default).
IER[5]: Xoff Interrupt Enable (requires EFR bit-4=1)
Logic 0 = Disable the software flow control, receive Xoff interrupt (default).
Logic 1 = Enable the software flow control, receive Xoff interrupt. SEE”AUTO XON/XOFF (SOFTWARE)
IER[6]: RTS# Output Interrupt Enable (requires EFR bit-4=1)
Logic 0 = Disable the RTS# interrupt (default).
Logic 1 = Enable the RTS# interrupt. The UART issues an interrupt when the RTS# pin makes a transition
from LOW to HIGH.
相關PDF資料
PDF描述
XR16L2450IM-F IC UART FIFO 1B DUAL 48TQFP
XR68C192CJTR-F IC UART FIFI DUAL 44PLCC
ST16C2450IJ44-F IC UART FIFO DUAL 44PLCC
ST16C452CJ68-F IC UART W/PAR PORT DUAL 68PLCC
XR16L2750CJ-F IC UART FIFO 64B DUAL 44PLCC
相關代理商/技術參數
參數描述
ST16C650AIQ48TR 制造商:Rochester Electronics LLC 功能描述: 制造商:Exar Corporation 功能描述:
ST16C650AIQ48TR-F 功能描述:UART 接口集成電路 UART W/32BYTEFIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
ST16C650CJ44 制造商:Rochester Electronics LLC 功能描述: 制造商:Exar Corporation 功能描述:
ST16C650CJ44-F 功能描述:UART 接口集成電路 UART W/32 BYTE FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
ST16C650CP40 功能描述:UART 接口集成電路 UART W/32 BYTE FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*